please answer question c During the construction of a dam, concrete was poured into a lift of approximately 1.8 m (yı =1.8 m). The shape of the front of the dam is reused from level to level. The figure shows onesuch shape, which is bolted to the cured concrete.New pour levelCantileveredform60°Old pour levelBoltsCuredconcreteFigure 1: Schematic for a dam's base.For the new pour, assuming that concrete acts like a liquid when it is first poured and has aspecific weight of 20 kN/m³, do the following:a. Describe the forces acting on the form due to the concrete.b. Describe the forces acting on the form due to the air.c. Determine the position of the center of pressure on the form.

Answered: please answer question c

Engineering

Civil Engineering

please answer question c

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: What are the characteristics of Error-Detecting Codes

A: Error-detecting codes - They are the sequence of numbers that are generated by specific procedure to…

Q: Part 1 Determine the answers for each size on the Civil Scales: (A) 1"=10' (for answers 1-3) &…

Q: Need help with this homework.

Q: One of the following choices is not among the types of volume counts : * Time variation counts.…

A: Volume count Counting the number of vehicles passing through a point in a given interval of time ,…

Q: Consider the following project network. Determine the critical path and the project duration. D 2 E…

A: The given project network is shown below:

Q: Define the following (300-500 words each) ITEM DESCRIPTION 1.Depth-Area Relationship…

A: In the hydrology aspect, there are several relationships between different parameters such as…

Q: Q1)- students have to write importance of geology to civil engineer, maps, and mapping techniques…

A: Geology is the research of environment, the substances it is constructed of a composition of such…

Q: 1. What is Airspace Charting? 2. How do you read an Airspace Chart? 3. What charts do pilots use? 4.…

A: Note: Hi! Thank you for the question as per the honour code, we’ll answer the first question since…

Q: : Draw the network diagram by using AON technique for the following activities, define the located…

A: First we will draw the network using AON type. Then we will find the critical path for the network.…

Q: Write an introduction report on the topic of topographic surveys

A: Topic : Topographic surveys

Q: How many hours will the construction activity for painting a/an 27m2 wall would last if 11m of the…

A: It is required to find the number of hours required to paint 27 m2

Q: The given shaded area in the figure below, it is the top plan of a flower garden (with a circular…

Q: d t (consta nt thicknes s) b Area (xbar) Ixo lyo ly NA 1- = 11 in 0.3 in 4 in 3.300 in2 1.495 in…

Q: Discuss the nearest neighborhood resampling algorithm, as one of image rectification techniques

A: Nearest neighborhood re - sampling system selects the value of pixels to an unspecified pixel based…

Q: What is a moving walk?

A: A moving walk is an equipment which transport people to short distance through conveyor mechanism.…

Q: Q2/ Initial Map scale is 1: 1000. The playground is rectangular and on the map has dimensions 8 cm…

A: This question is related to the Surveying Engineering from Civil Engineering. In this question ask…

Q: Proposed a number of upgrades to the existing BMS

A: There should be the proper upgradation of the BMS for the better life of the building. The proper…

Q: can u pls do the question 2 and 3

Q: Write brief notes on the following: a, the technique of estimating mean depth and mean area; and b,…

Q: Q4: The project company shown in the table has used the early and late times to answer the following…

Q: ing the epanet program, create a water network on this map, the percentage of personal consumption…

A: The Water Supply and Water Resources Division of the United States Environmental Protection Agency…

Q: What situation does Route Survey is applicable?

A: The situations that require application of Route survey are explained in the following step.

Q: and follow the proper filename format for the submission of assessment tasks. No. 1 %3D 3w 4z 3w -1z…

Q: The top-down approach is typically used on simple projects in which the tasks and schedule are…

A: the answer is false

Q: Determine the Departure Misclosure and Latitude Misclosure for the four sided parcel shown below.…

Q: What types of conduit are in general use?

A: Types of conduit that are generally used are Rigid Metal Conduit—RMC and IMC. Electrical Metallic…

Q: 1. 26.1% of the surface area of the spherical buoy is submerged in water. Find the specific gravity…

Q: Note: Replace all zero digits of your ID number by number "2" Problem #3: y-axis Use X = Last 3…

Q: Define Traffic management?

A: Traffic management:

Q: Question 8 (1) Question 9 (1) What is the FS Reading What is the BS reading ? Answer: Answer: 4 2

Q: Note: 1)There is no more extra data. 2) This is not writing assignment question.

