Parallel Circuit Problem #2 Using the following circuit, find the total resistance, the total current, the current through each resistor and the voltage drop across each resistor. Also find the power dissipated in each resistor. Let Vs = 60V R1 = 4kQ R2 = 8kQ R3 = 6kQ

Q: From the circuit shown determine the graph of Vo=F(V1) for R=10k V1 R D1 R VZ=5V D2 R Vo

A:

Q: Clock K (a) Q (b) Q

A:

Q: O Vcc=12 V R₁ R₂ Rc RE=1k

A: The given problem is from BJT. The detailed solution is given in the next step

Q: ii) Vin iii) 500 Ω Figure 2.1 Figure 2.1 shows a voltage regulator circuit using a 5.2 V Zener diode…

A:

Q: Consider the hyperbolic functions, and their inverses, as real functions of a real variable. (a)…

A: Note: Trigonometric functions and Hyperbolic trigonometric function is very important in signal and…

Q: The Thevenin equivalent circuit (E, Z) at the terminals a-b of a certain network is shown in Figure…

A:

Q: Determine the damping ratio (zeta - Z) of a system from analysis of its differential equation, given…

A: We need to find out damping ratio for given system .

Q: A second order feedback has G(s)=. rotated at 4 rpm and steady state error is 0.5 degree, then k…

A: Given- A second order servomechanism- Unity feedback- Gs=ks(s+6), Steady state error e=0.5, Shaft…

Q: :For the shown Network, find the collector current (Ic) of the npn trar 4.7 ΚΩ 280 ΚΩ Www ·c= 10V…

A: This problem is from BJT. The solution is given in next step.

Q: :For the shown Network and using the re-model and ro= 50 kilo Ohms, compute the output resistance Zo…

A: Note BJT Modes of operation When BE and CB junction is reverse biased= Cut off Region When BE…

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A: Given data, Critical frequency is given fc=12.5 MHz. Incidence i=650.

Q: How did you know that energy is 0.5 CV2

A:

Q: What resistance is present in the tuned circuit that limits the gain and quality factor of the…

A: Q=XLRVG=βZcZin where Q- quality factor XL-Inductive reactanceR-Inductive resistanceZc-effective…

Q: 1. Using the superposition and time delay theorems and the known result for the transform of the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: draw frequency response on semi log paper  and find  Bandwidth(BW) note use the same paper…

A: The given table is a measurement of the frequency versus gain in dB. The bandwidth is the difference…

Q: 1 Find the transfer function G(s) = VL(s)/ V(s) for the electrical network shown v(t) (+ 2 H 0000…

A:

Q: For the figure below determine the lower culiff frequencies) and sketch the frequency response using…

A: The required frequency analysis can be carried out with the help of DC and AC analysis. The low…

Q: Match the system's step response to its differential equation

A: The given differential equation is a first-order system and it should be converted into a transfer…

Q: Q.3) An ideal boost converter is required to have a constant output voltage of 12 V at 24 W load.…

A: Given data: The voltage, Voutput=12 V The power load, Pload=24 W The frequency,f=100 kHz The…

Q: P5.76. Determine the power for each source shown in Figure P5.76. Also, state whether each source is…

A: Note Only active power will be available in purely R Load Only Reactive power will be available in…

Q: :For the shown Network, find the collector-Emitter voltage (VCE) of the npn transistor 300 ΚΩ ww 12…

A: The given problem is from BJT. The detailed solution is given in the next step

Q: implify the block diagram H₁ G H₂ ✪

A:

Q: VALIDA Example 8.31 A 3-phase balanced load connected across a 3-0, 400 V ac supply draws a line…

A: Given- Voltage, VL=400V, Line current, IL=10A, Ratio of two wattmeter readings = W2W1=12,   To find…

Q: 10. What is the total power of an AM transmitter with carrier power of 1 kW with a modulation index…

A: We need select correct option for amplitude modulation power .

Q: Charge Q-80x10" C is distributed uniformly throughout a spherical insulating shell of radius R-5.7…

A: Given data: Charge, Q=8.0×10-9CRadius, R=5.7 cm=5.7×10-2mDistance r=19.0 cm =19×10-2m

Q: :For the shown Network, find the base current (Ig) of the npn transistor 4.7 ΚΩ 280 ΚΩ WWW 10V B…

A: We need to find out the base current for given circuit .

