It is observed that 100 traffic crashes occurred on a 20 mile long section of Kalayaan road in one year. If the average daily traffic on the section was 10,000 vehicles. Determine the rate of fatal crashes per 100 million vehicles-miles if 10% of the two crashes involved fatalities?

Q: 1.3 ft 200 Ib

A:

Q: Que 67. Calculate the weight (Kg) per meter length of 25 mm diameter steel bar place at a spacing of...

A: Given data- Diameter of the steel bar=25 mmspacing=250 mmTo Find-The weight per meter length of the ...

Q: An A36 W 12 x 65 column section is 8 m long, pinned at each end and has an additional support in the...

A: Given, L = 8 m or 8000 mm  A = 12323 mm2

Q: 6. The soil moisture at field capacity is 27.2% and the moisture content at the time of irrigating i...

A:

Q: 1 viscosity is 0.25 cp and the formation casenvoir is 20 md thickness is 30 f th

A:

Q: THE IDEALIZE MODEL FOR SUSPENSION BRIDGE IS SHOWN IN THE FIGURE. THE TRUSS ARE PIN CONNECTED AT A, O...

A: Given, Allowable tensile stress  σmax=150 MPa Required, Design diameter of cable  

Q: If the rod is at rest when 0 = 0°, determine its angular velocity when 0 = 90°. Express your answer ...

A: ASKED: To determine the angular velocity of the rod at θ=90o.   Given, Weight of the rod (W) = 42 lb...

Q: 2. A long solid cylinder of radius 4ft, hinged at point A, is used as an automatic gate. When the wa...

A: We have to determine the specific weight of the cylinder as per the given data like specific weight ...

Q: constant head permeameter, 85 mm in diameter containing fine sand sample 450 mm long, allowed water ...

A:

Q: Assuming sea water to be incompressible and unit weight is 64 lb/cuft, what is the pressure in tons ...

A:

Q: uhat o the doil which has vo id ratio Shecific guauity cortical gradient g २-११ 2-67

A:

Q: A man paid 10% as down payment of P200,000.00 for a house and lot and agreed to pay the balance on m...

A:

Q: A stone is thrown vertically upward from the ground with a velocity of 300ft/s. How long must one wa...

A: Given data: initial speed from the ground = 300 ft/s height of tower= 600 ft meeting both the stones...

Q: Taking 'k' components 0.77TEC + 0. 8TBD=1440.. (1) Taking 'j' components 0.514TEC – 1. 67BD=0. . - (...

A:

Q: The rectangular channel in Fig P10.120 contains a V-notch weir as shown. The intent is to meter flow...

A:  

Q: Two cables will lift a 15.20 meter long prestressed pile. 1. How far away from the pile ends should ...

A: Precast foundation piles have many advantages: being much faster foundation time, highest foundation...

Q: 1406. Through what distance will body A in Fig. P-1408 move in changing its velocity from 6 ft per s...

A:

Q: Please sketch the direction of Moment both in the Z-Z and Y-Y axis E P. C B A α

A: We have to sketch the direction of moment in both direction in Z-Z and Y-Y axis as per the given dia...

Q: Calculate the weight of block A shown in the figure.' 37 36 N W.

A:

Q: Given: The 200 lb mine car is hoisted up the incline. The motor M pulls in the ap= 4ft/s? cable with...

A:

Q: A retaining wall 9 m high retains granular fill weighing 18 kN/m³ with level surface. The active thr...

A:

Q: **** A 45° slope as shown in figure has been excavated to a depth of 6 m in a saturated clay having ...

A:

Q: Taking 'k' components 0.77TEC + 0. 8TBD=1440. . - (1) Taking 'j' components D. 514TEC – 1.6TBD=0.......

A:

Q: Suppose a large rock is ejected from a volcano, as illustrated below with a speed of 25.0 m/s and at...

A:

Q: The horizontal lawn sprinkler shown in the figure has a water flow rate of 24 L/min introduced verti...

A: ω=VR-TρQR2When T=0ω=VRQ=24Lmin=24×10-3m360sec=0.0004m3sV=QA=0.0004m3sπ40.0082=7.95774ms

Q: ody having a mass of 1.5 kg Is rotate at an angular velocity of 2 /s In a circle of radius 25 cm. cu...

A: Given data- Mass (m) = 1.5 kg Angular velocity (w) = 2rev/s    Angular velocity (w) = 2×6.283 = 12.5...

Q: A beam is to be designed for loads causing a maximum factored shear of 270 kN, using a concrete with...

A: Beam Reinforcement: Beam is a horizontal member which carries a load from the structure and transfer...

Q: Que 20. The covered area of a proposed building is 150 m? and it includes a rear courtyard of 5m x 4...

A:

Q: Take Distance AB=188 m

A: Given data : True length of chain L=30 m Wrong length of chain L'=30.04 m Wrong length of line measu...

Q: 2. All members of the truss A B C shown have a cross- sectional area of 500 mm? and all pins have a ...

A: We have to determine the value of axial stresses in members BC and DE and the shear stresses in the ...

Q: Q-9: A road is to be constructed with a uniform rising gradient of 1 in 100. Determine the staff rea...

A:

Q: 8 kN 4 m

A:

Q: For the retaining wall shown in the figure below, assume that the wall ca yield sufficiently to deve...

A: ###Using Rankine Active pressure theory#####  

Q: Determine the force in each member of the Howe roof truss shown. State whether each member is in ten...

A: In Method of section we divide the section into two half in such a way that section should passed th...

Q: mine  the equations of the shear and bending moment curves for the beam and loading shown , (b) draw...

A:

Q: From Given plan and section below , Estimate Quantity of (Footing, Block wall under DPC, Block wall ...

A: The dimensions are given, Calculating the volume/quantity of the different items:  S.No. Details ...

Q: L = 14 in. PA L = 16 in. ds da Ps d1= 2" d2= 2.375" d3= 2.25" d4= 2.5"

A:

Q: e elongation of the bar from e load P = 30kips.

A:  

Q: 20. Determine the location of the maximum upward deflection from B. 21. Determine the maximum upward...

A: uw = upward dw = downward

Q: jWater flows through a vertical contraction (venturi) section. Piezometers are attached to the upstr...

A: The given data is shown below: V=24 m/sd=33cm

Q: Example 2.9. A horizontal line PQRS is 12 m long, where PQ = QR = RS = 4 m. Forces of 1000 N. 1500 N...

A:

Q: m) what is the block shear rupture (L-shaped) capacity of flange plate of the flange connection in k...

A: Answer We are given Flange plate A36 (Fy = 36 ksi , fu = 58 ksi) Flange plate PL = 9.5 in x 1/2 in  ...

Q: How long will it take to sink an open and empty vessel 4 m x 4 m x 2m high, with a  draft of 1.6 m, ...

A:

Q: If the concentration of Na, Ca and Mg in a water sample are 345, 60 and 18 mg/l, respectively, then ...

A: This question is related to The Irrigation Engineering. In this question we calculate the SAR of thi...

Q: 4. A water flows through a pipe at a velocity 2 m/s. The pressure gauge reading is 2 bar. The datum ...

A:

Q: Calculate degree of static indeterminacy

A: Given data : The number of member in truss m=11 The number of Joint in truss J=7 The number of exter...

Q: Find the weight of water if water content is 0.172 and weight of soil solids is 22 kg

A:

Q: A soil has liquid limit 65%, plastic limit of 30% and shrinkage limit of 25%, and it has natural moi...

A:

Q: A dry sand 10 m thick has an in-situ dry unit weight of 18 kN/m^3. Using vibroflotation, the surface...

A: Dry unit weight of sand = 18 KN/ m3 Thickness of layer of sand before compaction = 10 m. Thickness o...

Q: The torsional assembly shown in figure below consists of a solid bronze (G3 = 45 GPa) shaft CD and a...

A: