Iron loss in a transformer: a) is dependent on load current. Ob) is a function of the resistance of the primary and the secondary windings. c) is a function of eddy currents and hysteresis effects in the transformer core. d) can be reduced by 4 by reducing the current by 2.

Iron loss in a transformer: a) is dependent on load current. Ob) is a function of the resistance of the primary and the secondary windings. c) is a function of eddy currents and hysteresis effects in the transformer core. d) can be reduced by 4 by reducing the current by 2.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.3P: Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source...

See similar textbooks

Related questions

Q: Assume Bpc =200. The Q-point for the following circuit is: Rc 330 N RB Vec: 20 V 47 kN Q (198 μΑ.,…

A: We need to find current and voltage for given circuit

Q: A transformer has a turns ratio of 4:1. If the secondary winding contains 30 turns, the number of…

A: The solution is given below

Q: Q5. Briefly explain about any five physical properties of CNTS along with their potential…

A: Introduction - The term CNT stands for carbon nanotube. A carbon nanotube is a carbon pipe with a…

Q: Q1. A series-connected circuit has R=4 & and L=25 mH. Calculate the value of C that will produce a…

A: Given a series RLC circuit with, Resistance, R=4 Ω Inductance, L=25 mH Capacitance, C =? The quality…

Q: Determine V0 for the circuit shown

A: In this question we will find output voltage Vo...

Q: 1. For Figure 8.1, Calculate the gain from the input to RI to Vo, R2 to Vo and R3 to Vo as well as…

A: The given circuit is as shown below,

Q: Question1: Simplify the following block diagram.

A: AS per our guidlines we done 1st question

Q: Given y = mx + c. Find the value of y1, y2 and y3 based on the figure below. y(t) 2 -2 -1 0 1 t 3 2x…

A: The solution is given below The answer is option option a.

Q: Which of the following is true if a series circuit has unequal resistances throughout the circuit?…

Q: The value of Capacitor depend on: potential energy and distance Only on Distance between plate and…

A: In this question we will write about on which factors capacitor value depends....

Q: Homework 1 The switch in the circuit in below has been closed for a long time, and it is opened at…

Q: On the circuit below, assume all initial conditions are 0 and that R = 1kΩ, L = 1mH, and C = 1uF.…

A: The circuit diagram is shown below, Where, R = 1kΩ, L = 1mH, and C = 1uF

Q: Determine the inductance of the circuit.

Q: 1- The Eb/V ratio of a d.c. motor is an indication of its (b) Speed regulation (c) Starting torque…

A: In this question, We need to choose the correct options All are related to DC motor. as per our…

Q: Q4) A 220 V, d.c. shunt motor has an armature resistance of 0.4 2 and a field resistance of 220n…

Q: Sketch v, for the network of the figure below for the input shown. Show the details of your work.

Q: QUESTION 29 Select all signals that are inputs for the 8088. Use the schematic for our board. OSC…

A: Consider the schematics of 8088 shown below,

Q: If Z= 10-j3 Find z³(point)³³³³³… (z^3.333333...)

Q: Determine the volume of stone and its specific

A: Conductor-Materials which have free electrons in valence which can flow when comes under any…

Q: Listen R1 1kO R2 200kO V1 10V Q1 R3 0.25kO All resistor values are in kiloOhm Assuming that…

Q: A 25 kHz series resonant circuit has a Q of 50. The upper and lower cut-off frequencies are: O a) 23…

Q: Suppose a simple uniform hashing function is used with chaining. Here n is the number of keys stored…

A: When a simple uniform hashing function is used with the chaining, the collisions will be resolved…

Q: An Electric Flux Density equal to D = x²yz ax + 2xy?z ay + 4x°z2 az C/m², find: (a) Dx, Dy, Dz (b) a…

Q: Which among the choices is true about closed loop amplifier? Adds stability to the amplifier.…

A: The closed loop amplifier adds stability to the amplifier.

Q: Which of the following statements is one of the properties of capacitors connected in series?…

A: Consider the capacitors connected in series, In this circuit same charge will flow through all…

Q: A capacitor, a resistor and a 440V, 60 Hz supply are connected in series. The phase angle is 65.7°…

A: The solution is given below

Q: Q2. 5. Given vectors P = 4i - 2j 5k: Q = -i + 3j - 6k find QxP. Select one: O a. -3i -19j + 1ok O…

Q: To improve a lagging power factor: a) the apparent power from the source is increased. Ob) the…

Q: Which of the following current has the least in magnitude? Select the correct response: O IE O IC O…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Q2. 4. Given vectors P= 4i - 2j 5k: Q = -i+ 3j - 6k: find PxQ. Select one: O a. -3i + 19j - 1ok O b.…

Q: Consider the above semiconductor structure, where Al is alloyed into an n-type Si sample with…

A: Given data is Nd=1016 cm-3,Na=4×1018 cm-3 Assume ηi=1.5×1010 cm-3 ε=ε0εr=8.854×10-12×11.8 F/cm…

Q: 6. What is the effect of decreasing resistor Rg on Ico for the fixed- bias circuit? What is its…

A: BJT is a current controlled Device in which base current control the mode of operation of BJT. Mode…

Q: Listen An AC voltage represented by e= 170 sin377t volts is applied to a resistor resulting in a…

