liquid pentane with relative density 0.62, 20 °cas shown in the figure at temperature, the geyç pressure is 0.2 atm dollars acast iron (0.2 m odiameter cast iron))it flows through the pipe.Marked as full pipe outputit can be considered as the principal atmospheric pressure at the point at which it is.The total pipe length in the system is 45 m.5 kW in the systemthere is a pump that works with 92% efficiency in its power. Liquidsince the volumetric flow rate of pentane is 0.05 m2 / s, with the tankcalculate the height difference botween the pipe output.Data:* Friction loss at the pump is negligible.GrycAtarkpurmp

Given data as per question The specific gravity of liquid =0.62 Diameter of rod =0.2 m Flow rate =…

Answered: liquid pentane with relative density…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

b) Oil flows through a 30 mm diam eter pipe Then the pipes 16 uplit into two, wher eby the firot Pipe If 10 mm diameter with 0-3 m/r velo(ity and the other pipe is 15 mm diameter with 0-6 mis velocity Cal culate the flowrate and velo city in 30 mm diameter pipe .
The longest pipe run for a hot water system is 100 m. If the pressure rise through the pump is 35 kPa, then the pressure drop per one meter in system is إختر أحد الخيارات: Pa/m 233.3 .a O Pa/m 400 .bO Pa/m 250 .c O Pa/m 375 .d O
Question Liquid of sp.gr and u is in a closed tank with air at pressure measured by a manometer of R reading. It is required to flow this liquid through a piping system connected to a tank as shown in Fig. with a flowrate Q. Is this liquid capable to flow to the end of this system? or it is required a pump? If it required a pump what power must supply to the pump if its efficiency is 1=0.6? Case -1- (Le/d)E (Le/d)v (hr)LEx. (m) R LI po L2 (m) (cm) (mm) 140 sp.gr. Z1 d (poise) (m) 0.032 Case -2- (m) (m) 38 (m) (/min) 190 (kPa) 100.62 0.85 2.5 22 15 0.125 60 200 3.5 (Le/d)e (Le/d)y (hr)LEx. (m) R Z1 LI L2 d Q (I/min) sp-gr. po (poise) (m) (m) (m) (m) (m) (cm) (mm) (kPa) 0.85 0.032 1.5 22 38 15 140 5 0.125 60 200 190 100.62 3.5 Н.Ех. R Air ? Z1 Liquid Hg
Water is contained in both sides of the cylinder system shown below and the valve is closed. If the pressure on the right hand side of the valve is 119.6 kPa, what is the height in tank B, i.e. what is hp 1? Assume that the atmospheric pressure is 100 kPa, the acceleration due to gravity is 9.807 m/s² and the density of water is 1000 kg/m³. A Po B ha,1=1.5 m Water Water hg,1 1.0 m 0.5 m Pval,left Pyal,right A) 1.0 m B) 1.5 m C) 2.0 m D) 2.5 m
Question Liquid of sp.gr and u is in a closed tank with air at pressure measured by a manometer of R reading. It is required to flow this liquid through a piping system connected to a tank as shown in Fig. with a flowrate Q. Is this liquid capable to flow to the end of this system? or it is required a pump? If it required a pump what power must supply to the pump if its efficiency is n=0.6? Case -1- R L1 L2 d. (Le/d)E (Le/d)v po (hf)H.Ex. (m) sp.gr. Z1 Z2 e (poise) (m) (m) (m) (m) (m) (cm) (mm) (1/min) (kPa) 0.85 0.032 2.5 22 38 15 140 0.125 60 200 190 100.62 3.5 Case -2- (Le/d)E (Le/d)y (hf)HEx. (m) L1 L2 Q (/min) po Z2 (m) sp.gr. Z1 e (poise) (m) (m) (m) (m) (cm) (mm) (kPa) 0.85 0.032 1.5 22 38 15 140 5 0.125 60 200 190 100.62 3.5 H.Ex. Air Z2 Liquid L1 Hg
Exercise : The losses per unit length pipeAh/l in turbulent flow through small pipe depend upon Velocity, Diameter, Gravity, Dynamic viscosity and Density. Determine the general from of equation.
dp 1. It shows that the behavior of fluid is A From the equation stated, show the formula for mass flow rate AVp = c. :C.
10.0 m 200 m 2. An old western town has a water tower to deliver water to the residents. Pictured above is the water tower. The water tower is closed but there is a section of air that is atmospheric pressure just above the water. The corsss ectional area at point 2 is 4.75 x 10 m. The cross sectional area fot the water tower is very large. What is the speed of the water coming out of the pipe at point 2? (density of water = kg/m³) 3. On a vacation trip up in Oregon my boys decided to build a 10 kg raft that they made out of driftwood. 1000
Industrial pipes Do the guides allow movement of a pipe only in two directions (in a plane)?
y aer. A Pitot tube is used to measure the air flow rate in a eircular duct 8.5 m I.D. The "riowing air temperature is 65.5°C. The Pitot tube is placed at the center of the duct and the reading R on the manometer is 1.2 cm of water. A static pressure measurement obtained at the Pitot tube position is 2.0 cm of water above atmospheric. Take Cp 0.98,9ter ase press u = 2.03 x 10 Pa.s, if U- Ux ( 1-0.17). Calculate The velocity at the center and the average velocity. The volumetric flow rate of the flowing air in the duct
Q1) Benzene with specifie gravity of 0.8 flows through 200 mm diameter pipe at velocity of 5 m/s. Find: 1. volume flow rate of Benzene. QV 2. Mass flow rate of Benzene. 3. Weight flow rate of Benzene Q2) Water flowing through a jet with velocity of 45 m,/s. Caleulate the value of (0) to be the water reach the hole in the wall 30m 30m
Water is flowing at the rate of 1.676 m/s in a 3.068 inches’ diameter horizontal pipe at apressure p1 of 68.9 kPa. It then passes to a pipe having an inside diameter of 2.067 inch. Thedensity of the water is 998 kg/m3.a) Calculate the new pressure p2 in the 2.067inch pipe. Assume no friction losses.b) If the piping is vertical and the flow is upward, calculate the new pressure p2. The pressure tap for p2 is 0.457 m above the tap for p1.c) Compare and discuss your answers in 2 (a) and 2(b).

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS