Path Loss Exponent Calculation

B. Find the transfer function, G(s), for the circuit in Figure 2 below: naimpo nine Vi(t) VIDO 21 + Vo(t)- 00000000 ↑ I R 3L IL 茶 Problem 18

Construct the XOR operator using only NAND gates. Hint: xXOR y = (xy)(xy)

helpp

2- Design 8-bit Ripple Carry Adder using structural representation based on 1-bit full adder where the design of 1-bit full adder is given below A B Cy. FA S = A OB OC Cy = A.B + A.C + B.C

Question 2 In Figures 2, 3, 4 and 5 the designation of the state of the MISO signal is "Hi-Z" before an. after the SS signal is low. This means the output driving the signal is turned completely off and not driving the signal either high or low. "Hi-Z" means "High Impedance". Also in the figures, the designation of the state of the MOSI signal is "XXX" before and after the SS signal is low. This means the state of the signal is "Unknown" or "Don't Care". If there are multiple Slaves on the bus, why must a Slave turn off the driver (Hi-Z) on the. MISO signal when their SS signal is high

4 bit 2’s Complement Multiplier INPUT A: 4 bit 2’s Complement numberINPUT B: 4 bit 2’s Complement numberOUTPUT: the product of A x B represented as a 8 bit 2’s Complement number   Do this:Build a 4 Bit UNSIGNED Multiplier as a subcircuit named UnsignedMultiplier use AND gate ,full and half adders for the circuit