O 3,302.641 m O 5,173.646 m O 4,234.492 m O 1,935.824 m O 2,497.952 m

Q: 5kN/m 21 5m 20kN 2m I + 2m 3kN I 3m D

A: To find the reactions at the supports and to draw the Moment diagrams.

Q: All of the following are true except for? O a. Primary data is data gathered for research from the…

A: Part A=  Primary data is the raw data gathered by researcher himself. Secondary data is the data…

Q: 22) It is required to measure the distance from A to C which was obstructed by a building (see the…

A:

Q: choose the correct answer

A: Wrong about elastic material

Q: Linear Regression u

A: Given: Building Number Number of Employees (X) Vehicle Trips (Y) 1 624 397 2 924 642 3 1260…

Q: The correct answers are: 1) 480.18 2) 28.92 Please help with the calculation of how to get these…

A: Torque (T) = 6.3 kN-m or 6.3 x 106 NmmModulus of rigidity = 77 GPa or 77000 MPaLength = 3 m or 3000…

Q: Calculations are not right.  incorrect forward pass and backward pass.  there are incorrect numbers.…

A: PROBLEM 1:PROBLEM 2: PART 1 AND PART 2

Q: Talked with the professor and need look up the data for Anchorage, Alaska using NOA. Also, I found…

A: Designing geography manages the investigation of the construction of the earth according to the…

Q: Q2 : A: Find the standard deviation and variance of the following data classes 10- 13- 16- 19-22…

A:

Q: Assuming EI constant is Find the • Slope at A • Displacement at C 2 Using double integration method

A:

Q: a) level of significance = 0.125, 0.24, 0.31 b) confidence level = 95%, 77%, 98%

A:

Q: Determine the 85th percentile speed for each of the following frequency di Speed (kph) 25 30 35 40…

A: Given dataspeed and frequency of vehiclesfind 85 percentile speed

Q: SITUATION 1. In an examination, the marks are normally distributed with mean of 60.7 and standard…

A: Given  μ=60.7σ=12.3 z=x-μσ=40-60.712.3=-1.68   From the distribution table  PrX<40 =Prz<-1.68…

Q: ADJUSTED CORR INT. ANGLE OBSERVED BEARINGS COMPUTED STA INT. ANGLE LINE LENGTH FORWARD BACK AB BC CD…

A: Given Closed Traverse with fore and back bearings.   To Determine. Interior Angles of the stations.…

Q: E D А B P T

A: Static friction is contact between at least two strong masses that are not moving comparative with…

Q: 1) Determine the Centroid of the Shaded Area, Tabulate your answers and solution. Y 400 mm 300 mm r=…

A:

Q: PERT Calculations yield a project length of 45 weeks with a variance of 12.25. The project is…

A: Given data - Variance = 12.25 TE = 45 weeks Probability of completion = 90% Find out - Calculate the…

Q: Calculations are not right.  incorrect forward pass and backward pass.  there are incorrect numbers.…

A: Detailed explanation:(First Image)1. Forward PassThis calculates the earliest start (ES) and finish…

Q: Write true if the statement is correct. if the statement is wrong, Write the word or phrase that…

A:

Q: What does the Janbu method assumes?

A: Janbu's tangent modulus method: It is a convenient method that explains settlement phenomena from…

Q: percentile speed for each of the following frequency distribution table.

A: 85th percentile speedDefinition: It is defined as the speed at or below which 85 percent vehicles…

Q: Determine the missing storm precipitation of station 'D' given in the following table: Station A. B…

A: Given: The storm precipitation is shown as, Station A B C D F G Storm…

Q: Q3/Do as required depending on function 1 and function 2. 1. Make an offer. 2. Make a sentence of…

A: This is mixed question

Q: PROBLEM 2: The L-shaped retaining wall shown retains soil on the right side and water on the left…

A:

Q: Determine the missing storm precipitation of station 'D' given in the following table: Station Storm…

A:

Q: Part 1: Some Discrete Probability Distributions 4.2 Discrete Uniform Distribution 4.3 Binomial…

A: in this question , 3 examples is asked about probability

Q: The link and node network is representative of the road and street system. Determine the shortest…

A: The given node and link diagram is as below. Shortest path is the time wise shortest path which…

Q: Determine the distance to the centroid of the area.

A:

Q: Please do the same question again with explanation and atleast show how the data in table is…

A: Given: Level data Required  Explanation of table data given by previous expert.

Q: Write it purpose of finding rth moment, moment generating function,incomplete moments and…

A: It is asked to Write the purpose of finding rth moment, moment generating function, incomplete…

Q: Which of the following statements is true regarding a frequency distribution table?

A: The frequency distribution table is one of the most basic tool used for displaying descriptive…

Q: For the blue shaded area shown in the image below, if dimension a = 1.7 m, determine its area moment…

A:

Q: Determine the moments of inertia Ix and Iy of the area shown about vertical and horizontal axes…

A:

Q: Show a detailed solution in solving for the sum of the square of variance of the distance…

A: A probability is generally a number that reflects the chance that a particular event is going to…

Q: Consider the area shown in (Figure 1). Suppose that a = 2.89 ft, h = 5.29 ft. Figure 16 ft _y = (4 —…

A:

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.