A machine component is subjected to fluctuating stress that varies from 40 to 100 N/mm?. The corrected endurance limit stress for the machine component is 270 N/mm2. The ultimate tensile strength and yield strength of the material are 600 and 450 N/mm2 respectively. The factor of safety using goodman line is,

A machine component is subjected to fluctuating stress that varies from 40 to 100 N/mm?. The corrected endurance limit stress for the machine component is 270 N/mm2. The ultimate tensile strength and yield strength of the material are 600 and 450 N/mm2 respectively. The factor of safety using goodman line is,

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As an engineer you are asked to choose 1 component from what you studied ( Screw, rolling bearing, Sliding Bearing, key, or shaft). 1. Explain what you know about that component and its types? 2. Make a sketch of the component with the important dimensions required? 3. Explain in detail what information you need to know to design this component?
1. What are the main causes of vibrations in machines?
The tyre of a parked car in a parking lot experiences Select one: O Siding Friction O Rolling Friction Both static and dynamic friction O Static Friction
Give an example of Generalized Hooke’s Law?
As an engineer you are asked to choose 1 component from what you studied ( Screw, rolling bearing, Sliding Bearing, key, or shaft). 1. Explain what you know about that component and its types? 2. Make a sketch of the component with the important dimensions required? 3. Explain in detail what information you need to know to design this component?
2. What is the mechanical advantage of a claw foot hammer having a handle with a length of 45 cm and head length of 10 cm?
Which of the following statement is incorrect? Select one: Friction causes objects to move faster Friction is high for dry surface Friction causes objects to slow down Friction force acts opposite to motion
Choose correct answer: When the cylinder is cushioned at the end of the stroke, how does cushioning affect the piston's force? At the beginning of the stroke, cushioning increases the piston's force. At the beginning of the stroke, cushioning reduces the piston's force. At the end of the stroke, cushioning increases the piston's force. At the end of the stroke, cushioning reduces the piston's force.
4. How we can measure shear modulus?
kinetics of particles-relative motion report
Would the plank and the roller have the same acceleration why or why not?
Q1. The part shown below will be turned in two machining steps. In the first step a length of (50 + 50) = 100 mm will be reduced from Ø100 mm to Ø80 mm and in the second step a length of 50 mm will be reduced from Ø80 mm to Ø60 mm. Calculate the required total machining time T with the following cutting conditions: Cutting speed V=80 m/min, Feed is f=0.8 mm/rev, Depth of cut 3 mm per pass. Ø100 Ø80 Ø60 50 50