Ο I 12Ω 6Ω 6Ω 2A G 6Ω iļ {24Ω a b RL

Q: 4. If physical aperture of antenna is 0.02m2 and aperture efficiency is 0.5, then what is the value…

A:

Q: Qs: An ordinary end-fire array of 10 isotropic elements with the spacing between the elements i…

A: (a) Progressive Phase Excitation: In an end-fire array, progressive phase excitation means that each…

Q: Find the simulation diagram and the A, B, C, and D matrices for the analog systems: a) y(t) + 2ÿ(t)-…

A: The differential equation representation of two analog systems is given as:a) b) To: draw simulation…

Q: 2. Find the correlation between the two waveforms shown below analytically.

A: Given:

Q: = For the circuit shown below, given Vo 10V, Io = 1A, C = 10μF, L = 100mH, and R = 500, find the…

A: The circuit diagram is given by,Here,

Q: Problem 3: Part (a)  Calculate the impedance of the capacitor, in ohms. XC = ______ Part (c)…

A: The impedance of a capacitor can be calculated using the following formula:where:Xc is the impedance…

Q: the: i-gain K ii-G(s) The Bode plot of uncompensated and compensated control system is shown in…

A: The Bode plot of the system isFrom the bode plot,Initial phase of the phase plot is -90,,Also, From…

Q: alculate the power in the element below. The current through the element I= 0.56 A, and the oltage…

A:

Q: B-Twenty speech signal each bandlimited to 4 kHz are FDM/SSB multiplexed, then RF modulated by a…

A: Given:Twenty speech signals band limited to 4 KHz are FDM/SSB multiplexed. Multiplexed signal is…

Q: A 25-MVA three-phase 13.8-kV, 2 pole 60 Hz synchronous generator was tested by the open-circuit…

A: The given information about a , star connected synchronous generator is,Rated terminal voltage kV…

Q: According to the nec table 250.55 what would the deman load be for two ranges one 14 kw and one 16…

A: According to the NEC Table 220.55, the range of demand load is provided up to the 12 kW range. For…

Q: Prove the following Boolean identity. ABC + ABC + ABC + ABC + ABC = AB + B(A + C)

A: Given equation is written below:

Q: Construct a Common Base Amplifier Circuit with a Vin of 10mV with a Voltage Gain of 10+ and Current…

A: The common base amplifier circuit isVoltage gain

Q: In the circuit below, given R1 = R2 = 18 ohms, R3 = 10 ohms, and L = 1.7 H. Determine the current at…

A:

Q: The data in Table 1 corresponds to input and output waveform amplitudes and filter gains at five…

A: The data for the input and output waveform amplitudes for the low pass filter is given in the…

Q: Find the natural frequency for Ve for the following circuit given the following parameters. Solve…

A: R1 = 4 ohmR2 = 9 ohmR3 = 10 ohmC =  1 mF = 1 * 10-3 FL = 3mH = 3 * 10-3 HWe need to find the…

Q: V₁0- C₁ F 10 μF RB 8.2 ΚΩ RB2 4.7 ΚΩ ĐF C₁=5 µF RB3 3.3 ΚΩ , Vcc= 22 V RE 1.1 ΚΩ Figure 2. Rc , 2.2…

A:

Q: Question 2 Find the equivalent resistance RAB for the circuit shown in Figure 2. RAB B 100 60 10 10…

A: The given circuit isWe need to find the equivalent resistance RAB.

Q: The voltage from A to N in a balanced three phase circuit is 240 ∠-30° V. If the phase sequence is…

A:

Q: If a 100 Hz sinusoidal signal is sampled at the rates of 140 Hz, 90 Hz, and 30 Hz, then the aliased…

A: Given information is shown below:

Q: Assume a digitization of a unipolar signal that can change between 0 to 9V volts into 4 bit digital…

A: We need to find out resolution and number of level for given ADC .

Q: Your Answer: 6.00ΩΣ 3.00 A Answer &₁ #H x10 5.00A In the circuit shown in the figure, find the…

A: The circuit diagram,

Q: A sinusoidal voltage has a peak value of 340 V. Calculate its mean and r.m.s. values, correct to 3…

A: Given information is shown below:

Q: Which of the following shows the block diagram form of 3x+5x+4x=f(1) ? F(s) F(s) (c) O. Ob 1/3 1/3 5…

A: We need to select correct option for given equation .

