polar coordinates are used mostly for drawing

Q: 3 V 3Ω www + 6Ω3 2 A ww ww

A: Node method is to examine the current flow at different nodes Superposition tells that  The response...

Q: 1. Find iot). 10 2 ww 20 sin (10r–) V 1H E 4 cos (10r–4) A 0.02 F elll

A:

Q: 4(t) = A1 - cos (1000t +5) + Az · cos • cos (2000t – Assume the system is in steady state. Find the ...

A:

Q: What is the transistor bias circuit arrangement that provides, but requires voltage, Q good stabilit...

A: To further stabilise the collector current, this sort of transistor biassing setup, also known as se...

Q: Three phase alternators are invariably connected in star so as to  a. Reduce the size of stator cond...

A:

Q: 3 V + ww 6Q 6ΩΞ 3ΩΕ 2 A ww- www

A: The solution is given below 

Q: R1 V1 Vo D1 Si V2

A:

Q: robler If admittance Y = 0.06 -j0.08 mho, then conductance G equals, A. -0.06 B. 0.06 C. 0.08 D. -0....

A: In this question,  We need to choose the correct options If Admittance Y= 0.06-j0.08 mho then what i...

Q: W17.4 We are given a periodic function f with period 2a and such that f(x) = -f(-x+n) for all r. (a)...

A: We are given a periodic function f with period 2π and such that f(x)=-f(-x+π) for all x. a) We need ...

Q: A 240-Vrms, 60 Hz source skpplies two loads as shown above. Find the capacitance of a capacitor conn...

A:

Q: A singer voice is sampled for 4 second by an 8-bit ADC at a sampling frequency of 10 kHz. The sample...

A: Given that n=8bit fs=10kHz t=4sec

Q: resistors. Use Rf = 1 MQ in all cases a) V1 = 1V, V2 = 2V, V3 = 3V, R1 = 500 kN, R2 = 1MN, R3 = 1 MN...

A: Given that a. Rf=1MΩV1=1v,V2=2v, V3=3vR1=500kΩ, R2=1MΩ, R3=1MΩb   V1=-2v,V2=3v, V3=1vR1=200kΩ, R2=50...

Q: R3 R R1 R2 A R R R4 Ra Vo Vi R D B- +

A:

Q: The analog signal x(t)=2sin 480nt + 3sin 720 nt. Calculate: i. Minimum sarnpling rate to avoid alias...

A: It is given that: X(t)=2sin480πt + 3sin720πt fs1=200 MHz fs2=75 Hz

Q: A 4-bit pulse code modulation (PCM) modulator is used with a 0-2 V signal. How many quantization lev...

A: Given, In Pulse Code Modulation Number of bits n=4 Signal range 0 - 2 V.    

Q: Vc R Ao R R.

A:

Q: 4. The voltage difference between the two terminals of the series equivalent resistance? 5. The powe...

A: We are authorized to answer only three subparts at a time since you have not mentioned which questio...

Q: Q3. A discrete time LTI system described by y[n] + 0.5y[n – 2] – 0.3y[n – 3] = x[n] – 2x[n – 2]. Det...

A: Givenyn+0.5yn-2-0.3yn-3=xn-2xn-2

Q: 2. Solve for loop currents only. 2 Ohm 1 Ohm 1 Ohm 4 V 4 V 3 Ohm 2 Ohm 3 Ohm 2 Ohm 1 Ohm

A: Given circuit:

Q: Q-4) Find the number of poles in the left half-plane, the right half-plane, and on the jw-axis for t...

A: Transfer function- It is define as the mathematical terms which shows the relation between the outpu...

Q: dy d d'x d²x d² :+y=本 +5+ +&x + &r dt

A:

Q: A hot wire anemometer was calibrated in an air jet at ambient temperature TO = 20.6 °C and a wire te...

A:

Q: A two ends of an electromotive force source were connected with a resistance its value is (5 2) and ...

A: In this question,  Resistance R = 5 ohm is connected to electro motive force source with ammeter. Em...

