PPM1?

161 About industrial piping HOW ARE SIZING CALCULATIONS MADE FOR THE DEFINITION OF SPRING SUPPORTS?

151 About industrial pipping: HOW SHOULD ECONOMIC SPEEDS BE USED?

In a well constructed paragraph define the material requirements for a single-use (disposable) water bottle.

Differentiate between Constant Load and Cross-Sectional Area?

Can you provide an explanation of the problems that may occur with SLA printed parts and offer suggestions on how to prevent them? b)

Materials that are not classified as nanomaterials have_______reactivity because their surface are _______as compared to nanomaterial counterpart A. Lower;smaller B. Higher; larger C. Higher ;smaller D. Lower ;larger

4. For the composite product shown (carbon fiber-epoxy duct flange), describe the plan to produce the final product from a complete product design (supplied by the customer's engineering department). You are responsible for all aspects of production; nothing is supplied other than the design. Explain/list all material, equipment, tooling & personnel requirements to be able to deliver a product of acceptable quality at a rate of 20 units per week. A contract has been signed for 2 years. For the sake of this part, assume there are no certifications required. Overall part size is 6.00" x 8.00" x 1.25" deep. Thickness is approx. 0.085" as produced by 8 plies of twill fabric. The surface shown is the visible side and requires a tooled surface. You choose the process.

How’s ASTM D2041 related to ASTM D2726 ??

What are advantages and limitations of MPI and FPI?