● Pay special attention to the role and operation of the horn relay. Learn how to measure voltage and inspect each checking point. Fusible Link Battery Fuse Choose the best answer. 1. What happens when point 1 is grounded? a) The fuse will blow out b) The fusible link will blow out c) The relay will be damaged 2. What happens when point 2 is grounded? a) The horn will not sound b) The fuse will blow out c) The horn will keep sounding Inductor Relay reee Horn Switch 3. What happens when point 3 is grounded? a) The fuse will blow out when the switch is turned on b) The fuse will blow out when the switch is turned off c) The horn will keep sounding (m) Hi 40₁ Horns Low

Describe the process for controlling maintenance requests. Should all requests be handled in the same way or are there situations when you should be able to circumvent the process? If so, when and why?

Plz I need the answer of this question

Question 5 What is the device address used by the instruction OUT A4, AL?

What function does a classic load balancer serve? I need like three sentences.

· Explain the meaning of terms (Accuracy and Precision) and give example for an each?

1-What phrase is used when a substitution is permitted for a specific item? 2-The specifications state that all work shall be done... 3-What phrase is used when a substitution is permitted for a specific item? 4-What is the purpose of an electrical symbol? 5. Where are notations found?

Q.1) Assume that the control of a bottle filling system is performed with an 8051 microcontroller. • The start and stop of the conveyor is controlled by the P1.0 pin. • The bottles are moving on the conveyor and detected with a sensor. When they arrive at the filling place, they are detected with a logical "1" signal, otherwise they are detected with a "0" signal. • A valve connected to P1.1 turns on for 10 seconds to fill each bottle. • At every X bottles, the conveyor will stop for 8 minutes and then start again. The remaining time to restart in the waiting period is displayed in minutes on the 7-segment display. • Logic "1" is detected from P1.3 during the operation of the system. Logic '0' is detected from P1.3 at the end of the shift. • At the end of the shift, the number of the filled bottles will be determined and saved in a memory location as 2 bytes. Write the required program. (Crystal Frequency:12MHZ). NOTE: X number will be taken as the last 2 digits of 59

What is the maximum number of digits that may be used in the Octal System?

Explain the concept of microchip fabrication and the various manufacturing processes used to create microchips.