Olympic cyclists fill their tires with helium to make them lighter. Calculate the mass of air in an air-filled tire and the mass of helium in a helium-filled tire. What is the mass difference between the two? Assume that the volume of the tire is 855 mL, that it is filled to a total pressure of 125 psi, and that the temperature is 25°C. Also, assume an average molar mass for air of 28.8 g/mol.

Q: Nitrogen is an essential source of nutrition for growing plants. Ammonia has the highest nitrogen co...

A:

Q: A wet solid is dried from 55to 12 percent moisture in 30 ks. If the critical and equilibrium moistur...

A: For first drying operation w1 = 0.55 kg/kg, w = 0.12 kg/kg, wc = 0.22 kg/kg, we = 0.07kg/kg Thus: f1...

Q: Chemical Engineering Draw a flow diagram of life cycle of glass/ceramic industry.

A:

Q: Answer immediately pls

A: Given data: Flow rate of air at 1 atm and 70 0F = 1000 cc per 600 s Downstream side pressure = 1 atm...

Q: The roasting of pyrites analyzing 85% FeS2 and 15% gangue utilizes 40% excess air (FeS2 to SO2) supp...

A:

Q: A saturated liquid feed of 500 mol/h at the boiling point contains 30 mol% ethanol and 70% water is ...

A: Hi, thank you for posting the question. Since part a contains multiple questions, only part a will b...

Q: can you please answer question b

A: Given data:  P = Po * ekt   here, P = total population after time t (gram)           Po = initial po...

Q: Soru 12 Very pure liquid water can be subcooled at atmospheric pressure to temperatures well below 2...

A:

Q: None

A: Dimensions refer to qualitative characteristics for physical quantities. Physical quantities are tho...

Q: Question 1 Terephthalic acid (TPA), a raw material in the manufacture of polyester fiber, film, and ...

A: PX=C8H10 TPA=C8H6O4 S=Solvent R=recycle rate S/PX =3:1 90% PX converted to TPA temperature T=25C Pr...

Q: 0.15 L/s 10.0 mol A/L 15 mol B/s V = 10 L 0.15 L/s CA(mol A/L) Св(mol B/L)

A: A reactor is a equipment in which reaction where takes place. In an industrial reactor most importan...

Q: What is Crystallographic analysis ? Why it is used for ?

A: The definition of crystallographic analysis is to be mentioned along with the reason for using it.

Q: Book: Process Dynamics and Control, Third Edition or Fourth Edition, by D. E. Seborg, T. F. Edgar, D...

A:

Q: Compare the column material of GC and LC in terms of the “functional groups” taking place on the col...

A: Introduction Chromatography is classified into two types based on the physical state of the mobile p...

Q: Book: H. Scott Fogler, Essentials of Chemical Reaction Engineering, 2nd Edition, Prentice Hall,2018

A: As per our company guidelines, we are supposed to answer only first 3 subparts. Kindly repost other ...

Q: A small-scale steam engine might operate between the temperatures 20°C and 300°C , with a maximum st...

A: Cold temperature, TC = 20°C = 293 K Hot temperature, TH = 300°C = 573 K Steam pressure, P = 10 bar

Q: A binary mixture of species (1) and (2) with z1=0.60 is flashed at P-0.8 bar. Using P-xy diagram giv...

A: Given data: Composition of component 1 in the feed = 0.6 Pressure at which the flash vaporization ta...

Q: 1. A water solution containing 10% acetic acid is added to a water solution containing 30% acetic ac...

A: Stream 1 composition: mass fraction of acetic acid, xA(1) = 0.10 Stream 2 composition: mass fraction...

Q: 7.13 Benzene and toluene enter a reboiler at a molar flow rate of 100 mol/h. The reboiler is operati...

A: Given: A mixture of benzene and toluene enters a reboiler at a molar flow rate of feed as F = 100 mo...

Q: what is the difference between Fick’s first and second law of diffusion. Sketch their velocity profi...

A: Diffusion : diffusion is a mass transfer process that results in the random movement of particles th...

Q: QUESTIONS Q1.a) Write the characteristics of acetone and explain the safety precautions in the stori...

A: (A)

Q: Which among the following is not an isomer of C6H14?

A: Isomer is explained as the two or more compounds with same molecular formula but different arrangeme...

Q: Carbon disulfide, CS2, burns in oxygen. Complete combustion gives the balanced reaction that has bee...

A: Given data: Mass of carbon disulfide = 35 g Mass of oxygen = 35 g

Q: You closed the mouth of the 5 liter empty PLASTIC bottle at 20oC, when you took the PLASTIC bottle o...