Q: Sketch the Nyquist plots of the following loop transfer functions and determine whether the system…

A:

Q: At t = 0, the switch opens. Determine the quantities given in the following table. a C O 4 Ω ww 40 V…

A:

Q: Create a decade counter using Toggle flip-flops. The sequential circuit should contain four…

A: The decade counter needs to be designed with the help of T flip flop and the transition from 9 to 0…

Q: M [dB] 26 dB 20 dB 10 dB 6 dB 0 0.1 1 100 1000 @ (rad/s)

A: Given Data:A Bode magnitude plot of a system.To Find:The transfer function.

Q: /Sketch each of the following waveforms:- 1- i(t)= 2u (t-2)-(t-2) +r(t-4) 2- v(t) = u(t-2) + u(t+2)

A: In this question, we need to sketch the given waveform.we know u(t) is unit step function r(t) is…

Q: Determine the value of the current ix in the given circuit by using the Mesh Current Method 20 12 V…

A: We need to find out current for given circuit by using of mesh current method.

Q: 10- The switch has been open for a long time for t 0.

A: For the given RC circuit the expression for voltage across the capacitor and output voltage needs to…

Q: 2. For the following circuit: a. Determine the transfer function H(jo) (Show all your work). b.…

A: Given circuit We need to calculatea. Transfer function H(j)b. Sketch magnitude plot of  c. Centre…

Q: Find the value of current I in the given circuit?

A: Given circuit is shown below:

Q: consider the following continuous time signals given as x(t) = e¹²¹¹u (t) and h(t) = u[t − 2] I.…

A: Given Data:The continuous-time signals of,Input Impulse response To Find:Sketch of the…

Q: 9- Address 172.16.1.1 is belong to Class..... A- C B-A D-B E-E 10-How many subnets and how many…

A: According to guideline solving only one question at a timeAddress 172.16.1.1 is belong to in which…

Q: + 6 ΚΩ ww 12V 12 ΚΩ www Ix 4 ΚΩ ww 2 mA + 24V Determine the I、 using Thevenin's Theorem.

A: The circuit diagram,

Q: 9.1 Determine the resonant frequency of the circuit shown in Fig. P9.1, given that R = 100 S2, L = 5…

A:

Q: The system shown in the image is : * y[n] = Linear Non linear Both = None of the mentioned The…

A: We need to check the linearity property of the system: We need to check the stability of the system:…

Q: Find To + Vx me lkn 12v Ik n 32kr кл Io 2 Vx

A: The circuit diagram,

Q: For the single - node pair circuit below i1 = 1.5 A and 12 = -9.5 A. Find (a) i (b) iy; (c) i D (a)…

A: I1 = 1.5 A, I2 = -9.5 A

Q: Find Rth? (Assume Vth 3V) Hint: find isc, then calculate Rth bx +1 ww 20 6V O a. R-10 1.5 lx O b.…

A: Given circuit,Thevenin's voltage Vth = 3 volts.Asked to calculate the Thevenin's resistance Rth?

Q: QUESTION 6 ADPCM is an improvement over DPCM in that it can vary the size of quantization steps…

A: Given:Statements about DPCM and ADPCM.Required:We need to tell which statements are True and which…

Q: Please solve

A: Td=20 msT = 20 ms

Q: 11. Calculate the maximum power transfer (in mW) possible in the following circuit: 12 V 2.2kQ www…

A: Given:

Q: 4. A 3-phase, 6-pole, 50 Hz induction motor takes 60 A at full-load speed of 940 r.p.m. and develops…

A:

Q: Use Gauss's Divergence Theorem to calculate the flux integral f(x, y, z). ds where S is the surface…

A: We need to find out the given integration by using of divergence theorem.

Q: Use Thevenin Thereom

A: The circuit isWe need to find the Thevenin's equivalent circuit across the terminals 'a' and 'b.

Q: For a closed loop system, the transfer function is 00 02 02 O ∞ 2 X(s) 3²+75 - What is the steady…

A:

Q: 2. For the following circuit: a. Determine the transfer function H(jo) (Show all your work). b.…

A:

Q: Calculate the voltage v1. Use the values, a = 2 2, b = 8 2, c = 102 and d = 2 22. R₁ = a kn + V₁…

A: