points on a smooth curve drawn to best represent the stage- discharge data of a stream have the following coordinate. Find constant (a) in rating curve equation Q=k(g- a)b Stage is 315.56, 316.44, 318.73 and Discharge is 50, 250, 1250, respectively *

points on a smooth curve drawn to best represent the stage- discharge data of a stream have the following coordinate. Find constant (a) in rating curve equation Q=k(g- a)b Stage is 315.56, 316.44, 318.73 and Discharge is 50, 250, 1250, respectively *

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A hydraulic jump is shown in figure below. The depth of flow z₂ after the hydraulic jump is 5 m…

A: Depth, Z1 = 6 mDepth after the hydraulic jump, Z = 5 mLength, l = 0.4 mFlow rate, Q = 450…

Q: The slider block has the motion shown. Suppose that r= 130 mm and h = 450 mm. (Figure 1) Figure tamn…

Q: Derive the deflection at different points of the beam, the maximum deflection, and slopes of the…

Q: tica

A: Given:- h=1.50m R=0.75m To find:- stable or unstable

Q: Q1/ The ordinate of 2-hrs unit hydrograph of a basin are given in the table below. Compute a 4-hrs…

A: S-curve Method-It is used to derive a unit hydograph for a desired duration…

Q: Consider the EGL and HGL of the 200-m pipeline shown in the figure. The fluid is water and all pipes…

Q: Determine the following: *Volume using end area method * Volume using prismoidal formula *what is…

A: h=2m To find Volume using end area method Volume using prismoidal formula difference of capacity…

Q: Suppose that the graph of Qa versus Ho1/2 has a non-zero intercept at Ho = 0. How would you account…

A: Orifice coefficients are crucial in various engineering applications, including fluid flow…

Q: 1. A single loop consists of the following pipes with Darcy's f= 0.0205: 40 L/s В Pipe Length, m…

Q: 5. What is the equation of the curve AB? Depth Specific Energy Q? a) y + 2gy b) у + 2gy Q² с) у +…

Q: y -om -| - 750 N/m? 1217 N/m² 아 -12m - 7.5 m→- -12 m -

A: Draw FBD:

Q: ater flows through an open channel that has a cross-sec own in the figure. Flow is uniform and the…

Q: The hydrograph tabulated below was observed for a river draining a 40 square miles catchment,…

A: Given data:

Q: How would we derive a solution for groundwater drawdown due to pumping near a river (i.e. a recharge…

A: Brief concept introduction- Groundwater- It is the water that is stored under the earth's crust.…

Q: For a flow of 1500 liters of water per second through a circular channel of 2 m diameter flowing…

A: Given, Diameter of channel = 2m (flowing half full) Manning's constant (n) = 0.013 Q= 1500…

Q: 20 15 165 10 250 np curve in the form of quadratic equation. s installed in a pipeline to augment…

A: we will plot the pump characterstic curve from given databy the curve if Q =170L/shead developed =…

Q: Water demand of a city is supplied from four identical (same) wells tapped into aquifer as seen in…

A: Given- Radius of well r=1 m, Distance between wells H =1 km =1000 m, Mean discharge Q=200…

Q: Example 15.5 In a flow through a rectangular channel for a certain discharge the Froude 2+Fr 2/3…

Q: Water flows along the drainage canal having the properties as shown below. S, = 1 ft/500 ft.…

Q: FIGURE Q2 The diameters of the nozzle and the pipe are given by dn = 25 mm and d, = 50 mm,…

A: To determine flow rate through the nozzle and the pressure at points A and B. Given, Diameter of…

Q: Given the inflow and outflow discharges: Time (h) Inflow (m³/s) Outflow (m³/s) 1 93 85 3 208 114 5…

A: Inflow x Outflow y xy x2 y2 93 85 7905 8649 7225 208 114 23712 43264 12996 442 233 102986…

Q: The section of a storm drain tunnel is as shown in the figure. During a heavy storm the water…

Q: Your assigned problem: If the water surface elevation in reservoir B is 110m, what must be the water…

Q: What is the flow of water

Q: Water flows at 150 ft³/s down a rectangular channel made of finished concrete. The channel has a…

A: Water flow=150ft3/sec Channel width=10ft Downward slope = 0.0002 manning's constant n=0.0012 Water…

Q: F (60cm) 20 km A(46cm) D(80cm) E (70cm) 20 km B(65cm) C(76cm)

A: First the weighted area is used to calculate the precipitation from theissen polygon method and…

Q: iven a portion of a water supply pipe network system below. Determine the actual ow in each pipe and…

A: First, draw the loop diagram separate them like loops 1 and 2: derive the table formulas and Do the…

Q: t: A certain lined irrigation channel with a cross section shown in figure I in the next page. It is…

A: Discharge= 30 m3 /s Velocity= 1 m/s

Q: 14. For a wide rectangular channel y>>B. a) True b) False

A: Since , AREA(A) = B.y & Perimeter( P) = B+2y Where B>>y

Q: For a vector, F = 193.67 kN at an angle of 26.07 degrees made with the horizontal in Q2. Find the…

Q: Problem 1: Current meter readings and the axes of measurements are given in Figure 1 for a certain…

A: a = 0.05 b = 0.80 V = a+bN

Q: Example 15.5 In a flow through a rectangular channel for a certain discharge Fr₂ 2/3 Jution: Show…

Q: A stream function is given by y = 3x² - y3, What is the magnitude of velocity components at the…

Q: Q1: Complete the field notes shown in table by computing and recording the elevation for each point.…

A: Field notes is completed Using H.I method.