Q: Shape Fill Тext Box Quick Z Shape Outl Convert to Picture Shapes Arrange BIUab x x, AV v Aa v…

Q: For Fixed Bias Configuration Solve for Ib, lIc and le. Atleast 2 decimal place. Be mindful of units.…

A: Apply KVL in collector base loop to find base current. collector current = Current gain* base…

Q: Question 4 Compute the current (express your answer in milli (103) ANSWER:Blank 1 10 kN -5 V Blank 1…

Q: 1. Obtain the Thevenin equivalent at the terminals a-b of the circuit and draw the equivalent…

Q: In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of ß is ..... 1. 100 2. 50 3. about 1 4.…

A: Given, In a transistor IC=100 mAIE=100.2 mA

Q: If V1 is a sinusoid with amplitude = 1mV and freq=1kHz, choose a combination of V2, R1, R2, and Rf…

Q: 19. How much inductance is need to resonate at 5KHZ with a capacitor of 12nF? O 11.844 H 3.33 mH…

Q: A 253 uH inductor and a capacitor are connected in series. The circuit is found to be resonant at…

A: We need to find out value of capacitor .

Q: for the given circuit , VDD= 50v, RD=16 k), RG=56k0, ID=1.03mA. VGS=-0.051v. Find RS.VDS +VDp

Q: (b) Figure 2 illustrates the one-line diagram of a power system. The ratings of the various…

Q: Determine the current in the loop of 12ohms, 0.1vx, 12 ohms. (Express your answer in milli (103))

A: In this question we will find current in the loop of 12 ohm, 12 ohm current source....

Q: Compute the current (express your answer in milli (103)) ANSWER:Blank 1

Q: What are some of the advantages of using high-tech lighting?

A: High-tech lighting : In high tech lighting system LED ystem are used for lighting purpose instead of…

Q: Ex: Find VA U Sing The ve nin theorem. 6A iB + VA - 20 V (+ 2 S2 2VA 26 iB

Q: 5 kN 5 kl -I VoM 5 k2 +1.5 vo

Q: Determine the R2 value for the summing amplifier given below so that the output voltage is -3V.

Q: Find the natural frequency for V. for the following circuit given the following parameters. Solve…

A: The circuit diagram is shown below, Where,C=8mFL=9mHR1=6ΩR2=9ΩR3=10Ω

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

BListen
Tron Joss in a transformer:
Cais dependent on load current.
b) is a function of the resistance of the primary and the secondary windings.
Cis a function of eddy currents and hysteresis effects in the transformer core.
d)
) can be reduced by ¼ by reducing the current by 2.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a short-circuit test on a 2-winding transformer, with one winding shorted, can you apply the rated voltage on the other winding? (a) Yes (b) No
Consider an ideal transformer with N1=3000andN2=1000 turns. Let winding 1 be connected to a source whose voltage is e1(t)=100(1| t |)volts for 1t1ande1(t)=0 for | t |1 second. A2- farad capacitor is connected across winding 2. Sketch e1(t),e2(t),i1(t),andi2(t) versus time t.
In developing per-unit circuits of systems such as the one shown in Figure 3.10. when moving across a transformer, the voltage base is changed in proportion to the transformer voltage ratings. (a) True (b) False
An ideal transformer has no real or reactive power loss. (a) True (b) False
A transformer core is laminated in order to ....................................? (A) reduce hysteresis loss and eddy current loss (B) reduce only hysteresis loss (C) reduce copper loss (D) reduce all of the above losses (E) None of the above.
A transformer has primary and secondary turns of 1250 and 125 respectively. It has core cross-sectionof 36 cm2 and its rms flux density is to be limited to 1.4 T (to prevent core saturation). Whatmaximum 50 Hz voltage can be applied on the primary side and the corresponding open-circuitsecondary voltage?The core has a mean length of 150 cm and its relative permeability can be assumed to be 8000. Whatwould be the rms exciting current when the transformer’s primary winding is excited at a voltage ascalculated above? Also calculate the magnetizing susceptance as seen from primary and secondarysides.If the transformer were to be excited at 60 Hz, 1. What should be the maximum primary voltage for thecore flux density limit not to be exceeded? 2. What would be the magnetizing susceptance as seen oneach side in this case?
391. A transformer has maximum efficiency at load copper loss (P.), is of full load. The ratio of its iron loss (P.) and full
2. What is the material commonly used for construction of transformer core? Draw the B - H curve for this material?
A small single-phase 60 Hz transformer has 10.2 W at no load. The core has a volume of 750 cm3. The maximum flux density is 10,000 G and the hysteresis constant of the core is 0.0005. Using the Steinmetz law on hysteresis loss, find the eddy current loss.
A 50 Hz 1-phase transformer has a turn-ratio of 6. The resistances are 0.90 ohm and 0.03 ohm and the reactance’s 5 ohm and 0.13 Q for high voltage and low voltage respectively. Determine (a) the voltage to be applied to the high voltage side to obtain full load current of 200 A in the low voltage winding on short circuit (b) the p.f. on short circuit.
The efficiency of a transformer will be maximum when ........................? (A) copper losses = hysteresis losses (B) hysteresis losses = eddy current losses (C) eddy current losses = copper losses (D) copper losses = hysteresis losses plus eddy current losses (E) None of the above.
What conclusions we come up with after doing open circuit test on single phase transformer.