Is the following system BIBO stable? Is it internally stable? why? Го 6 9 B = [].C= 10 A= 10 - [0 1 -3)

Q: 10. For a silicon diode, calculate the diode current at room temperature (22degreescentigrade) if…

A: The current is

Q: The required number of bits to obtain a resolution of 0.625 V over a voltage range of 0 to 10 Vis 2…

A: Given, Resolution, R = 0.625 Voltage range of 0 to 10 V, Vm=10 V Number of bit required, n =?

Q: 4 A resistance R, and inductance L=0.01H and a capacitance C are connected in series. When a voltage…

A: The value of resistor and capacitor can be calculated by using the total impedance of the series…

Q: In a common base configuration, collector current is 3.57 milliamperes and base current is 0.06…

A: Given: In a common base configuration, Collector current, IC=3.57 mA Base current, IB=0.06 mA

Q: Q3/ For the control system shown below, determine: + R(S) = -²-3 1 S(S + 1) a) C(s)/R(s) b) C(oo) c)…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Is the output true or false, I need the output step by step and a clear line please al = 25 dB al =…

A: Brief description : In the above given question they have mentioned a solution for the given…

Q: A system is characterized by the differential equation: y(n) = y(n-1)-y(n-2) + x(n) + x(n-1). Sketch…

A: here they given a differential equation and asked to sketch the direct form 1 and 2 structures.

Q: When a small a-c motor is operating at rated load from s 116-volt 60-cycle source, takes 287 watts…

A:

Q: Problem 2. In the lectures, we discussed how to use an NPN BJT as an emitter follower. In the…

A: The solution is given below

Q: parallel plate capacitor has plates, each of area 80 cm2, separated by a distance of 5 cm. The…

A: We need to find out surface charge density of given capacitor

Q: Example T-L with Zoz 600, ZR 2 100-2. Find the length and location of the single stub terminated by…

A: Here  dstub=distance of stub from load end. lstub =length of short-circuit stub.

Q: junction is forward biased and If the emitter-base the collector-base junction is reverse biased,…

A: There are mainly four types of regions such as Active region, Saturation region, Cutoff region and…

Q: capacitor is placed in parallel with two inductive loads one of 20 amp at 30° and one of 40 amp at…

A:

Q: Q2):- Find Y[Z] of signal Y[n] (Cos wn). U[n]

A:

Q: What is the purpose of the split-ring commutator in an electric motor that operates on DC power?

A: The electric device that uses electrical power input and the rotor stator set, to convert the…

Q: For the network of Fig. 5.185, determine: a. Zi b. Av c. Ai = lo/li d. Zo

A: The required parameters can be calculated by using the AC analysis of the amplifier circuit.

Q: a. What is V3 when Vbe = 0.7V, beta = 100, R2 = 1k, Vce(sat) = OV, V1 = 3V and R1 = 0? b. What is V3…

A: The voltage at emitter terminal can be calculated by applying the kirchhoff's voltage law to the…

Q: Two filament lamps rated 200 W/200 V and 50 W/200 V are connected in series across a 200 V, 50 Hz,…

A: Given data, Two filament lamp connected in series From first lamp ratings, Voltage, V1=200 V Power,…

Q: Determine the input impedance, Z, in rectangular (Cartesian) form if = 5 rad/s → 2 ΚΩ 20 H 2 mF 'in

A:

Q: 9. Draw the equivalent circuit and characteristic curve of a forward biased diode using the second…

A: To draw the equivalent circuit and characteristic equation of ideal diode model.

Q: D8.2. The field B = −2a, +3a, + 4a, mT is present in free space. Find the vector force exerted on a…

A:

Q: given the potential field V₂ (A5² +B5=²) Sinal d) Show the 1²V = 0 b) Select A and B So that V=loor…

A:

Q: A 3-phase alternator generates an open circuit voltage of 4000 V per phase when exiting current is…

A: The solution is given below

Q: 8.14 Find each capacitor voltage in the circuit shown in Fig. 8-9. 20 F 30 μF Ht 400 V Ht V₁ 40 μF…

A:

Q: A single phase transformer of (k) transformation ratio is to be used as a step-up autotransformer.…

A:

Q: 6.) A capacitor is charged with 18 mC. If the energy stored in it is 1 joule and with voltage of…

A: We need to find out the value of capacitance.

Q: 100 V -100 V 2.2 k Ideal diodes [ 2.2 ΚΩ www 2.21

A:

Q: B- Design a series- type ohmmeter, the movement to be used requires 1mA for full scale deflection…

A:

Q: find capacitor voltage (calculate please) Let us compute the voltage across the capacitor for t20…

A:

Q: Obtain the Laplace transform of the following function: a) e-2 cos 3tu(t)

A:

Q: Compare between squirrel cage rotor and drag cup-rotor

A: 5

Q: Find the current in the RLC-circuit when inductance is 0.1 H; resistance is 20 ohms, C = 0.0002…

A:

Q: Q3: Put the following sentences in the correct order to form an introduction paragraph that begins…

A: The correct order of the sentence will be, 5-2-3-6-4-1

Q: 7) A 480 volts distribution system delivers a load of 120kw 0.707 pf lagging, what value of the…

A:

Q: Consider the following circuit below, assume V = 1.2 V and k = 0.5 mA/V². th a. Determine I (in mA),…

A: The solution is given below

Q: 3. Draw the equivalent circuit and characteristic curve of a forward biased diode using the third or…

A:

Q: Q5/ A- A series- type ohmmeter, designed to operate with a 6V battery, has a circuit diagram as…

A: Given R1 =49 kΩ Ifd=100 μA Rm =2000 Ω

Q: Emitter Current is O more than the collector current O always equal to base current less than the…

A:

Q: Draw the equivalent circuit and characteristic curve of a forward biased diode using the first or…

A: In this question,   We need to Draw the equivalent circuit and characteristic curve of a forward…

Q: A storage battery of internal resistance of 0.4 is to be charged from a DC line. If the EMF of the…

A: Given: Internal resistance, r=0.4ΩEMF of the battery, E=12VCharging current, I=4ALet DC supply…

Q: Find the forces per unit length on two long straight Parallel conductors if each carries. a current…

A:

Q: 9) Which type/types of Amplitude Modulation signal/signals can be detected by the Envelope Detector?…

A: We can detect double side band (DSB) signal by envelope detector. Also DSB-SC, SSB and VSB signals…

Q: 10v I₁ R₁=49 a b I, R₂=89 R,=69 1₂ 4v

A:

Q: -8V P₁= 12kn m 22=2.5k-2 12V Si R3=5602 T Analyse the circuit using any. Circuit amatysis method to…

A: In this question we will find output voltage, diode current , diode voltage...

Q: 2. Sketch the output voltage (v.) and the transfer characteristics (v, against v;) for each circuit…

A:

Q: BJT acts as a switch in O in saturation region O in cut off region in saturation and cut off region…

A: There are mainly four types of regions such as Active region, Saturation region, Cutoff region and…

Q: b) A three-phase supply operating at 400 V 50 Hz is supplying a factory with two loads. Load A is…

A:

Q: The current 'i' and '12' in the circuit shown in Fig. is 100 • i, Ⓒ120 V 500|¹ 6A+

A: Given circuit,

Q: Find the T.F of DE (h[n]) Y[n] 2X[n] + 3X[n-1] - X[n-2] + 17X[n-3] - 6X[n-4]+Y[n-1] -3Y[n-2]

A:

Q: Assume beta = 100, V = 0.7 V, V CE,sat = OV. ВЕ a. If R = 0 and V = 3 V, determine the value of V.…

A:

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.