Q: The area bounded by the water line of a reservoir and the contours with a contour interval of 2 m.…

A: Given data- Contour Interval d= 2 mArea bounded by the water line-A1=10250 m2A2=8350 m2A3=7750…

Q: Situation 16 - The flow of water from Reservoir A shown is 600 L/s. Properties of the system are as…

Q: Example 15.5 In a flow through a rectangular channel for a certain discharge the Froude 2/3 numbers…

Q: . The velocity along a stream line passing through the origin is given by: V = 2yx² + %3D What is…

A: Given data : Coordinate =(4,3)X=4Y=3

Q: NUMBER OF POSITIVE TUBES SAMPLE DILUTION Sample A Sample B Sample C Sample D 5 10.00 1.00 4 0.10 5…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

1- Three points on a smooth curve
drawn to best represent the stage-
discharge data of a stream have the
following coordinate. Find constant
(a) in rating curve equation Q=k(g-
a)b Stage is 315.56, 316.44, 318.73 and
Discharge is 5O, 250, 1250,
respectively. *
O 315.5
O 315.01
O 315.3
O 315.20

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

QUESTION 02 2.1 A pipeline connects two reservoirs such that the total head between them, when water is being pumped from one to the other can be expressed as H= 25 + (77,46Q)² where H is the total head (m) and Q is the discharge in m³/sec. The characteristic curve of the particular pump that can be used, is tabulated as follows: Head (m) 75 65 55 45 33 25 Discharge (m³/sec) 0,02 0,03 0,04 0,05 0,055 0. 70 08 70 30 (%) LI Evaluate graphically the discharge, head and efficiency if: is used 2.1.1 One pump 2.1.2 Two pumps are used in series. 2.1.3 Two pumps are used in parallel.
Answer in image not allowed
The discharge in a rectangular channel is given as Q = V*W*H, where V is the measured velocity, W is the channel width, and H is the depth of water. The table below gives the average of many measurements of each of the terms and the associated standard uncertainty. What is the discharge in this channel and its uncertainty?
Qsn. Plot the flow curve of liquid limit according to the data given in the table.
3.5 An idealized velocity distribution is given by X y W = 0 1+2t u= 3 V = 1+t Calculate and plot (a) the streamline; and (b) the pathline which pass through the point (xo, Yo, 0) at time t=0.
3. A stream function is given by 4 = 2x²y + (x + 1)y² The flow rate across a line joining points A(3, 0) and B(0,2) is
Using the following figure that shows location of three wells, how would you determinen the groundwater flow direction?
Example 15.5 In a flow through a rectangular channel for a certain discharge the Froude 2/3 numbers corresponding to the two alternate depths are Fr, and Fr,. Show that Solution : Fr₂ Fr₁ 2+ Fr 2+Fr
4. What is the ground water travel time from well MW1 to well MW2 (days) according to the following figure's condition? (Hint: Solve by Darcy's Law) - TOC stands for Top of Casing, and is an elevation with respect to a common datum DTW stands for Depth to water, which is the distance from the TOC to the water table MW1 MWI MW2 L = K= 900 ft TOC (ft) 18 ft/day 0.24 1052.6 1045.3 DTW (ft) 12.5 14.2 MW2
This is for water resources Engineering. Please show steps and formulas so I can understand.
Develop the expression to determine: the elevation of the oil-water surface (Yi) and the pressure gradient for a water phase and an oil phase that is moving between two parallel plates showed on the figure. The flow rates at the inlet are 0.1 ft3/sec (same for both fluids) and the viscosities are 100 and 0.89 cps for oil and water respectively. 01 Water 12" 0il 2 Water 1 Fig. 1 Laminar Flow of Water and oil between interface Two Parallel Plates. Fig. 2 Two Dimensional Flow of oil and Water.
A B Figure 2 Figure 2 depicts a stormwater drainage pipeline that flows from left to right as shown by the arrows. The said pipeline constricts at Point B before being bifurcated into two separate channels as shown. Given the following: • Diameter of pipeline AB at Point A = 0.6 m • Diameter of pipeline AB at Point B = 0.45 m Diameter of channel BC = 0.35 m • Diameter of channel BD = 0.28 m You are to assume a steady flow throughout the system and that both channels BC & BD have circular cross-sections of constant size throughout. Then: i) Calculate the discharge at Point A if the velocity at A is given to be 3 m/s. ii) Find the velocity of flow at Point B. iii) If velocity at Point C is provided as 6 m/s, what is the velocity at Point D? iv) Evaluate the following statement: “Due to its smaller size, the volume flow rate at Point B is lower than the volume flow rate at Point A. ". Is this statement true or false? Give a brief explanation for your answer. v) Determine the acceleration…