Information: 2 Vp-p (Am = 1V) 20 Hz sine wave Carrier: 4 Vp-p (Ac = 2V) 500 Hz sine wave Modulation Index: ma = 1 DC offset: 0V ma=Acmax-Acmin/Acmax+Acmin for the modulated signal (AM) ,ma = 1; Calculate Acmax, Acmin and efficiency value.

Q: Calculate the ripple factor in a full wave combiner circuit and the value of the output frequency,…

A: Given RMS voltage of the circuit= Vrms = 10VVoc = 8V Input frequency= 60Hz

Q: Draw a voltage multiplier(6 times) with half wave voltage doubler and discuss it generally..

A: to draw a voltage multiplier(6 times) with half wave voltage doubler and discuss it generally..…

Q: the vo and sketch waue form, / Determine and find dc level output ?

A:

Q: (a) Determine the average voltage of Vo. 2. Figure B.2 shows a circuit using two silicon diodes with…

A: In this question,   We need to determine the average voltage, peak voltage and output voltage…

Q: Pure Signal (no rectification) Half-wave Rectified Signal Average Value RMS Value For a sinusoidal…

A:

Q: What is the difference between a positive clamper and a negative clamper? Explain with the aid of…

A:

Q: Draw the schematic diagram Design a 15v full wave power supply that will deliver a 1.5A of DC…

A: In Full wave bridge rectifier four diode is used D1,D2,D3,D4 and this rectifier convert AC signal to…

Q: please write introduction and conclusion of lap report about AC Circuits – Verification of Ohm’s Law

A: In this we will discuss about introduction and conculusion of AC circuits in Lan reports  The study…

Q: In the Figure Below, determine the following: a. Xe b. The dc voltage across the input terminals 1…

A: given data and value of Xc

Q: A full-wave rectified voltage of 18 V peak is connected to a 400uF filter capacitor. What are the…

A:

Q: Exercise 2: A single phase half wave ac regulator using one SCR in anti-parallel with a diode feeds…

A: The rm.s source voltage (Vs) = 230 V The peak value of supply voltage (Vm) = 230 2 V Firing angle…

Q: Subject name: Signal processing measurement Question: Is there any difference between the metallic…

A: Resistance is the property of opposition to the flow of current and is the important property of…

Q: Draw the signal after adding -2.5 DC level with the given signal, sketch the new output signal and…

A: A DC shift to a given signal can be added either using a clamper or using a battery connected in…

Q: why is the piv rating important for IS AN AC CIRCUIT THAT CONVERTS AC SIGNAL TO DC SIGNAL

A: The answer as given below steps:

Q: Question-4: Design a positive biased limiter circuit (use silicon or germanium diode) that limit the…

A:

Q: need the answer as soon as possible

A:

Q: The peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 5 cm and the 'volts/cm'…

A: Need to tell about peak to peak voltage of given signal.

Q: For the C.R.O sine waveform shown in figure, determine (a) periodic time, (b) frequency, (c)…

A:

Q: C2 (i). Draw the Schematic diagram and explain the working of LVDT and write any two applications of…

A: Linear Variable Differential Transformer, LVDT is the most used inductive transducer for converting…

Q: A buck converter produces an output voltage of 100 V across a 100 Ohm load resistor. The output…

A: Output voltage of buck converter =100V. Value of Load Resistance=100 ohm Output current=2A Supply…

Q: 4 Listed are some of the uses of capacitors except: A.   couples AC B.   bypassing a shunt load…

A:

Q: Compare both the amplitude and waveform outputs of a parallel and series-positive limiter.

A: Positive limiter A positive limiter is also called a clipper. Limiter that limits or clips the…

Q: 1. For the above Boost converter, what is the duty cycle? a. 0.95    b.0.75    c. 0.25  d. None of…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: In an RC coupled clamping circuit, the relationship of the circuit discharge time constant and the…

A: In the above given question they are discussing about an RC coupled clamper circuit. By using the…

Q: DERIVE AVERAGE OUTPUT VOLTAGE EQUATIONS FOR 3-PHASE SEMI CONVERTERS

A: 3 Phase semi converter: Also known as a three-phase half-controlled converter. By replacing three…

Q: 8. What is the difference between a positive clamper and a negative clamper? Explain with the aid of…

A:

Q: Draw circuits diagrams of different modes of three phase VSI and draw the output wave shapes of line…

A: In 3-∅ voltage source inverter, the main circuit diagram is shown below: In the above circuit the…

Q: An unipolar PWM full bridge circuit has a Vr.rms of 125V at a duty cycle D1 of 0.7. What is Vd? What…

A:

Q: why is the piv rating  important for  IS AN AC CIRCUIT THAT CONVERTS AC SIGNAL TO DC SIGNAL

A: PIV stands for Peak Inverse Voltage. Peak inverse voltage is the   maximum reverse bias voltage that…

Q: er circuit to produce the given output waveform with output voltage of V1= 5.7 volts and V2= - 34.3…

A:

Q: The signal measured with the oscilloscope in the Multisim program is shown in the figure below. For…

A:

Q: An AC voltage peak value of 20 Volts is connected in series with a silicon diode and load resistance…

A:

Q: For a full-wave rectified signal the dc voltage of 0.636Vm. The rms value of the ac component of the…

A:

Q: I want to design an oscillator for a PWM supply. It will run with a square wave of 75 KHz. Voltage…

A: The relaxation oscillator can be used to form the PWM signal since the duty cycle of the PWM supply…

Q: What is the action of a capacitor in a Power Supply Circuit?*   a. To de-couple DC component of the…

A: In this question we need to choose a correct option.

Q: 3. The waveform displayed on.an oscilloscope is as shown in Eigure. The 'time/cm switch isAtio. 20.…

A:

Q: me, (b) the frequency and (c) the peak-to-peak voltage. The 'time/cm' (or timebase control) witch is…

A: Given that Time base control=100μs/cmvolt/cm=20v/cmeach grid square represent =1cmeach…