L. Sketch the objects shown using isometric, oblique, and one- or two-point perspective.

Please assist with this practice question 9. I don't know where to begin with this. Give details on how to do. Thank you.

how do I dimension the object shown below  assume grid spacing is 0.2

This problem comes from Introduction to Graphics Communications for Engineers 4th Edition page 64 #2 could you help me sketch the isometric view given the 3 standard views

18 76 40 30 Dia 20 Dia 36 5/4 Through hole Sketch and project the top view side view and top view using catia v5, and i need the orthographic view in the first angle projection also provide the isometric view note skip the question if you dont solve it or if you dont have the software, dont reject it. i need the solution any please help クク

Sketch the isometric and Orthographic projection of the given componet Top view Side view Front view Isometric view Note : use CREO parametric software 3.0 to develop the sketch  No hand drawing

Don't Use Chat GPT Will Upvote

Use creo parametcric 4.0 drawing to Sketch all the compulsary part and partial views, including auxiliary and sectional views. (can replace by cropped views too). Please skip if don't have ,don't reject ,urgent needed ,

The entire top surface on the part below must be flat within 0.5 but each 25x25 patch must be flat within 0.1. Apply the necessary geometric controls to achieve this result.  Please refer to the attached image.

This problem comes from Introduction to Graphics Communications for Engineers 4th Edition page 64 #8 could you help me sketch the isometric view given the 3 standard views