olve and show your solution completely. Make sure your answers are in 4 decimals places. What capacitance must be placed in series with an inductance of 0.05 henry so that at 100 Hz, the impedance becomes equal to the ohmic resistance?

olve and show your solution completely. Make sure your answers are in 4 decimals places. What capacitance must be placed in series with an inductance of 0.05 henry so that at 100 Hz, the impedance becomes equal to the ohmic resistance?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Related questions

Q: Use the following circuit to answer the questions and pick one of the following answers. (a)…

A: Solution (a) To calculate steady state current i flowing thorough the indcutor and voltage across…

Q: , if two capacitances of the same value are present in the circuit, the equivalent capacitancecan be…

Q: In the given figure, what will happen to the impedance of the circuit if the inductor is replaced…

Q: Five capacitors, C1 = 3 pF, C2 = 7 pF, C3 = 2 pF, C4 = 4 pF, and C5 = 12 pF, are connected as shown…

Q: Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 10 ohms R2 = 93…

A: Given, Following resistances and capacitors in series, Resistor, R1 = 10 ohms Resistor, R2 = 93 ohms…

Q: Develop relation for unknown capacitance Cx and Unknown Resistance Rx for the AC Bridge circuit…

Q: A 200-volt electromotive force is applied to an RC-series circuit in which the resistance is 1000…

A: Let V is the supply voltage connected across the series RC circuit with R=1000 Ω and C=5 μF. The…

Q: Find the total capacitance CT for the given circuit below using the given values of C116 µF, C296…

Q: A 200-volt electromotive force is applied to an RC-series circuit in which the resistance is 1000…

A: It is given that: E(t)=200 VR=1000 ΩC=5×10-6 Fi(0)=0.2 A

Q: A 250-V circuit, consisting of a resistor, an inductor and a capacitor in series, resonates at 50…

Q: In an L-R-C series circuit, the source has a voltage amplitude of 121 V , R = 75.0 Ω , and the…

A: VS=121 VR=75 ΩXC=475 ΩVC=358 V (A). Relation between voltage and current across capacitor,…

Q: I have a series circuit with a source of 50V, resistor 400 ohms, capacitor Xc=120 ohms, and a 60 Hz.…

A: If f is the frequency of the input AC signal, then the reactance of the capacitor of capacitance C…

Q: Q2 Solve either A or B: (A) The voltage across a 5-mF capaciter is showm. Determine the current…

Q: Acapacitor witha capacitance is nitaly charged to apatential difference and thenconnected in…

A: Two capacitor with unequal capacitance added in parallel so For parallel combination voltage…

Q: Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 6 ohms R2 = 50…

Q: A 1-H inductor is connected in series with a 6-ohm resistor. If the connection is energized from a…

A: As current through long time indicates that time "t" tends to infinity

Q: 01: A (-|100 uC) charge is placed at the origin. A(-50 uC) charge is placed at x = 2m and a (+ 200…

A: The formula for Force between two charges is given by, F=kq1q2r2 where q1 and q2 are the charges, r…

Q: For a given series RC circuit with resistance R= 50 ohm and capacitance C= 1.5uF connected to an ac…

A: In this question , we have to find out magnitude of current in given series RC circuit...

Q: 7. Find the voltages across the following components (a, b and c). Both Capacitors are initially…

Q: Develop relation for unknown capacitance Cx and Unknown Resistance Rx for the AC Bridge circuit…

A: Fig: Given AC bridge circuit Assume that supply frequency is ω rad/sec

Q: In the figure a 17 V battery is connected across capacitors of capacitances C1 = C6 = 5.0 µF and C3…

A: given

Q: am trouble understanding this circuit. Here, R= 25.0 ohms, L=30.0 mH and C=12.0µF. Additionally the…

A: The solution can be achieved as follows.

