Lume The mass of the block depicted in the image is 1.60 kg. The spring has a spring constant of 76.9 N/m. The coefficient of static friction between the block and the floor is 0.726. Assume that the spring makes no contact with the floor and therefore friction only acts on the block. How far must the block and spring assembly be compressed to just barely overcome the force of static friction acting on the block? Report your result in meters.

Lume The mass of the block depicted in the image is 1.60 kg. The spring has a spring constant of 76.9 N/m. The coefficient of static friction between the block and the floor is 0.726. Assume that the spring makes no contact with the floor and therefore friction only acts on the block. How far must the block and spring assembly be compressed to just barely overcome the force of static friction acting on the block? Report your result in meters.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter15: Oscillations

Section: Chapter Questions

Problem 6CQ: Some people modify cars to be much closer to the ground than when manufactured. Should they install...

See similar textbooks

Similar questions

A pulley-and-cable assembly supports a block W and it requires a force at P for equilibrium. Since block W has a mass of 30kg (g=9.806), calculate the force of the spring CD and the magnitude of force P.
A 2.35-kg uniform bar oflength l = 1.30 m is heldin a horizontal position bythree vertical springs as inFigure P8.83. The two lowersprings are compressed andexert upward forces on thebar of magnitude F1= 6.80 Nand F2 = 9.50 N, respectively.Find (a) the force Fs exertedby the top spring on the bar,and (b) the location x of the upper spring that will keep thebar in equilibrium.
Problem 4: The spring has a spring constant 627 N/m. The box of mass 4.4 kg is released from rest at the top of the ramp as shown. The initial height is 1.9 m, and the angle is 18 degrees. Assume the surfaces are frictionless. Part (a) What is the maximum distance that the spring is compressed in m (when the box comes to a rest)? Grad Dedu m Poter Subr
A spring for industrial use, whose elastic constant is 375N / M and 70 grams, carries a mass of 1kg. What is the elongation of the same product of the force that the mass applies to it?
A 50 kg block moves on a 35º inclined plane with a friction coefficient of 0.17. The body It is attached to a spring whose elastic constant is 1200. N/m. With the above data, resolve the following: -How much does the spring stretch when it comes to its rest state? Express the result in centimeters.
A) the block, starting from rest, slides down the ramp a distance 42 cm before hitting the spring. How far, in cm, is the spring compressed as the block comes to momentary rest?
Given a spring constant of 67 N/m. If the spring is compressed to a distance of 12.4 cm, what is theforce being applied to the spring?
A block with a mass of 4.5 kg is attached to a spring with a spring constant of 970 N/m. it is initially at rest on an inclien plane at an angle of 25 degrees with respect to the horizontal and the coefficent of kinetic friction between the block and the plane is .12/ in the intial position where the spring is compressed by a distance of d = .18m. the mass is at the lowest positiion and the spring is compressed a maximin amount. Take the intial gravtiation potential energy of the block as zero. 1) what is the blocks intitial mechanicial energy? 2) if the spring pushes the block up the incline what distance in meters will the block travel before coming to rest? the spring remains attached to both the box and the fixed wall throughout its motion.
A block of mass 1.5 kg is attached to a horizontal spring that has a force constant 800 N/m as shown in the figure below. The spring is compressed 2.0 cm and is then released from rest. wwwwwww x = 0 (a) A constant friction force of 3.7 N retards the block's motion from the moment it is released. How much is the spring compressed when the speed of the block is a maximum. cm (b) What is the maximum speed? cm/s
To measure the static friction coefficient between a 1.40-kg block and a vertical wall, a spring (k = 770 N/m) is attached to the block, is pushed on the end in a direction perpendicular to the wall until the block does not slip downward (see figure). If the spring is compressed by 0.048 m, what is the coefficient of static friction?
A block of mass m = 4.90 kg slides along a horizontal table with velocity vo = 4.00 m/s. AAt x = 0, it hits a spring with %3D www spring constant k = 40.00 N/m and it also begins to experience a friction force. The coefficient of friction is given by u = 0.300. How far has the spring compressed by the time the block first momentarily comes to rest? Assume the positive direction is to the right. %3D = XV 87 730
A surgeon is using material from a donated heart to repair a patient's damaged aorta and needs to know the elastic characteristics of this aortal material. Tests performed on a 16.0 em strip of the donated aorta reveal that it stretches 3.75 cm when a 1.50 N pull is exerted on it. (a) What is the force constant of this strip of aortal material? (b) If the maximum distance it will be able to stretch when it replaces the aorta in the damaged heart is 1.14 cm, what is the greatest force it will be able to exert there?