What type of FET that the two channels are enhanced after applying proper voltage at the gate

Q: 2K 5V D1 etermine the voltage at the resistor R2. (assume LED forward voltage is 2.0 volts) m D3 R1

A:

Q: What is the value of this resistance in ohms of a 4-band resistor with color combinations of…

A:

Q: A cell has a terminal voltage that changes from 1.5 volts to 1.4 volts when a 10 ohm load is…

A: In this question,  A cell has a terminal voltage that changes from 1.5 volts to 1.4 volts when a 10…

Q: A voltmeter that reads 0.100 volts has a 200-division scale that can read up to half a division.…

A: Given,Range of the voltmeter is 0-100 Volts.Divison on the scale is 200.The voltmeter  can read up…

Q: What is the corrosion current when the circuit resistance is 0.25ohms and the potential difference…

A: In this questionWe need to determine the current in the corrosion if voltage across the circuit is…

Q: What are the protection coordination procedure of circuit breakers

A: Protective Devices MOV (Metal Oxide Varistor) fuse Circuit Breaker Relay Lighting Arrester Inrush…

Q: Explain in paragraph the relationships of resistance, voltage and current, and the distribution of…

A: Question is asking about relationships of resistance, voltage and current  also distribution of…

Q: Determine the resistance and tolerance of each of the 4-band resistors shown below.

A: We need to find out the resistance value for the above two resistors.

Q: How does the internal circuitry differ among the Ohmmeter, voltmeter, ammeter?

A: Ohmmeter - Ohmmeter is used to find value of resistance. In ohmmeter, An independent voltage source…

Q: 30) A specification requires the PV array for a stand-alone PV system to be sized to produce 1.25…

A:

Q: A consumer has a work area that he wishes to illuminate with single 80W, 220V tungsten fitting. The…

A: Given Data: P = 80 W V = 220 V Current rating of one switch = 10 A

Q: a. Determine V, for the gate in figure (1). b. Determine level of V, for gate in figure (2). c.…

A: Given : In the given question they have mentioned an electrical circuit having the diode and voltage…

Q: Explain the charging system from Supply system to the battery in detail

A: In an Electric Vehicle (EV), the charging system is responsible for transferring electrical energy…

Q: True or False   Exposed non current carrying metals parts are capable of carrying current if…

A: The above statement is TRUE which describes that the exposed non current carrying metal parts are…

Q: @1: When using Weatstone bridge for resistance measurement, excessive current Can result with S [A]…

A: Basic introduction of Wheatstone bridge It is the device that is used for the calculation of unknown…

Q: Describe how to place the DMM to measure the current, voltage, and resistance

A:

Q: Q. The input for any circuit at lab experiments are O B. the switches OD. None of the above O C.…

A: While performing the experiments in Laboratory, the inputs is given at one terminal and switches and…

Q: None

A: Batteries are essential for storing electrical energy, and different types cater to various needs…

Q: Of the Type A electrical resistors produced by a factory, 85.0% have resistance greater than 41…

A: The answer is  14.1%

Q: Which statement is TRUE about coulometry? a. There is only one circuit and all of the potentiometric…

A: What is true about coulometry ?

Q: electronics circuit determine the following:   - If Q1 is turned on in Figure 4a, what is Vout?…

A:

Q: How does a voltmeter differ from a potentiometer? What type of meter is the Corning- 10 pH meter?

A: A voltmeter and a potentiometer are two different types of measuring instruments used in electrical…

Q: There are two types of switch's in the electrical circuit attached . What is the state of each type…

A:

Q: What is the minimum wire size for a 30 amp circuit?

A: To determine the minimum wire size for a 30 amp circuit. For the minimum wire size refer the NEC…

Q: What advantage does a 4 inch octagon box have over a 3 1/4 in octagon box

A: An Octagon box is a general type of electrical switch box, which is commonly utilize for installing…

Q: The current flow in the FET device is only due to the carriers.

A: Current flow in the FET devise is only due to the ....... Carrier

Q: What is the advantage of using erasing shield

A: An erasing shield is a meager sheet of treated steel or plastic with spaces and openings of various…

Q: Question V  What is the resistor range if the LED has a forward voltage of 1.7V. Supply voltage is…

A:

Q: (ii) (iv) Explain how you would take a voltage measurement with a multimeter at a given point in a…

A: The above questions are based on different modes of a multimeter.

Q: It is desired to renew two different electrodep systems with a 9 Volt supply source. The first…

A:

Q: Define 5 applications where voltage regulators are used.

A:

Q: How to solve KCL and KVL?

A:

Q: If an electronic resistor lacks the fourth color strip, it has a tolerance of a. 1% b. 20% c. 5% d.…

A: The fourth band in any resistor represents the percentage tolerance of the resistor. Resistor…

Q: what is value of current (I).

A: Given circuit is -

Q: Task: Add another potentiometer with voltage divider to control another diode led manually.…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.