motion warnings on the road. They are highly visible horizontal lines that produce a hu sound and amply bumpy ride to the motorist when ran over. bumpers diagonal markings

Q: Compute the x and y coordinates of the centroid of the dark shaded area.

A: The given area is divided into 4 sections as follows:

Q: Line Length AB 40 BC 46 De CD 33 DE 42 EA 39 ration with complete bearings and lengths D E B

A: solution  initially compute the whole circle bearings  whole circle bearings    AB=69°96'BC…

Q: x5 – 1024 - find lim x→4 x – 4 O 1100 O 1300 O none O 1280

A: Divide x5-1024 by x-4 ,as x=4 is a solution forx5-1024 Now apply limit for remaining part

Q: Bearing Angle Traverse Given the tabulated measurement of the closed traverse as shown. Determine…

A: Introduction- Leveling is a discipline of engineering that determines the location of an item on the…

Q: A section line AB appears to be 10.16 cm on a photograph for which the focal length is 16 cm. The…

A: Length of a line on a map = 2.54 cm Scale = 1/50000 Actual length on a ground = 50000 * 2.54 cm…

Q: What is the total length of extra bars at the midspan as shown below, 03.75 07.5 O8.5 O NONE OF THE…

A: length of extra bar at mid span  l=0.5L1 = 0.5×7.5l= 3.75m

Q: a. b. c. 120° Az 315° Az 245° Az

A: a120°Az is in 2nd coordinate:Bearing =180-120=60°so,Bearing =S 60 E

Q: Given the radius distance (R) of a horizontal curve = 950.00' Delta (A) = 14°-00'-00" %3D What is…

A: The given data is: The radius distance (R) of a horizontal curve=950.00' Delta (∆)=140-00'-00"…

Q: Angle Values ACB 50 BAD 20 BCD 30° АВС 50° CAD 60° Find the angle CBD

A: Given , ACB = 50° BAD= 20° BCD= 30° ABC= 50° CAD= 60°

Q: What do you mean by the limit of visibility dv ?

A: The limit of visibility is a term which is used in satellite communication system.

Q: Adjust the given traverse busing the Transit Rule.  Express all values up to 3 decimal places if…

A: Data given: Line Distance Latitude Departure KL 55 18.057 -51.951 LM 48 19.651 43.793 MN 36…

Q: Q#11: Define the following terms: i. Elevation ii. Bench Mark iii. Back Sight iv. Fore Sight v.…

A:

Q: Determine the y-coordinate of the centroid of the shaded area. y 0.25h 68° 68° --x Answer:ỹ = i

A:

Q: Describe the location (or give the name) of the angle that could be considered alternate exterior to…

A: Alternate Exterior angle : Alternate angles are a special type of angle found in geometry.…

Q: Draw the conflict point of four leg intersection with a bridge

A: The conflict points are determined to enhance the safety of the intersection. By knowing the number…

Q: Arc command and its abbreviation is A character is the only command can be used to draw an arc in…

A: It is required to state whether true or false statement.

Q: Section 1 M, = 5 P = 2atm T = Section 2 100 Section 4 150 %3D 50 Section 3 300K

A:

Q: 1. Describe the following commands in AutoCAD and its application:- a) Line. (CLO3:PLOS:C3) b)…

A: Line: This command is used to draw a line to join two points or to draw a reference line etc. Line…

Q: is made of a 5"radius half-circle inscribed in a5" x 10"rectangle beside a 5"x8" triangle determine…

A:

Q: AA County Foad c6o wie) For the rectangular shown, the county road is to be place such that the…

A: Given: The diagram is a rectangle.

Q: Determine the x- and y-coordinates of the centroid of the shaded area. 0.61 al Answer: (X, ỹ) = ( i…

A:

Q: 6) (D² – D – 6)y = 0; x = 0,y = 2,y' = 1 %3D %3D %3D

A: solution given in next step

Q: Determine coordinates of centroid of the following shaded area.

