Is collecting data with a tally card the most efficient method in timber cruisin

Q: A project needs 600 each 8-foot-long 2x4s and 75 each 8-foot-long 2x6s. You have received a bid from…

A: Given requirement is  8ft long 2×4s= 600 8ft long 2×6s= 75 Cost for each 2×4s= 3.39$/each Cost of…

Q: Given the bridge abutment shown here, determine the numberof worker hours required to form the…

A: Given: L1=30ftL2=50ftL3=30ftThickness of wall(t)=1ftHeight of abutment(H)=8ft Form work area for…

Q: What is the effect of Dust loading on the efficiency of  a cyclone seperator?

A: Solution: The geometry of the separator basically imparts the efficiency of the units. A cyclone…

Q: Assuming that you have convinced the owner/designer to not use No3 grade and only Select Structure…

A: Lumber grade first and second is the highest grade of hardwood lumber. it is usually 6-inches x…

Q: write short notes on why a timber brought onto the site is not good for construction of civil works.

A: Timber is one of the oldest and most convenient construction material. It is widely available and…

Q: If the free haul area is between 4+30 and 14+30, what is the average haul distance (ft) for the net…

A:

Q: Describe about the bailers and for what it is used.

A: Bailment happens when someone voluntarily transfers property to another person for a specific…

Q: Define the concept Cross-Hole Sonic Logging.

A: for non destructive testing of drilled shaft and other concrete piles we used cross hole sonic…

Q: Explain the disadvantages of grillage analysis which is commonly used in structural analysis of…

A: In designing the no. of cells for concrete box girder bridges. The depth of the box girder bridge…

Q: Observe several construction sites and ascertain details oftheir safety program. If possible, attend…

A: As a construction site trainee engineer, I visited more than 5 construction sites in the past 1…

Q: Define the importance & benefits of using continuous-flight augers  ?

A: Continuous flight auger Piles are also known as auger cast piles, cast in place piles, auger…

Q: How is the float useful for the contractor?

A: - Float denotes the range within which the activity time or the finish time may vary without…

Q: What does the pacer test look for?

A: Answer -  Aerobic capacity, which is defined by endurance, performance, and fitness, is what the…

Q: Using the Internet, research the LEED rating system for new construction.What are the prerequisite…

A: The Leadership in Energy and Environment Design (LEED) is a commercial building certification…

Q: what are  the Profession of individuals involved in constructing a wooden wharf ?

A: Wooden wharfs are the structures that are built on water providing access to the ships and boats to…

Q: Scaffold platforms must O Be fully planked O Be at least 18 inches wide O Be free of debris O All of…

A: Given data in question  Scaffold platforms To be discussed  Provisions of scaffold   The scaffold…

Q: “decay” of timber? And how does it affect the properties of timber?

A: DECAY OF TIMBER

Q: Assuming that you have convinced the owner/designer to not use No3 grade and only Select Structure…

A: Lumber- It is described as the felling of economically valuable trees in the forest for domestic,…

Q: Make sure you know the difference between fixed and movable slots. What impact may they have on the…

A: A slot is a shelf or part of a shelf where  items of a warehouse sit. Warehouse slotting is…

Q: Assuming the following information • Parapet is 12550 mm long Blocking is 1x2 dimensional lumber…

A: Solution:- Given data:- Length of parapet = 12550 mm Blocking is 1 x 2 dimensional lumber   To…

Q: Explain the concept of mill over- and under-run. What is the common tendency seen when using the…

A: Mill over-run and under-run are terms utilized in the lumber business to depict the distinction…

Q: Describe four factors that must be taken into account before deciding on picking system and…

A: to find  four factors that must be taken into account before deciding on picking system and…

Q: From the following network data, determine the criticalpath, starting and finishing times, and TFs…

A: Network

Q: Using the Internet, research the LEED rating system for new construction.What are the prerequisite…

A: Leadership in energy and environment design (LEED) is an internationally recognized green building…

Q: Q5. What is the minimum clearance required by OSHA regulations between a crane and a 150-kV power…

A: The Occupational Safety and Health Administration(OSHA)-The Occupational Safety and Health…

Q: Note: This is not an assignment question. Don't copy from Google  Explain by using the view in…

A: Characteristics of good timber in terms of construction are as follows :-  Strength  Durability…

Q: Define the term Preconstruction Operations?

A: Pre-construction operation:

Q: Give an explain the several methods for eliminating the problem of stainless steel pipe damage…

A: explain of several method for reducing the problem of stainless steel pipe damage handling in…

Q: Briefly define and describe the purpose of the following structures and how they were used. Make…

A: Definition: A presidio was a military outpost built by the Spanish Empire in its colonial…

Q: Why is it necessary for the Plant Inspector to report to Field inspector?

A: The field inspection is a critical part for any construction project, as it guarantees that the work…

Q: What are the differences between on-site and off-site storage?

A: The difference between on-site and off-site storage is required to be considered according to the…

Q: What is the primary difference between a typical grade stamp and an E-rated (machine rated) grade…

A: The Grade designates the quality of lumber or wood product. The grade of a piece of lumber is based…

Q: What is the standard test procedure to determine the timber grain?

A: Loads will be used in two areas in the third grade of space from each poor support of the two…

Q: Describe the term the selection of the trailer type field office/

A: In the field of construction , the offices are needed to be set at the fields or construction site.…

Q: what is slab pull in a short definition?

A: Slab pull is nothing but the movement of tectonics plates which results into earthquake waves.

Q: A particular company decided to do the construction of a building with timber as a material. Depends…

A: Wood that has been treated into beams, as well as boards, is known as timber. Timber, often known as…

Q: How does Hand-operated auger methods useful?

A:

Q: Discuss about the punching shear failure? Explain the cause & consequences of punching shear…

A: Solution: The punching Shear is the mechanism of failure in the members of the structure such as…

Q: Suppose a BAF 5 gage was chosen for inventorying a stand. What might you assume about the size and…

A: BAF (Basal Area Factor) is a measure of the area of a tree's cross-section at breast height (usually…

Q: What is shovel productivity? What is  factored into shovel productivity?

A: shovel productivity- It is defined as the productivity of a shovel that can produce maximum output…

Q: What are  the Machines used to construct a  wooden Wharf ?

A: Wooden wharf is a site of around 5 million sq ft usually constructing for various commercial and…

Q: What does the pacer test look for?

A: Answer - The PACER fitness exam is an excellent method for encouraging kids to love exercise. It…

Q: Define the term rakers?

A: The word "raker" is made from "rake" which refers to an angle of a slope which is measured from the…

Q: 3. For timber form work to be use in c best criteria for usage consideration?

A: