JFET is a unipolar device and current-controlled device current-controlled device unipolar device and voltage-controlled device voltage-controlled device a JFET is a bipolar device normally OFF device normally ON device current-controlled device. If the value of a is 0.9, then the value of ß is.. 90

Q: In a 3-bus system that consists of one generator (slack) bus and two PQ (load) busses, the data were…

A:

Q: 4 Determine the total P,Q,S of the circuit, 230V Gottz DItej 2504 34j 2-j

A:

Q: 400 Ω resistor is connected to two coils X1 and X2 = 2X1 additively connected, completing the…

A:

Q: 12 V 0.75 kn Vg (a) (mA) 30 25 20 10 6. 10+1 12 V 0.7 V (b) FIG. 152 Problems 1 and 2.

A:

Q: The frequency band of a standard AM radio broadcast. Measure by which a carrier voltage is varied by…

A: 1. Answer: Modulation. Modulation is the process of varying property of the carrier with respect to…

Q: The figure below shows a two-member truss supporting a block of weight W. The cross- sectional areas…

A: The given figure is shown below: It is given that: Area of members:AAB=800  mm2=800×10-6 m2AAC=400…

Q: 4. Three resistors, of 40 N, 60 N, and 120 N are connected in parallel and this parallel group is…

A: Solution- If 40, 60 and 120 ohm resistors are connected in parallel, 1Req=1R1+1R2+1R3 =140+160+1120…

Q: Three identical impedances are connected in delta to a 3-phase supply of 400 V. The line current is…

A:

Q: EXAMPLE 12.3 What transformer turns ratio is required to match a 16-N speaker load so that the…

A:

Q: A series RLC circuit is constructed employing component values R = 100 Sa and L = 1.5 mH along with…

A: In this we will find Capacitance  C with help of data...And find impedance and current for series…

Q: Si Ge 2 k2 12 V oVo 10 kN

A:

Q: For the figure given below and device parameters, what is the value of Va and Vb? Use VD = 0.6 V.…

A: In this question we will find valley point voltage and peak point voltage of given Uni junction…

Q: Consider the continuous time signals described in the figure below and aluate the convolution…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 2 considered Vcc is equal to +5V In anticipation of TTL Logic Explained in details the logic levels…

A: TTL logic: It is a digital logic design known as a bipolar transistor that is fabricated into a…

Q: What is an approach thats being investigated to mitigate the absorption losses in photovoltaics

A: Introduction -  Photovoltaics is the transformation of photons to energy utilising photovoltaic…

Q: frequency spectra of the given signals:

A: Even signal-When any signal is mirror image/symmetrical  to y axis or vertical axis then that signal…

Q: Find the convolution x[n+2]*h[n] between the signals shown x[n]=Ω[n]+2Ω[n-1]-Ω[n-3]…

A: This question is belongs to signals

Q: What is the resistance of this combination of resistors?

A:

Q: Given the sequence of x[n] = {-1, 2, -1} where the underlined number corresponds to when the…

A:

Q: 1. The resistance, inductance and capacitance in a parallel RLC circuit are 1500 ohms, 400mH and…

A: As per company guidelines we can solve only first three sub parts kindly post another parts…

Q: A 415 V, 3 phase, 4 wire system supplies power to three non-inductive loads. The loads are 25 kW…

A:

Q: For the circuit shown below, determine the value of the current ix. State any assumptions/theorems…

A:

Q: An op-amp has a differential voltage gain of 2000 and a CMRR of 20000. A single-ended input signal…

A: We need to find out output voltage for given input and gain

Q: On the complex plane, which roots are characteristic of responses that are stable? roots on…

A: To check the stability of a system, the roots of its characteristics are located on the complex…

Q: 2. ELECTRICAL NETWORK a. Determine the amount of each current for the following network. 1 ohms 5…

A:

Q: Obtain the equivalent circuit of a 200/400-V, 50-Hz, 1 phase iransjormer from the following test…

A:

Q: Transmitting and receiving antennas operating at 1 GHz with gains (over isotropic) of 20 and 15 dB,…

A:

Q: PROBLEM 7.15 Determine VOUT versus vIN for the circuit shown in Figure 7.8 Assume that the MOSFET…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: What is the Transfer function? Use the keyboard, do not write by hand

A: TRANSFER FUNCTION:                       Transfer function gives the relationship between input and…

Q: the open-loop and closed loop poles

A: Open Loop System-  A system which is controllable in which input of the system does not depends on…

Q: What is an approach thats being investigated to mitigate the absorption losses in photovoltaics?

A: Solar cells are photovoltaics. Quantum efficiency and impedance spectroscopy tools are used for…

Q: Determine the resistance of 75 feet of No. 17 gauge aluminum wire. Note: Use at least 4 decimal…

A: In this question we have to calculate resistivity of a aluminium wire.

Q: 3. For the circuit shown in the figure, find a) I in 20 2 b) V at 20 2 c) I in 75 N d) V at 75 N e)…

A:

Q: A two-pole Y-connected synchronous generator rated at 470 kVA, 480 V, 60 Hz, and 0.85 PF lagging.

A: NOTE_ “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: 1. Determine the effective impedance of the network shown in Figure 3.21 at 10 MHz. Figure 3.21 75…

A:

Q: 2. a.) From the circuit shown below, determine: a. Vgs and Ids. b. Vds, Vd, Vg, and Vs 10V 2.2 kn…

A:

Q: A balanced delta connected load, consisting of there coils, draws 10 A at 0.5 power factor from 100…

A: Notes: Line current equal to phase current in star connection  Line voltage equal to phase voltage…

Q: A copper cable with a length of 1.00 m starts to conduct a current of 5.00 A when it is connected to…

A:

Q: EXAMPLE 12.1 Calculate the input power, output power, and efficiency of the amplifier circuit in…

A:

Q: Determine urrent, P, ST, Qr f the 'circuit i 3+5 al7

A:

Q: Alpha is 25 degree and Vpic is 120 the wave is from 0 to 10pi Find Vrms for the given wave

A:

Q: The PMOS transistor shown below has Vtp = -0.6 V. As the gate voltage vG is varied from +2 V to 0 V,…

A:

Q: Why we would want to use the Laplace transform. When can we employ it (think about conditions), and…

A: Laplace transform convert time domain to frequency domain

Q: Figure 1

A: For KVL equations- Summation of voltage drops in a closed loop is  always zero. For KCL equations-…

Q: 33. Determine v, for each network of Fig. 177 for the input shown.

A:

Q: 16.12 One period of a periodic function is described by the following equations: i(t) = St A, -2 ms…

A: Given: Graph will be like:

Q: A battery is charged with 2A for hour, calculate how much Coulombs of electrons is charged during…

A: Given, Current, I=2 A Time, t=1 h=1×60×60 s=3600 s

Q: An FM modulator has kf=30kHz/V and operates at a carrier frequency of 180 MHz a. Find the output…

A: FM modulator sensitivity is, kf=30 kHz/Volt Carrier frequency is, fc=175 MHz Instantaneous value of…

Q: Consider the following control system: K. s+1 + or- What is the unit-step response for negative…

A: Brief description : In the above given question they have mentioned a unity negative feedback…

Q: The current in a circuit known to consist only of resistance and inductance in series is 8.31 amp…

A: The solution is given below