The following data represent individual observations on molecular weight taken hourly from a chemical process. Observation Number X 1 2 3 4 5 6 7 8 9 10 1045 1055 1037 1064 1095 1008 1050 1087 1125 1146 Observation Number 11 12 13 14 15 16 17 18 19 20 x 1139 1169 1151 1128 1238 1125 1163 1188 1146 1167 The target value of molecular weight is 1050 and the process standard deviation is thought to be abouto= 25. Set up a EWMA control chart with λ = 0.1 and L=2.7.

The measurements of suspended solid material concentration in water samples is illustrated in the figure below. Determine approximately the IQR value of the data.

n. ln. N Ciectical Cnyineers GToup as Cv = 40.32 % The following data represent the results obtained from the specific gravity (S.G.) test performed ina soil laboratory including * ?for sand samples. Find the mode Number of Specific Gravity 2.30-2.39 Samples 2.40-2.49 2.50-2.59 4 6. 2.60-2.69 12 2.70-2.79 14 2.80-2.89 2 3.35-3.40 2.10-2.15 2.20-2.25 2.70-2.75 2.80-2.85 2.30-2.35 2,60-2.65 2.40-2,45 2.50-2.55 2.90-2.95 ارفع اجابتك بشكل ملف wdf او صورة 1O 0O 10 O O O O O

A photoconductor film is manufactured at a nominal thickness of 25 mils. The product engineer wishes to increase the mean speed of the film, and believes that this can be achieved by reducing the thickness of the film to 20 mils. Eight samples of each film thickness are manufactured in a pilot production process, and the film speed (in microjoules per square inch) is measured. For the 25-mil film, the sample data result is = 1.13 and 81 = 0.11, while for the 20-mil film, the data yield = 1.08 and 82 = 0.09. Note that an increase in film speed wwould lovwer the value of the observation in microjoules per square inch. (a) Do the data support the claim that reducing the film thickness increases the mean speed of the film? Use a = 0.10 and assume that the two population variances are equal and the underlying population of film speed is normally distributed. What is the P-value for this test? Round your answer to three decimal places (e.g. 98.765). The data v the claim that reducing the…

A photoconductor film is manufactured at a nominal thickness of 25 mils. The product engineer wishes to increase the mean speed of the film, and believes that this can be achieved by reducing the thickness of the film to 20 mils. Eight samples of each film thickness are manufactured in a pilot production process, and the film speed (in microjoules per square inch) is measured. For the 25-mil film, the sample data result is = 1.15 and 81 = 0.11, while for the 20-mil film, the data yield 2 = 1.06 and 82 = 0.09. Note that an increase in film speed vould lower the value of the observation in microjoules per square inch. (a) Do the data support the claim that reducing the film thickness increases the mean speed of the film? Use a = 0.10 and assume that the two population variances are equal and the underlying population of film speed is normally distributed. What is the P-value for this test? Round your answer to three decimal places (e.g. 98.765). The data the claim that reducing the film…

Trace metals in drinking water affect the flavor and an unusually high concentration can pose a health hazard. Ten pairs of data were taken measuring zinc concentration in bottom water and surface water. The raw data provided in table below. Does the data suggest that the true average concentration in the bottom water exceeds that of surface water? Use ?=0.01.

Which EWMA chart below will yield ARL performance most close to that of cusum chart with k=1/2 and h=5?   a. L=2.814, lamda=0.10 b. L=2.615, lamda=0.05 c. L=2.998, lamda=0.25 d. L=3.054, lamda=0.40 e. L=2.962, lamda=0.20

= The table available below shows the costs per mile (in cents) for a sample of automobiles. At α = 0.01, can you conclude that at least one mean cost per mile is different from the others? Click on the icon to view the data table. Let μss, HMS, HLS, Hsuv and μMy represent the mean costs per mile for small sedans, medium sedans, large sedans, SUV 4WDs, and minivans respectively. What are the hypotheses for this test? A. Ho: Hss HMS PLS SUV HMV H₂: Not all the means are equal. B. Ho: Hss HMS = μLS="SUV HMV Ha: Hss HMS HLS #μSUV HMV C. Ho: Not all the means are equal. Ha: ss = μms = μLS = μSUV="MV D. Ho: Hss #HMS # μLS #HSUV # HMV Ha: Hss HMS = μLS="SUV =HMV What is the test statistic? FSTAT= 32.33 (Round to two decimal places as needed.) What is the P-value? P-value= (Round to three decimal places as needed.)

Samples are collected from the River X and pH values are observed. 9 different pH values are listed in table 3. Table 3 Concentrations 4.2 Draw box plot and find a. Bowley's coefficient of skewness b. Karl Pearson's coefficient of skewness c. Third moment 3.8 6.0 3.5 8.1 4.9 4.1 3.2 4.0

The variable X, is the carbon monoxide concentration in air, and ten measurements are obtained as follows: 10.25, 10.37, 10.66, 10.47, 10.56, 10.22, 10.44, 10.38, 10.63, 10.40 mg/m3 . (i) Test whether the mean concentration of carbon monoxide in air is 10.00 mg/m3 . (ii) Calculate the power of the above test if the mean concentration of carbon monoxide in the alternative hypothesis is assumed to be 10.75mg/m3 .