A: The initial volume of the empty plastic bottle, V1 = 5 L Initial temperature of the plastic bottle, ...

Q: Please, I need to solve the question in less than an hour.

A:

Q: Q2 the rate constant for a reaction at 20°C is half of the rate constant at 30°C. Calculate the ener...

A: Given data: Rate constant at 20 0C = half of rate constant at 30 0C

Q: as a function of conversion: -TA 0.2 0.0167 0.00488 0.00286 0.00204 0.1 0.4 0.7 0.9 (a) What is the ...

A: A 400 L CSTR and a 1000 L PFR  volumetric flow rate of  feed-1 L/s The feed contains 41% reactant A,...

Q: The Jujur Field's reservoir at a pressure 4000 psia and temperature of 200 °F has produces gas to oi...

A:

Q: I need an answer in short time.

A: Given that, The composition of entering gas: CO2 : 6.7% O2 : 0.2% CO : 38.6% H2 : 51.6% CH4 : 0.8% N...

Q: a) Identify regions I, II and III in the diagram below:

A:

Q: Pyrite containing 80% FeS2 and 20% gangue is burned in excess air to produce a gas with a complete a...

A:

Q: Is it acceptable to recycle the containers of hazardous chemicals? Why or why not? Explain your answ...

A: Chemical containers in the form of cardboard, plastic bottles or styrofoam, etc will have correspond...

Q: An ideal gas at pressure 200 kPa, temperature 20 oC and with a velocity 5.0 m/s enters a cylindrical...

A: Given data: Properties of ideal gas at the inlet of pipe are, P1 = 200 kPa T1 = 20 0C V1 = 5 m/s Pro...

Q: If we have P_(Steam Generator) = 2500 psia , P_(Condenser)= 5 psia, and N_(Feed Water Heater)= 4 at ...

A:

Q: Question 2

A: for contaminant dispersion in soil, the equation of dispersion flux follows as, Jm=Dm×n×dcdx where j...

Q: QI// find the co-efficient of thermal conductivity (k) can by substituting the measured values , tha...

A: Given that, Voltage V = 85 volt Current I = 6 Amp The diameter of metal rod D = 0.06 m The temperatu...

Q: Help

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: 5 mol of an ideal gas undergoes an isobaric expansion by adding 1,200 J of heat. Determine the incre...

A:

Q: (b)Solvent extraction is essential for separation in the chemical industry, briefly describe four ap...

A: The applications of solvent extraction in the chemical industry are to be mentioned.

Q: In some countries, liquid nitrogen is used on dairy trucks instead of mechanical refrigerators. A 3....

A: Volume of liquid nitrogen required, V = 200 L Density of liquid nitrogen, ρ = 808 kg/m3 Time of trip...

Q: A 5 kg of steam at 121C and 90% vapor undergoes a isometric process until the pressure becomes 28 MP...

A:

Q: explain the design of natural gas sweetening in detail

A: In the extraction of crude oil from the earth by drilling wells it also contains natural gases. Natu...

Q: Q1: Steam flows through a device with a stagnation pressure of 900kpa, a stagnation temperature of 3...

A: Given: Stagnation pressure P0= 900 kpa Stagnation temperature T0= 371 °C Velocity= 275 m/s, Cp= 1.00...

Q: In a reactive environment, chemical A decomposes as follows: R, 'R = CA mol/liter-s S, rs = 1 mol/li...

A: Given data: An aqueous phase, parallel reaction is carried out in a mixed flow reactor. Initial conc...

Q: Ql: In a pyrolysis process, the product gas analyzed 6.7 % CO2, 0.2 % 02, 38.6 % CO, 51.6 % H2, 0.8 ...

A: Product gas mixture Basis 100 mole of gas mixture n=100 moles CO2-6.7% O2-0.2% CO-38.6% H2-51.6% CH4...

Q: Difference between grizzy, trommel, gyratory and vibration screen

A: Screening: Screening stands for the mechanical separation of particles depending on size differences...

Q: 3- A system of stirred tanks is to be designed to convert 90 % of a solution containing 9.5 kmol/m? ...

A: (a) The volume of the single CSTR is to be calculated.   The volume of CSTR is given as:-           ...

Q: (4b) Describe briefly how Liquid-Liquid extraction can be made economical and also environmentally f...

A: Introduction Liquid–liquid extraction (LLE), also known as solvent extraction is a method to separat...

Q: 10. the hardness test on the attachment picture is

A:

Q: The roasting of pyrites analyzing 85% FeS2 and 15% gangue utilizes 40% excess air (FeS2 to SO2) supp...

A: