Given the movement of the magnet relative to the wire loop, what will be * 1 point the direction of the induced current in the wire loop for the three cases for a, for b, and below when viewed from the right? It will be for c. (CW: clockwise, CCW: counterclockwise) - 0--0- 0 S S a) b) c) CCW, CW, CCW CW, CCW, CW CW, CCW, CCW CCW, CCW, CW S

Given the movement of the magnet relative to the wire loop, what will be * 1 point the direction of the induced current in the wire loop for the three cases for a, for b, and below when viewed from the right? It will be for c. (CW: clockwise, CCW: counterclockwise) - 0--0- 0 S S a) b) c) CCW, CW, CCW CW, CCW, CW CW, CCW, CCW CCW, CCW, CW S

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter11: Magnetic Forces And Fields

Section: Chapter Questions

Problem 90AP: A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A,...

See similar textbooks

Similar questions

In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
A coil of 1000 turns encloses an area of 25 cm2. It is rotated in 0.010 s from a position where its plane is perpendicular to Earth’s magnetic field to one where its plane is parallel to the field. If the strength of the field is 6.0 x I0 T. what is the average emf induced in the coil?
An emf is induced by rotating a 1000-turn, 20.0 cm diameter coil in the Earth’s 5.00105T magnetic field. What average emf is induced, given the plane of the coil is originally perpendicular to me Earth’s field and is rotated to be parallel to the field in 10.0 ms?
Figure 23.59 A coil is moved into and out of a region of uniform magnetic field. A coil is moved through a magnetic field as shown in Figure 23.59. The field is uniform inside the rectangle and zero outside. What is the direction of the induced current and what is the direction of the magnetic force on the coil at each position shown?
Check Your Understanding. A current I(t)=(5.0A)sin((200rad/s)t) flows through the solenoid of part (b) of Example 14.1. What is the maximum emf induced in the surrounding coil?
A single-turn circular loop of wire of radius 50 mm lies in a plane perpendicular to a spatially uniform magnetic field. During a 0.10-s time interval, the magnitude of the field Increases uniformly from 200 to 300 mT. (a) Determine the emf Induced in the ioop. (b) If the magnetic field is directed out of the page, what is the direction of the cun-ent induced in the loop?
The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
A 10-H inductor carries a current of 20 A. How much ice at 0ºC could be melted by the energy stored in the magnetic field of the inductor? (Hint: Use the value Lf= 334 J/g for ice.)
A wire of length 1.0 m is wound into a single-turn planar loop. The loop carries a current of 5.0 A, and it is placed in a uniform magnetic field of strength 0.25 T. (a) What is the maximum torque that the loop will experience if it is square? (b) If it is circular? (c) At what angle relative to B would die normal to the circular coil have to be oriented so that the torque on it would be the same as the maximum torque on the square coil?
The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?