One pound of air per second with an initial temperature of 180 °F is allowed to expand without flow (closed system) from a pressure of 120 psia to 20 psia. Find work in hp if the process is (a) pv=c (b) pv^k=c (c) pv^1.5=c

One pound of air per second with an initial temperature of 180 °F is allowed to expand without flow (closed system) from a pressure of 120 psia to 20 psia. Find work in hp if the process is (a) pv=c (b) pv^k=c (c) pv^1.5=c

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A piston-cylinder assembly contains water that undergoes a series of processes. Process 1-->2:…

Q: A 0.3 m^3 rigid tank receives paddle work at a rate of 4.5 W for 30 minutes. Initially, the gas has…

Q: water pump compresses water at a flow rate of 1 kg/s, at P1= 5 MPa and T1= 20 oC, to P2= 10 MPa and…

A: Given Data mass flow rate of water: 1 kg/s P1 = 5 MPa and T1 = 20°C P2=10 MPa and T2=40°C Q=-25000…

Q: A horizontal pipe has a sudden expansion from diameter 8 cm to diameter 16 cm as shown in Figure…

Q: ands polytropically through a gas turbine according to the process PV^1.42 = C. If the turbine…

A: Given:PV1.42=CW=27.04 MW

Q: m enters a turbine with an enthalpy of 1292 Bt/lbm and leaves with an enthalpy of 1098 Btu/lbm. The…

A: Given:h1=1292 Btu/lbmh2=1098 Btu/lbmQ=14 Btu/lbmm=2 lbm/sec

Q: A manometer with water as working fluid is connected to an air duct as shown in Figure 1.1. Flow…

Q: One pound of carbon monoxide per second with an initial temperature of 400°F is allowed to expand…

Q: A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079 lbm/cu…

A: Given Data: The volumetric flow rate of air, V=500 ft3/min Change in internal energy, ∆U=33.8…

Q: The velocity distribution (in m/s ) in a pipe with D1 = 4 cm is given by 1/7 Vz = 3 1- R1 where R1 =…

Q: The relation Δu = cv ΔT is valid for any kind of process, constant-volume or not.

A: Given data: *The initial temperature of the first system is T1i=20°. *The final temperature of the…

Q: Krypton in a closed system is compressed adiabatically from 94 K and 1 bar to a final pressure of 24…

A: Given: initial temperature→T1=94 K Initial pressure→P1=1 bar Final pressure→P2=24 bar Krypton is…

Q: 250 degrees saturated steam enters a steam coil. The steam is condensed in the coil, leaving as a…

Q: Energy is added to 4.6 kg of air with a paddle wheel until ΔT = 102 °C. Find the paddle wheel work…

Q: 4. The properties of a closed system change following the relation between pressure and volume as pV…

Q: show your solution on a paper with measures of units in every process. Find the mass flow rate in…

Q: Example 5.18. The relationship Between press by the expression: 3 + 2 where presssure p is in bar…

A: Given:P=3V+2Q=+1600 kJV1=1.2 m3V2=4 m3dV=V2-V1=2.8 m3

Q: 4. A compressor draws in 500 of air whose density is 0.079 min and discharges it with a density of…

A: Given data: The drawing rate of compressor is V = 500 ft3/min. The density of air at the time of…

Q: As part of a processing of biofuels, water is pumped into a circular tank with a diameter Dt. as…

A: For solution refer below images.

Q: One pound of air with an initial temperature of 200F is allowed to expand without flow between…

A: mass, m=1 lb or 0.453 kgT1=200o F or 366.48 KP1=90 Psi or 620528 PaP2=15 Psi or 103421 Pan=1 ,…

Q: For Non-flow Work fow systems with pv=const (Select All correct statements below):Work is directly…

A: Among the given statement: statement 1, statement 2, statement 4 are correct.

