Layer No. Thickness, H Soil Parameters e = 0.52, Gs = 2.62 e = 0.56, Gs = 2.65 w = 20%, e = 0.51 1 4.1 m 2.5 m 3 2.6 m Layer 1 Layer 2 Layer 3 O Dry sand O Sand E Clay O Rock If groundwater table is x = 0.25 m above point B (use yw = 9.81 kN/m3), determine: a. The effective stress at point D. b. If the effective stress at point D is lowered by 10 kPa, what is the newelevation (new x) of groundwater table measured from noint B?

Layer No. Thickness, H Soil Parameters e = 0.52, Gs = 2.62 e = 0.56, Gs = 2.65 w = 20%, e = 0.51 1 4.1 m 2.5 m 3 2.6 m Layer 1 Layer 2 Layer 3 O Dry sand O Sand E Clay O Rock If groundwater table is x = 0.25 m above point B (use yw = 9.81 kN/m3), determine: a. The effective stress at point D. b. If the effective stress at point D is lowered by 10 kPa, what is the newelevation (new x) of groundwater table measured from noint B?

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter7: Permeability

Section: Chapter Questions

Problem 7.13P

See similar textbooks

Similar questions

A sand has Gs = 2.66. Calculate the hydraulic gradient that will cause boiling for e = 0.35, 0.45, 0.55, 0.7, and 0.8.
The coefficient of permeability of a sand at a void ratio of 0.62 is 0.03 cm/sec. estimate the coefficient of permeability at a void ratio of 0.48. a. Using Casagrande equation b. Using kozeny - Carman equation.
Avsnitt Stiler 7.16 A layered soil is shown in Figure 7.34. Given that H = 1 m k, = 10 cm/sec H, = I m k, = 2.8 × 10 ? cm/sec. • H, = 2 m k, = 3.5 x 10 cm/sec Estimate the ratio of equivalent permeability, km/kyica) Internaliormal Tilgjengelighet Undeisok や)
uniform weight of 20kN/m³ is distributed on large area. Estimate the consolidation settlement of the clay layer in case : or 1)Pc=134kPa clay Cs-0.1, Cc-0.24 o'c= Pc @²₁ 7m 2)Pc = 100kPa 8m 3M I IVLII [[[[]20/² L T T (M I Silt 8= 17 * = 21 Sand 3)Pc-250kPa clay Sal. (Gise) p / n 2PKN 7 CS= 2-7 You = 35% pc as shown alone sul-r 1670-10)+4= 154 KO
i. A sandstone core sample is saturated 100% with water. Calculate the absolute permeability of the core sample if the water is flowing at 6.21 cubic centimetres per second. The length of the core sample is 14 centimetres and its diameters is 6 centimetres. The pressure differential across the core sample is 15 atmospheric pressure and the water viscosity is 1.2 centipoises. Explain a method of how the permeability of low permeability reservoirs can be ii. improved.
6.5 A site is underlain by about 14 m of hydraulic fill sand with the following properties. Grain size characteristics: Dio <0.074 mm D30 = 0.14 mm Dso = 0.17 mm Do = 0.20 mm Saturated unit weight = 18.8 kN/m² Average uncorrected SPT resistance = 6 blows/ft Average cone tip resistance = 3 MPa The groundwater table is located at a depth of 2m. (a) Estimate the shear wave velocity of the hydraulic fill at a depth of 5 m by as many proce- dures as the available data will support. (b) Shear wave velocity measurements at this site have indicated hydraulic fill shear wave velocities ranging from about 120 m/sec - 200 m/sec at 5 m depth with an average value of about 170 m/sec. Comment on the level of agreement between the estimated shear wave velocities from Part (a) and the measured shear wave velocities.
Q3. A soil in its natural state is partially saturated having a water content of 17.5% and a void ratio of 0.870. Assume Gs = 2.65 and determine: NIVERSI a). b). the degree of saturation. the porosity. the moist unit weight. the dry unit weight. the saturated unit weight. ials you d for this co aterials to r professor. the mass of water required to saturate 10 m³ of dry soil. TÉ D'OTTAWA - CON LE DROIT D'AUTE MATERIAL IVERSITY OF OTTAWA - C
a deposit of clay underlain a 4.5m thick sand. the degree of saturation of sand is 37%, the void ratio is 0.52. the moisture content of clay is 42 %. the natural groundwater table is located at 2m below the natural ground surface. assume that the sp.gr. of sand and clay are both 2.65. compute: unit weight of sand above the water table effective pressure at point 10m below the ground surface total pressure at point 10m below the ground surface
Problem 3: A layered soil is shown below. Given: H1 = 1.5 m kj = 9 x 104 cm/sec H2 = 2.5 m k2 = 7.8 x 10³ cm/sec H3 = 3.5 m k3 = 4.5 x 10$ cm/sec %3D Estimate the ratio of equivalent permeability, kH(eqykv(cq). H1 H2 k2 H3
What is the equivalent coefficient of permeability (k) for all soil layers? where equivalent k(2 and 3) = 4.95 k1 and k4 = 4.69 k1 6 10 8 A lc D K2 ~ K3 N K1 K4 28 12
The hydraulic conductivity of a sand at a void ratio of 0.62 is0.03 cm/sec. Estimate its hydraulic conductivity at a void ratioof 0.48.
the soil profil shwon in figure BI below.determine total and effective vertical stresses and powr water Pressure at Points A, B, and C. For the soil 3m 4m 6m I Sand A5=2167 €=0.69 B C w=9% Silt Gs =2170 = 2₁70 e=0.60 clay = 2.72 @= 0.5 G₁ 5 = 70%