A: Whenever writing the research or the thesis regarding construction and the main purpose. There are…

Q: 1. Apparent Specific Gravity 2. Soil Structure

A: 1) Apparent specific gravity:- The weight in air of a unit volume of aggregate's impermeable…

Q: aseholds going to cover in the city. (1 mile = 5,280 feet) (chc closest answer) Total of 400…

A: The given data in the question is: Total of 400 households All employments and exchanges are at…

Q: Determine the missing storm precipitation of station 'E' given in the following table: B Station…

Q: Answer the following four questions for the following information Time (min) Discharge (m³/s) disch…

A: The table given is of flood hydrograph. Since at the end and beginning of the observation flow is…

Q: How final survey report is helpful?

Q: Please make it fast 104. Wie wird die Kapazität von Parkhäusern berechnet?

A: Precautions against parking involve measures to ensure safety, legality, and convenience. Here are…

Q: 50 F 10 m B 150 6 O 400 tlo o + 100 150 50 00 50 50 100 150 20 す。 F' of X K X X

A: profile graph would be according to the elevation i.e. the contour level given in the diagram as we…

Q: يستخدم جهاز الثيودولايت لقیاس * الزواية الافقية والراسية فقط 5 points خطأ

A: For 3rd question answer is both

Q: unit rate of 51 minutes/ 6 miles

Q: Project Planning Prepare two slides for Construction a new villa as per the follow : - First slide…

A: Project planning is a discipline that addresses how to accomplish a project within a specific…

Q: uble the garden area with the addition of this path. How wide should the path be? ct one: .1m . 2.85…

Question

please answer question c

During the construction of a dam, concrete was poured into a lift of approximately 1.8 m (yı =
1.8 m). The shape of the front of the dam is reused from level to level. The figure shows one
such shape, which is bolted to the cured concrete.
New pour level
Cantilevered
form
60°
Old pour level
Bolts
Cured
concrete
Figure 1: Schematic for a dam's base.
For the new pour, assuming that concrete acts like a liquid when it is first poured and has a
specific weight of 20 kN/m³, do the following:
a. Describe the forces acting on the form due to the concrete.
b. Describe the forces acting on the form due to the air.
c. Determine the position of the center of pressure on the form.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Stresses in saturated soil without seepage

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the coordinates of the centroid of the given area.
Convert 55 mph to ft/sec, and then, to meters/sec. Show all work below.
Please answer the remaining 2 questions. D and E
Write brief notes on the following: a, the technique of estimating mean depth and mean area; and b, technical sanction.
Parking and its types
Q1) Calculate the number of aviation lines if you know that the dimensions of the area 30 x 30 km and the scale 1:20000 and the dimensions of the negative board 25 x 25 cm and side overlap 30%.
7:06 A A O 16* .l ul 93% docs.google.com/forms/d/e/1F/ 5 BSCE CEM Problem. On one side of the gate, water stands level with the top of a vertical rectangular gate 4 feet wide, 6 feet high, and hinged at the bottom. On the other side, water stands 2 feet below the top. rdcbasilio@bpsu.edu.ph (not shared) Switch account 1. the hydrostatic force at the left side of the gate is 20 points a.) 1492.8 Ib. b.) 2492.8 Ib. c.) 3492.8 Ib. O d.) 4492.8 lb. 2. The hydrostatic force at the right 20 points side of the gate is a.) 1996.8 Ib. b.) 2996.8 Ib. c.) 3996.8 Ib d.) 4996.8 Ib. +
O My Apps Dashboard | Flinders Ur x → E FLO 0 Quicklinks Shared EASC3741_2022 S1 Participants Competencies Grades General General flo.flinders.edu.au/mod/quiz/attempt.php?attempt=5323287&cmid=4056900&page=4 W1 - Introduction, hydrologic cycle & water balances W2-Groundwater geology & porosity W3-Aquifer types & properties (Part 1) 2022 S1 online quiz/test (EASC97 % W4 - Aquifer types & properties (Part 2) - + A fracture rock sample of volume 4.49 m³ has a primary porosity of 0.187. The sample is completely saturated with 1069 L of water. If the mobile water occurred only in the secondary porosity of the sample, what is the effective porosity of the dual-porosity sample? Answer: Previous page Help and Support Links Time left 3:13:27 Question 5 Not yet answered Marked out of 3.00 Flag question Next page Qui 8 15 E Flinde
Subject: irrigation engineering Do comparison of flood irrigation, sprinkler and drip irrigation? Also state what method is used in your village. Critically state the advantages and disadvantages of the above methods from your practical village experience? (please NO diagram should be drawn) ---------------approx. 10 lines
the answer choices are given in the picture.... the answers provided are not even options from the picture
Below is a link to an intersection. Provide two different design solutions that would reduce conflicts at the intersection. Explain your solution and provide a brief rational as to how it would reduce conflicts. (Assume that property is not an issue and that buildings in the area can be relocated and don't worry about cost)
In your own words, Explain the usage of hazard map. Write it in essay form.