Q: Can you use the attached photo to fill in a truth table, write the logic expression (a function in…

A: In the given questions we need to find output of each stage and fill the truth table.

Q: Design and implement a 3-input minority circuit. A minority circuit is a combinational circuit whose…

A: Given: A minority circuit is a combinational circuit whose output is equal to 0 if the input…

Q: :For the shown Network, find the power dissipation of the npn transistor 300 ΚΩ 12 V 4.7 ΚΩ ww Ic…

A:

Q: J=1 COMMJK1 k=1- 3:1 a1 Jk2 K=1 Relationship between CO and Q2 ? Q2

A:

Q: The DRAM memory cell is a capacitor. If the cell area is 1μm2, with a 4 nm oxide as the capacitor…

A:

Q: ANS-1) ANS-2) ANS-3) ANS-4) yer al -y-eg. If $ D dl = 3 is true on a surface, which of the following…

A: According to the question, we need to explain the physical meaning of the given expression as shown…

Q: 2.2 Find the Norton equivalent of the circuit of Figure 5. 5 V (+ 500 Ω www Vab + ↓ 10i 25 Ω a b

A:

Q: 12. An AM radio receives no station above 900 kHz. What is the likely problem? a) b) No input to the…

A: Solution of question (12): Given statement is "an AM radio receives no station above 900 kHz". Four…

Q: :For the shown Network, compute the re resistance of the transistor re model li 470 μF th Vi Zi 200…

A: Transistor is three terminal device. Three terminal are emitter, collector , base. The feedback from…

Q: ANS-1) ANS-2) ANS-3) An electron moves in the x direction on the line y = 1. In which of the field…

A:

Q: Find the Torque equation for the Dc motor seperately excited

A: In case of separately DC motor, the main supply is given separately to the armature and field…

Q: Find v(t) in volts, one time constant after time to: Is = 3.9 A, R₁=478 , R₂-966, C₁-202 mF, C₂-266…

A: Given: Is=3.9 A, R1=478 Ω, C1=202 mF, C2=266 mF To find: V(t) in volts after one time constant from…

Q: A high voltage Schering-bridge has the following arms a) Standard capacitors: 500 pF and 100 pF b)…

A: Given: A high voltage Schering-bridge has the following arms a) Standard capacitors: 500 pF and 100…

Q: Input V1 CC 10pF SINE(0 100mV 5k) R1 9K R2 2220 Vb Out RC 3.0K Q1 2N3904 Emitter RE 1K Vcc CE 10μ

A:

Q: The induced voltage of a wave connected generator is 200 volts and the flux per pole is 0.02 Wb. The…

A: In this question,  We need to determine the number of pole of the generator.  We know  Induced emf…

Q: :For the shown Network, find approximate power dissipation of the npn transistor 150 ΚΩ 12 V lb 4.7…

A:

Q: GIVENS: RG = 8.6 kΩ; Vs = 236 V, 60 Hz C = 0.75μF; IGT = 40 mA; Iave = 1.4 A VGT = 0.7 V; RL = 50…

A: Given data: Gate resistance,RG=8.6 kΩ Supply voltage,Vs=236 V Frequency of the supply voltage,f=60…

Q: Q1/ Sketch the line spectrum of the following signal: m(t) = 3-5 cos (40nt -30°) + 4 sin 120nt

A:

Q: = = For a message signal m(t) = 2 cos(100t) + 18 cos(2000mt) Write ex- pressions for OFM (t) and OPM…

A:

Q: Find the currents of each resistor using super position method. Where, VLeft = 160V; VRight = 180V;…

A:

Q: Amplitude Amplitude Amplitude 0.5 0.5 0 0.5 0 0 step response against time in seconds 0.5 0.2 1 step…

A:

Q: Find the currents of each resistor using super position method. Where, VLeft = 160V; VRight =…

A: In this question we need to find a current I3left of the given circuit

Q: 3. Satisfy the Maxwell Equations by using E and H fields given below for source-free, free-space. Ē…

A: Maxwell Equation ∇.E→ =ρεo∇.B→ =0∇×E→ =-∂B∂t∇×B→ =μo(J+ε0∂E∂t) B= Magnetic field E= Electric field…

Q: :?For the shown Network, what is the region of operation of the npn transistor 62 ΚΩ 9.1 ΚΩ 12 V lb…

A: We need to find out region of Operation for given circuit .

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.