A: A shaded area coordinate system is a way of calculating points in a system area with the correct…

Q: GIVEN THE DATA OF A VERTICAL CURVE BELOW, FIND EE' L = 200 g1 = -1.5% g2 = +2.5%

A:

Q: Determine the x- and y-coordinates of the centroid of the shaded area. Y I Ti 0.34 al TE Answer: (x,…

A:

Q: Determine the x- and y-coordinates of the centroid of the shaded area. Input values only without…

A: A section have been given and it has been asked to determine centroid of the same. Please refer step…

Q: Two circles have radii 3 inches and 8 inches. The distance between their centers is 18 inches. How…

A:

Q: 216 Home Works Find the centrod for the Shaded area. [Q2] :- 120 150 30 90 130 4

A: Given a areas ,we have to find centroid for the given area

Q: Q1. Complete the statements 1 to 10 using the words/phrases given in the following box. Note: one…

A:

Q: Determine the y-coordinate of the centroid of the shaded area. bF-- Ix=y2/b 0.47b b Answer: ỹ = i b…

A:

Q: Compute the elevation of BM6 a.270.17 b.207.71 c. 217.70

A: Given  Elevation of BM5  And f.s and b s of all the stations

Q: Q1: Differentiate between the following pairs in your own words; a. Surveying & Levelling b. Datum &…

A: Comment- As per our policy, we cannot answer multiple questions/subparts,  Since you have asked…

Q: Discuss and plot the difference among urban, rural and hilly cross section of road in detail.

A: There are different cross section of roads such as urban, rural or hilly cross section. The cross…

Q: An instrument is set over point “A" with a 5.45 ft. H.I. A vertical angle of -9°35'17" and a slope…

A:

Q: A ramp has diagonal length of 14 feet and has a height of 3.5 feet. What is the angle of inclination…

A:

Q: Find the intersection points for the system below: y = -2x – 3 x² + y? = 30

A: To determine the intersection points of the given system of line and curves.   Given: Equation of…

Q: Give the functions of each parts of a transit in your own words and understanding. Please do not…

A: A.  TELESCOPE:  A Telescope is an instrument that helps to observe distant objects by the absorption…

Q: Q4/By the DMD method, find the area enclosed by the traverse ABCD Stations X (m) Y(m) A 0 0 B -50.0…

A:

Q: (a) Briefly explain FOUR (4) types of road sight distance that commonly considered during the…

A: Sight distance is the visible distance to the driver of a vehicle on the road at a specified height…

Q: A ramp has diagonal length of 14 feet and has a height of 3.5 feet. What is the angle of inclination…

A: To find angle of inclination

Q: Where did this 101.3 over 76 coming from? Its not on the given. Here is the picture.

A:

Q: bing bearings were taken for a ompass at a place where local attraction is suspected. Line FB BB AB…

A:

Q: 22- Which of the following symbols is a representation of a Manhole in Civil 3D? A) B) M S D) S IM…

A: 22. Option C is correct .

Q: Locate the centroid y of the shaded area.

A: Data Given: Asked: Locate the centroid

Q: Determine the x- and y-coordinates of the centroid of the shaded area. Input values in two (2)…

A: A shaded area is given and it has been asked to determine centroid of the same.Please refer step 2…

Q: Determine the y-coordinate of the centroid of the shaded area shown. 12" H Parabolic. 5" Answer: y =…

A:

Q: Draw the conflict point of three leg intersection with a bridge

A: The geometrical design for the signaled intersection includes both horizontal and vertical…

Q: Determine the x- and y-coordinates of the centroid of the shaded area shown. 3", 3" 5" - 2.00" -…

A:

Photogrammetry

Photogrammetry is a technology of taking measurements of physical objects present in the environment, using photographs. It includes the process of recording and analyzing a three-dimension image in the two-dimension form. Photogrammetry was invented around 150 years ago in 1851 by Aimé Laussedat, he was also known as the father of photogrammetry, but this method was not in use until 50 years after its invention. This method was first used in Germany by Dr. Albrecht Meydenbauer in 1893 who was the director of the Royal Prussian Photogrammetric institute founded by him.