Micropressor 8086when dividing a 1 MB memory into 128KB sections what how many sections are there in total and what is the starting address and end address of 2nd sections and what is end address of 5th sectionhow to find starting address and end address in hexadecimal step by step A)0x7FFFF b)0x80000 c)0xA0000 d)9FFFF

Micropressor 8086when dividing a 1 MB memory into 128KB sections what how many sections are there in total and what is the starting address and end address of 2nd sections and what is end address of 5th sectionhow to find starting address and end address in hexadecimal step by step A)0x7FFFF b)0x80000 c)0xA0000 d)9FFFF

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter11: Operating Systems

Section: Chapter Questions

Problem 26VE

See similar textbooks

Similar questions

Most Intel CPUs use the __________, in which each memory address is represented by two integers.
In the ________, memory addresses consist of a single integer.
A(n) __________ is a storage location implemented in the CPU.
If a microprocessor has a cycle time of 0.5 nanoseconds, what’s the processor clock rate? If the fetch cycle is 40% of the processor cycle time, what memory access speed is required to implement load operations with zero wait states and load operations with two wait states?
physcal addresses are 4s ng 4 Ame dat in a cetain compe, te addresses can be translaled without y TLB entries At most how many ditina vid the address translation peh has 12 vld The Translation Look aside Bulfer (TLB)i sine is kB and the word size iby The memory is word addresible. The pe virtual addresses are 64 bea long d th sine is miss?
Suppose the RAM for a certain computer has 4M words, where each word is 16 bits long. What is the capacity of this memory expressed in bytes? If this RAM is byte addressable, how many bits must an address contain? If this RAM is word addressable, how many bits must an address contain?
Q6: A digital computer has a memory unit with 24 bits per word. The instruction set consists of 110 different operations. All instructions have an operation code part (opcode) and an address part (allowing for only one address). Each instruction is stored in one word of memory. (a) How many bits are needed for the opcode? (b) How many bits are left for the address part of the instruction? (c) What is the maximum allowable size for memory? (d) Can we extend this instruction set by adding new 10 instructions and keeping the same length of opcode part? (e) Determine the type of this instruction set: stack-based ISA or accumulator- based ISA or general purpose registers-based ISA?
x86-64 bit Assembly
Given a memory address, say 12A1H, find the Block number(i) the address belongs. Assume, the size of the Block is 8Bytes. Also find the starting address of the block the address belongs. Find the capacity of RAM. Find the number of addressable locations in RAM. Find the total number of blocks RAM has. Assume RAM is byte addressable.
Consider a memory implemented for 8086 microprocessor Draw the memory block diagram. Determine the values for A0 , /BHE ,address lines(A1..A19) and data lines(D0.. D15) in order to access: A byte at odd address [01FF3H] A byte at even address [01FFCH] A word at even address [01FFEH] A word at odd address [01ABFH]
Given a memory address, say 12A1H, find the Block number(i) the address belongs. Assume, the size of the Block is 8Bytes. Also, find the starting address of the block to which the address belongs. Find the capacity of RAM. Find the number of addressable locations in RAM. Find the total number of blocks RAM has. Assume RAM is byte-addressable.
Sim8085 - A 8085 microprocessor simulator