Directly determine the optimum alum dosage (in mg/L) by examining the following jar test results.Dose (L)NTU0.01240.02130.030.040.050.06Q ZoomB40.00A0.0350.000.05 Dose (g/L)NTU0.01240.02130.030.04ITM U30.050.069,

dosage(g/lt) NTU 0.01 24 0.02 13 0.03 9 0.04 3 0.05 2 0.06 3

Answered: NTU Dose (L) Directly determine the…

NTU Dose (L) Directly determine the optimum alum dosage (in mg/L) by examining the following jar test results. 0.01 24 0.02 13 0.03 0.04 0.05 0.06 Q Zoom

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

You made an error and changed the concentration of your NaOH from 0.100M to 1.00M for the potentiometric titration of acetic acid. Beyond this, you followed the rest of the procedure properly. Your acetic acid's buffer capacity will (increase, decrease, not be affected) because
During construction of the surface layer of asphalt pavement, two samples were taken every day to measure the asphalt content in the mix to ensure that it is within the specification limits. The target value was set at 5.5% with a tolerance of ±0.4%. The asphalt content data shown in Table P1.41 were collected: a. Calculate the mean, standard deviation, and the coefficient of variation of the data. b. Using a spreadsheet program, create a control chart for these data show- ing the target value and the upper and lower specification limits. Are the asphalt content data within the specification limits? Comment on any trend and possible reasons. TABLE P1.41 Date Asphalt Content, % Date Asphalt Content, % Oct. 15 Oct. 15 Oct. 16 Oct. 16 Oct. 17 Oct. 17 Oct. 18 Oct. 20 Oct. 20 Oct. 21 Oct. 21 Oct. 22 5.7 5.3 5.8 5.6 5.3 5.8 5.4 5.1 5.7 5.8 5.7 Oct. 22 5.9 5.6 Oct. 23 5.1 Oct. 18 5.8 Oct. 23 6.2 Oct. 19 5.4 Oct. 24 5.2 Oct. 19 5.5 Oct. 24 4.8
What is the effective fiber diameter of a membrane filter with a pore size of0.45 * 10^-6? The solidity is 0.20, the thickness is 0.15 mm, and the pressure dropis 1 cm Hg at U0 = 0.015 m/s
4-9 fast solution plz
11-7. A water contains 200 mg/L Ca, 75 mg/L Mg, 180 mg/L HCO3, and 150 mg/L CO₂- all expressed as CaCO3. Determine the chemical dosages required to soften this water as much as possible without removing magnesium. What will the final hardness be? 1-8. If the water of P7 is to be softened to a final hardness of 85 mg/L as CaCO, and is not to contain more than 25 mg/L. Mg as CaCO3, find the required chemical dosages. 1-9. Design a cation-exchange process which will produce a water meeting the criteria of PT-8. Assuming the salt must be provided in an excess of 100 percent, how much salt would be used per year in a plant with a capacity of 5000 m³/day? Solve 11-8 & 11-7 The manufacturer recom-
I need the solution quickly..please In 10 minutes
In determination of Acidity experiment, If the volume of 0.02N NaOH when use Methyl Orange (M.O) is 0.8 mL and 7.8 mL when use Phenolphthalein (Ph.Ph), the volume of sample is 25mL and the EW for CaCO3 is 50. The Mineral Acidity as mg (CaCO3)/L is
Detail explainatory solution required
The following test results (Table Ql-2) were obtained from a raw water sample. All of the tests were performed using a sample volume of 50 mL. Table Q1-2 Weight (g) Mass of residue after drying at 105 ỏC Mass of residue after ignition at 550 ¿C Mass of residue on Whatman GF/C filter paper after drying at 0.7148 0.3818 0.3571 105 'C Mass of residue on Whatman GF/C filter paper after ignition at 550 'C 0.1418 Calculate the concentration (mg/L) of : (i) total solids. (ii) total volatile solids. (iii) total suspended solids. (iv) total dissolved solids.
5. Determine the effective size and uniformity coefficient of the filter media of which grain size distribution curve is given below. Do you prefer using this media? Why? % passing by weight 100% 90% 80% 70% 60% 50% 40% 30% 20% 10% 0% 0.01 0.1 1 Grain diameter (mm) 10
If the concrete temperature is 7 °C, how long would it take for the concrete sample to reach an age equivalent to 7 days curing at 20 °C? Apparent activation energy of the mix is 40 kj/mol and the gas constant is 8.314 j/mol-ºK. O a. 7 days O b. 15 days O c. 25 days d. 10 days O e. 3.3 days
(a) (ii) Following chemical species were reported for water sample from a well. Concentration (milli equivalent)/L 15 15 05 30 12 18 8.8 Species Chloride (CL) Sulphate (SO2-) Carbonate (CO2) Bicarbonte (HCO3) Calcium (Ca²+) Magnesium (Mg2+) pH Find (i) The total hardness (in mg/L) as CaCO3 (ii) Alkalinity present in the water (in mg/L) as CaCO3.