Q: A signal waveform has a frequency of 8 MHz, and the width of the positive pulse is 0.08 us. What is ...

A:

Q: Find the centripetal acceleration of a person standing on the Earth equator. Consider the radius of ...

A: Given Radius of earth =6400000=6.4×106 m

Q: 6. A coil having a resistance of 10 Q and an inductance of 0.2 H is connected in series with a capac...

A: In  this question A coil is connected with series of capacitor C.  Find the value of current I,  vol...

Q: Y-connected, solid grounded and is operated at rated voltage at no-load and is disconnected from the...

A:

Q: Evaluate the following: a) 2 / (1+j) ^4 b) j [ (1+j3) / (1-j2) ] ^2

A: a)  Given  Z1=21+j4

Q: In order for a méasüring instrufffent to relationship with the circuit output resistance Rs: Rin >> ...

A: When the output of the some  circuit has  to be connected to some measuring instrument , impedance m...

Q: 3- In a High Pass Filter, the filter response curve has a slop of 6dB/ octave with a cut of frequenc...

A:

Q: - Find the Fourier Transform of the following signals x(t)-e "u(1) a>0. x(t) = 8(1).

A: The given signal is,  x(t)=eatu(t)    a>0 The Fourier transform of the above signal is,  Xω=∫-∞∞x...

Q: 1. Determine the current flowing through an element if the charge flow is given by: (а) q(t) —D (3) ...

A: Note: We are authorized to answer one question at a time, since you have not mentioned which questio...

Q: piece of crystalline silicon is doped uniformly with phosphorus atoms. The doping density is 1x 1015...

A:

Q: Discussion Question 1: A rectangular block of iron is 2cm x 2cm x 30cm. How would you connect this b...

A: A rectangular block of iron which has the dimensions of 2 cm× 2 cm × 30 cm. So now if we connect it ...

Q: Let x(t) is an input to a continuous time linear time system S and y(t) is the output. The input-out...

A:

Q: The screw eye is subjected to two forces, F, and F2. Determine the magnitude and direction of the re...

A:

Q: Give at least 3 applications of Fourier Series.

A: Fourier series: A periodic function (potentially infinite) can be represented as a sum of cosine &am...

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a cap...

A:

Q: L1 3 1 17H L2 L4 L5 12H 24H 12H L3 4 4H

A:

Q: Let:  z1 = 1 – j3  ;  z2 = -2 + j5  ;  z3 = -3 – j4   Determine & create Argand diagram: z1 z2 / z...

A: Please note that the argannd diagram  Here not for scale Argand diagram has real and imaginary axes ...

Q: 5. Calculate the output voltage of a non-inverting amplifier for values of V, = 5v, Rf = 370kn, and ...

A:

Q: R = 2 Q, C = 1/5 F e L = 5 H, v.(0) = 4V e iį(0) = –1A (1)a R L v(0)

A:

Q: A simple one-pole system has transfer function H(s) = What is the magnitude of the frequency respons...

A: Given, A simple one pole system with transfer function Hs=11+τs  

Q: (a) Calculate V in the following circuit using the equivalent circuit technique. (b) Calculate the p...

A: Given,

Q: D1 R1 Si R2 D2 Ge R3

A: Given  All the required values, we have to find current through diode 2. The answer for the above qu...

Q: Consider an FM signal s(t)=10 cos(2n 106 t+8 sin 4m 103 t).Determine a. modulation index b. frequenc...

A: Given: An FM signal having equation st=10cos2π×106t+8sin4π×103t  

Q: Find a Simplified formula for q(t)=h(t-10)

A: Given equation  q(t)=h(t-10)

Q: 52 10 2 V1 A 20 v(+ 10 2 4 A VTh

A:

Q: の 2 A Xー ス=0 10Ω v(1) 2 H

A:

Q: A 4-bit pulse code modulation (PCM) modulator is used with a 0-2 V signal. How many quantization lev...

A: Given data, A pulse code modulation Number of bits n=4 0 - 2 V signal