Q: Q.1: An RC circuit with a 110.0 V power source is connected to a fluorescent lamp as shown in the…

A: VS=110 VVL=75 Vt=0.65 secR=3 MΩ Using the expression, V0t=VS1-e-tτ →eq. 1 substituting the given…

Q: 7. Suppose we have a RC circuit with an alternating voltage V(t) = V_{m} * cos(5t) If the initial…

A: Given data : Resistance, R=8 ΩCapacitance, C= 2F Initial Voltage of capacitor V= 4V

Q: Develop relation for unknown capacitance Cx and Unknown Resistance Rx for the AC Bridge circuit…

Q: A- Find the charge on the capacitor at t = 30 B- Find the voltage on the capacitor at t = 50 C-…

Q: Basic Electrical Engineering: Inductance and Capacitance You are an electrician working in an…

A: The AC capacitors are polarity-independent and non-polarized. As a result, an AC capacitor may be…

Q: write the Nodal equations; b.) solve for V1 (left of the inductor) and V2 ( right of the inductor)…

Q: Assume that you are constructing a certain ac circuit on bread board during your lab session. An…

A: Given circuit is R - L series circuit. Given values are =

Q: Find the equivalent capacitance Ceq seen by the terminals A and B in Figure A1 as a function of C…

A: The solution is

Q: You are given the below RLC circuit, answer the following questions and show the steps in details…

A: Given circuit is =

Q: What is the equivalent capacitance of the following circuit?

A: If two capacitors C1 and C2 are connected in series than equivalent capacitance is( C1×C2) /(C1+C2…

Q: e(t) A R2 R3 Ri B

Q: The current in the circuit in the following figure is known to be -2000t i = B1e The capacitor has a…

A: From the question the given data is as follows: i=B1e-2000tcos1500t+B2e-2000t sin1500t t≥0Voltage…

Q: An RC circuit has an emf of 5 V, a resistance of 10 ohms, a capacitance of 10 – 2 F, and initially a…

A: Given, R=10 Ωapplied EMF=5 VCapacitance =(C)= 2 FInitial charge on the capacitor=(Q)= 5 CThe voltage…

Q: Given the following Resistances and Capacitors in Series and Voltage Source: R1 = 1 ohms R2 = 53…

A: Given, the Resistances & Capacitances as R1 = 1 ohms, R2 = 53 ohms, C1 = 10 Farad, C2 = 36 Farad…

Q: A circuit supplied by 230V, 50HZ, is shown in Figure B5 below, is used to find the unknown value of…

A: The circuit given in the question is a ac bridge circuit excited by 230V, 50Hz supply and the value…

Q: Design a single circuit element containing one inductor, one capacitor and one resistor with…

Q: E=100 olan bir emk k bağlanmıştır. Sığanın y 34 - büyüklüğü (µC birimind O A) 168 O B) 172 C) 144 O…

Q: A 100V electromotive force is applied to an RC-series circuit in which the resistance is 200ohms and…

Q: C2 luf Ci 4uF C3 3uF P C4 6uF C6 8uF C5 2uF

Q: The circuit contains two capacitors in series and two resistors in parallel with each other…

Q: What is the total capacitance of capacitors connected in series? A. The total capacitance is the…

A: Option : C ( answer )

Q: C2 6. Figure shows a series resistance-capacitance bridge to R1 measure the capacitor, C3 and its…

Q: (b) Find the equivalent inductance of the circuit in Figure Q3(b). 8mH 6mH a 5mH 12mH 8mH 4mH 6mH…

A: In this question we will turn equivalent inductance across point ab...

Q: For the circuit below with switch U1 closing at time t=0 and the initial current in inductor L1…

Q: What is the amplitude of the current I?

Q: 5- Find circuit. the values 20K Ind when switch is in positia た= When switch isin position 2. Assume…

Q: Develop relation for unknown capacitance Cx and Unknown Resistance Rx for the AC Bridge circuit…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

GENERAL RLC CIRCUITS:

Solve and show your solution completely. Make sure your answers are in 4 decimals places.

What capacitance must be placed in series with an inductance of 0.05 henry so that at 100 Hz,
the impedance becomes equal to the ohmic resistance?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then what is the capacitance in micro Farads? Answer in micro Farads.
A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
4. A RC series circuit is composed of a resistor of resistance 50 ohms and a capacitor of capacitance 100µF. It is suddenly disconnected from a source voltage of 12V. Determine the time it takes for the voltage across each element is equal and determine the rate of change in the current at this time.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A 250-V circuit, consisting of a resistor, an inductor and a capacitor in series, resonates at 50 Hz. Thecurrent is then 1A and the p.d. across the capacitor is 500 V. Calculate (i) the resistance (ii) theinductance and (iii) the capacitance Answer:
Problem Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage source.