Map distance=5 cm Ground distance%3D2 km Determine scale

Q: n. For the reinforced concrete section shown below, determine the nominal shear capacity of concrete...

A: Dear student,  Please find the answer in the below attachments  Thank you 

Q: Solve for the horizontal components of the force at pin B (See the Figure below). 3' 6' 5' 3' A 8' E...

A: To determine the horizontal component of reaction at B.   In order to determine the reaction at pin ...

Q: A footballer kicks a ball on horizontal ground giving it an initial velocity of 35 m/s at an angle o...

A:

Q: a. Find the support reactions b. Draw SFD and find the maximum shear force (magnitude) c. Draw BMD a...

A: Introduction: Share force- The algebraic sum of the vertical forces at any section of a beam to the ...

Q: Simply Supported Beam ABCDE below carries multiple loads as shown. A built-up section made from a T-...

A:

Q: Determine the equivalent state of stress on an element if it is oriented 30° clockwise from the elem...

A: Given data - The element is oriented 30* We have to use stress transformation equation and Tu = 900 ...

Q: A steel rod, circular in cross-section, tapers from 30 mm diameter to 15 mm diameter over a length o...

A: To determine the increase in length of the tapered steel rod.   Diameter at the wider end (D) = 30 m...

Q: PROBLEM 1: Determine the mass of the heaviest uniform bar that can be supported in the position show...

A:

Q: Your team want to measure line AB but there is an obstruction on line. You set up two lines AC and C...

A: To find length of line AB,BD,AD

Q: A simple circular curve has a radius of 300 m and 60° deflection angle. Compute the following: a. it...

A: Given, Radius of the curve= R= 300m, Deflection angle= ∆= 60°         Note :- as per our company gui...

Q: The following bearings taken on a closed compass. Assuming the observed bearing of line AB to be cor...

A: To find out the correct bearing of line CD. 

Q: cantiliver shown in the diagram has a length L1=9 m and subjected to a uniformly distributed load q2...

A:

Q: A man exerts a force F on the handle of the stationary wheelbarrow at A. The weight of the wheelbarr...

A:

Q: half-submerged in a tank of oil with a specific gravity of 0.82. Find the minimum weight of an ancho...

A:

Q: A five-cylinder reciprocating pump haises the water level by 150 m and the theoretical discharge is ...

A:

Q: A saturated compressible clay layer of thickness h is sandwiched between two sand ayers, as shown in...

A: Initial effective stress  is=150-25=125kpaIt is increased to 175kpa ANd further 100kpa is added to i...

Q: (a) Determine the reactions at A and Eif P- 740 N. The reactions are positive if to the right or up,...

A:

Q: 8 KN 15 KN/m 12 KN/m A E 2m 3m 3m 2m Properties of T-Section Br = 180 mm T= 16 mm Tw = 12 mm D = 210...

A:

Q: 2. Determine the reactions in the supports and draw the shear diagram.statb mSTgeib 18odz orlt mi BO...

A:

Q: What is the pH of the solution containing 10-5 M H2SO4? Assume complete dissociation of H2SO4 in wat...

A: To find the pH of the solution 

Q: 4. When the direct and reverse Zenith angles are 146 24'45" and 213 45'34" respectively, what is the...

A:

Q: A curved line in a level surface all points of which are normal to the direction of gravity and equi...

A: To Determine Which of the given term is correct for the definition given.

Q: 6 KNIM 45 KN/m 3m 3.6m

A:

Q: A plate of 150 mm width and 20 mm thick is welded to another plate by fillet weld as shown in the fi...

A:

Q: Discuss briefly the food and hunger situation in the Philippines.

A: Philippines secured  68th rank with plenty of information to generate 2021 GHI rankings in the Globa...

Q: In the assembly shown, sags of s and 1.5 s resulted when the two cylinders were suspended from the r...

A:

Q: During a test of an airplane wing, the straingage readings from a 45° rosette (see figure) are asfol...

A: Given data: ε0=520×10-6ε45=360×10-6ε90=280×10-6

Q: A D В C Hinge 5 m 3 m 8 m

A: Given:- compound beam To find:- indluence lines for the vertical reactions at A,B and C and bending ...

Q: A noise meter located at a distance of 30 m from a point source recorded 74 dB. The reading at a dis...

A:

Q: An open cylindrical tank 3 ft in diameter and 5 ft high is three-fifths full of water. If the tank i...

A:

Q: The mechanism shown is used to lower handicapped persons into a whirlpool tub for therapeutic treatm...

A:

Q: a circular curve is to be constructed with a 225 ft radius and an interior angle of 55 degree. deter...

A:

Q: An experimental device imparts a force of magnitude F = 67 lb to the front edge of the rim at A to s...

A:

Q: A simple beam with a W 10 × 30 wide-flangecross section supports a uniform load of intensityq = 3.0 ...

A: Given data:

Q: A beam segment subjected to internal bending moments at sections A and B is shown along with a sketc...

A:

Q: The porosity (n) of a mass of soil is 46.69 % What is the void ratio, e, expressed as a percentage? ...

A:

Q: A man exerts a force Fon the handle of the stationary wheelbarrow at A. The weight of the wheelbarro...

A: Find force F that must be applied at A

Q: A wastewater treatment plant processes its mixed sludge by employing the gravity thickening followed...

A: Hazen William equation for Head loss due to friction in a pipeline hf=10.67*Q1.852*LC1.852*d4.8704 F...

Q: The data shown were taken from a certain part of road to be constructed Base for fill = 7 m sideslop...

A:

Q: Properties of T-Section Br = 180 mm T= 16 mm Tw = 12 mm D = 210 mm Properties of C-Section Br = 105 ...

A:

Q: e beam is supported by a roller at B and a pin at C and is subjected to the distributed load shown e...

A:

Q: Situation 1| Simply Supported Beam ABCDE below carries multiple loads as shown. A built-up section m...

A:

Q: As a trailer is towed in the forward direction, the force F= 275 lb is applied as shown to the ball ...

A:

Q: Question No.06 A simply supported beam of span 8 m is carrying a uniformly distributed load of 4 kN/...

A:

Q: A pair of forceps used to hold a thin plastic rod firmly is shown in (Figure 1). < 1 of 1 Figure Jaw...

A: The forces at thumb and finger are FT = FF =16.5NThe distance of P from thumb and finger, d1 =8.5cmT...

Q: What is the pH of the solution containing 10-5 M H2SO4? Assume complete dissociation of H2SO4 in wat...

A: Given data,Concentration of H2SO4=10-5To find the ph of the solution

Q: A racing racl ing car has a unisorm accele radion of 6 m/s, what Jiztance will it cover in 12 Seconl...

A: Given data : Uniform acceleration=a a=6 m/s2 Time=t t=12 s Initial velocity=U U=0 m/s  

Q: 625 mm 10 |20 kN/m 500 mm 6 m 100 mm

A:

Q: An experimental device imparts a force of magnitude F = 67 lb to the front edge of the rim at A to s...

A:

Q: A cylindrical piece of steel 80 mm dia and 120 mm long is subjected to an axial compressive force of...

A:

Introduction to Architectural Drafting

Architectural drafting converts vision and ideas into technical drawings and detailed plans for the construction of buildings, such as institutional, residential, and commercial buildings. It helps engineers and architects to outline the working data and details, such as structure type, codes, elements, and kind of materials.