Q: Air at pressure 173.9 kPa flows through a pipe. The actual volume flow rate of air through the pipe…

Q: A wind turbine has a blade length of 30 m. In a given day, average speed of wind for 5 hours is 9…

Q: 36 The air velocity in the duct of a heating system is to be measured by a Pitot-static probe…

Q: An automobile cooling system holds 16 L of water. How much heat does it absorb if its temperature…

Q: m = 70 kg/s P₁ = 40 kPa Saturated Liquid Water W = 140 kW 2 Q = 302 MW Boiler 3

A: (a) To find: The boiler pressure. Given: The pressure at the entry of the pump is P1=40 kPa. The…

Q: Q2: A nozzle is a device for increasing the velocity of steadily flowing stream of fluid. At the…

A: GIVEN DATA- A NOZZLE GIVEN INLET CONDITION h1=3025 KJ/Kg , C1=60m/s , Z1=0m , A1=0.1m2 , v1=0.19…

Q: A nozzle is attached to a pipe at Point 1 as shown in the figure. Water (= 1000 kg/m³) enters the…

Q: 3.)A pump delivers 4 m³/min of water from 110 kPa to 350 kPa. Both pipe's gages are on the same le…

A: Given data as per question Q=4 m3/minP1=110 kPaP2=350 kPad1=16 cm=0.16 md2=13 cm=0.13 mρ=997 kg/m3

Q: 2) The energy consumed by a shower for 30 days is 22kwh. It is known that the resistance of the…

A: To find: The value of time in minute. Given: The value of energy consumed is, 22 KWh. The value of…

Q: Water is to be pumped from the bottom of a well 20 ft deep with a specific heat of 1 BTU/lbm F is…

A: Calculate the mass flow rate of water. m˙gh=Wm˙9.8120 ft×0.3048 m1 ft=1 hp=746 Wm˙=12.47…

Q: what is the nonflow work

Q: Helium expands polytropically through a gas turbine according to the process PV^1.327=C. If the…

A: For solution refer below images.

Q: Steam enters a turbine with an enthalpy of 1292 Btu/lb and leaves with an enthalpy of…

Q: An oxygen gas R = 0.2598 KJ/kg°k and k = 1.395. If 4 kg of oxygen undergo a reversible non flow…

Q: A hot air balloon is used as an air-vehicle to carry passengers. It is assumed that this balloon is…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

3. A fluid system undergoes a non-flow frictionless process from 5.5 ft to a final volume 2.5 ft in accordance with the defining relation P= 60/V + 23 psi, where volume is in ft. During the process the system reject 30 BTU of heat. Determine the change in enthalpy and internal energy.
A reciprocating compressor draws in 500 cubic feet per minute of air whose density is 0.079 Ibm/cu ft and discharges it with a density of 0.304 lb /cu ft. At the suction, pi = 15 psia; at discharge, p = 80 psia. The increase in the specific internal energy is 33.8 Btu/lbm. Determine the work on the air in Btu/min and in hp. Neglect change in kinetic energy. Ans. 56.25 hp
A container maintains a constant pressure of 40800 Pa while changing to a volume of 791 liters. If 31080 J of work was done by the gas, what was the starting volume? *
One pound of air with an initial temperature of 200F is allowed to expand without flow between pressure of 90 and 15 psia. if the air is undergoing a process that follows pVn=C, where n=1.5, what is the non-flow work?
A fluid undergoes a frictionless process in a closed system form v1=5ft to v2=2ft^3 in accordance with the relation v=36/(p-8) where p is the psia and v is ft^3. During the process, the fluid rejects 30 BTU/lbm. Compute the change of heat transfer.
Power of a pump (N); the flow delivered by the pump (Q), the pump's head (H) and the fluid delivered by the pump Since the specific gravity () is a function, obtain the relation that gives the power of the pump by size analysis.
(2.) Steam enters a turbine with an enthalpy of 1292Btu/lb and leaves with an enthalpy of 1098 Btu/lb. The transferred heat is 13 Btu/lb. what is the work in kW and in hp for a flow of 2 lb/sec? draw a figure also, and explain each step by step solution.
Please assist with this thermodynamics question
A rigid vessel containing water has a temperature of 200 C and a pressure 200 kPa with a volume of 1.0 m^3. If 100 kJ of heat is added to the tank in an isobaric process, what's the final temperature?