An inverted U-tube manometer is used to measurethe pressure difference between two pipes A andB, as shown in the figure. Pipe A is carrying oilthe pressure difference between two pipes Aand(specific gravity = 0.8) and pipe B is carryingwater. The densities of air and water are 1.16 ka/m³ and 1000 kg/m3, respectively. The pressurekPa.%3Ddifference between pipes A and BisAcceleration due to gravity: g = 10 m/s?Air80 mm200 mmWaterA Oil100 mmB.

Given data, Specific gravity of oil (Soil) =0.8ρoil=0.8×1000=800 kg/m3Density of air (ρair)=1.16…

Answered: m3 and 1000 kg/m³, respectively. The…

Engineering

Mechanical Engineering

m3 and 1000 kg/m³, respectively. The pressure difference between pipes A and Bis kPa.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Barometric pressure is 29.89 in Hg. Convert 100 kPag to psiabs
The longest pipe run for a hot water system is 100 m. If the pressure rise through the pump is 35 kPa, then the pressure drop per one meter in system is إختر أحد الخيارات: Pa/m 233.3 .a O Pa/m 400 .bO Pa/m 250 .c O Pa/m 375 .d O
A 32m high down comar-tank system operates at loobar. If the quality of the stream 0.5 what will be the driving Pressure. Assume S to be 1.4. Hand written plzzz
Convert 8.5 kg to kN/m³
Q1: A vertical conduit is carrying oil (S.g 0.95). A differential mercury manometer is tapped into the conduit at points A and B. Determine (a) the difference in pressure between A and B. (b) the difference head between A and B? Take (specific weight for water =62.4 Ibr/ft³, specific weight for mercury = 847 Ibr/ft³). Dil B 18 in 2 in fr = 3 in Mercury
4. Given the manometer set up, find the pressure difference between m and n in meter of oil and KPa oil (ap. gr=o.om) t.om 075m -13.4
Problem 4 (a) Water from a water reservoir is delivered through a 2-cm pipe to a 200-litre tank as shown in Figure below. The water level (H) is at 2 m above the pipe. Calculate (a) the time it would take to fill the tank and (b) the height difference of the mercury, h in a U-tube manometer. State all assumptions needed. (Non-anonymous questionO) * h H Water Mercury S.G. =13.6 Jet 200-litre Tank
On a trip to the beach (Patm 1 atm or 101.3 kPa), a car runs out of gasoline and it is necessary to siphon gasoline from a Good Samaritan's car. The siphon is a hose with a small diameter and to start the action it is necessary to insert one end into the tank full of gasoline, fill the hose with it through suction and then put the other end in a can that is placed under the tank level. The difference in pressure between point 1 (on the free surface of the gasoline in the tank) and point 2 (at the outlet of the tube) causes the liquid to flow from the highest elevation to the lowest. In this case, point 2 is located 0.75 m below point 1, and point 3 is 2 m above 1. The siphon diameter is 4 mm and friction losses in it must be ruled out. Determine: a) theminimum time to bring 4 L of gasoline from the tank to the can and b) the pressure at point 3. The density of the gasoline is 750 kg / m3.
An unknown gas is flowing through a venturi meter whose diametersas shown. Gage pressures are measured 12.2 psia at the entranceand 11.8 psia at the throat. Take the density to be 0.105 lb/ft3.Determine the following: A) Neglecting friction, the volume flow rate of airB) If the pressure gauge is replaced with a manometer withmercury as its medium (SG=13.6), what will be the height ofthe mercury in inches? Draw the most possible orientationof the manometer and its fluid height.
a cylindrical container tank contains water to a depth of 0.90m. Wjat is the resulting pressure in kPa at the bottom of the tank; it has aconstant velocity. a cylindrical container tank contains water to a depth of 0.90m. Wjat is the resulting pressure in kPa at the bottom of the tank; it it accelerated downwards at 6.14 m/s2