Answered: Inductive reactance results in a…

Inductive reactance results in a current that lags the voltage by n/2 rad leads the voltage by n /2 rad Leads the voltage by 90 degrees Is in phase with the voltage

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: A 230V series motor with 4-pole, 600 conductors wave-connected supplying a load of 7.5kW by taking 3...

A: We know torque=power/(speed in radian per second) Now derive the formula and solve

Q: Find V, the magniliude, 4 direction of unknowh urrente through 10e,5n 420 istanse resistors. 9. 15A(...

Q: Given : The system shown 400 customers at 500 KWh/month LOAD 1 600 customers at 300 KWh /month Power...

A: Rate lists are given as

Q: (a) [4] Convert the integer E0D16 from hexadecimal to decimal notation. (b) [3] Convert the integer ...

Q: Material GAAIAS GaP Color Wavelength (nm) V-forward 1.8 Super Red Green 660 565 Red GAASP AllnGaP 64...

A: The solution is given below

Q: 3. Find Pa, the average power absorbed by the 4-2 resistor c absorbed by the same elements due to vw...

Q: For a Full wave rectifier circuit, the AC voltage input to transformer primary is 115V. Transformer ...

Q: An overhead line is supported between two towers which are at the same vertical height from the grou...

Q: How many GPS Satellites are present?

A: In this case, the number of GPS satellites present should be found.

Q: The voltage across by a voltmeter connected across it. a resistance R5 in the circuit of Figure is t...

A: The given circuit is shown below:

Q: defined by -2 n< -4 -4 <n<1 4 g[n] = 1sn

Q: A transformer iron core has a mass of 50 kg. At 25 Hz, the maiximum flux density in the core is 1.3 ...

A: Transformer: It is a static device by mean of which electric power in one circuit is transformed in...

Q: Note that these are devices you can still purchase. Review what the processor's structure is, what i...

Q: For the digital system shown in below: 1) Write down the difference equation that represents the sys...

A: Solve the problem

Q: Analyze AC network using Kirchhoff's Laws. Find the branch currents indicated in the following netwo...

A: The given circuit is shown below:

Q: 3. When the bandwidth of x(t) is Qn , find the bandwidth of x²(t).

Q: 3. Use nodal analysis to solve the circuits below.

Q: What is the need for modulation? Justify with examples.

A: MODULATION: Modulation is critical branches of electronics science that is widely used in communicat...

Q: Determine the current using the practical model. 20 V Si Si 102 202

Q: 400 customers at 500 KWh/month LOAD 1 600 customers at 300 KWh /month Power Plant LOAD 2 560,000 KWh...

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for...

Q: 1. The boiler, turbine, alternator efficiencies of a thermal power plant are 35%, 86% and 93% respec...

A: Given: ηboiler=35% or .35ηturbine=86% or .86ηalternator=93% or .93Value of heatind coal=12000 BTU/lb...

Q: 3. What output voltage results with equal drive at the inputs? 4. Plot a graph on the grid paper to ...

A: Differential Amplifier- It is an electronic device which is used to increase the difference between ...

Q: Draw a circuit diagram to get the DC output voltage with constant DC output current from a fixed AC ...

A: Circuit diagram for the DC output voltage having the constant DC output current from the fixed AC vo...

Q: Express the following time-harmonic fields as phasors (a) A = 5 sin(2t + a/3)a, +3cos(2t + 30° la, (...

Q: 3. For the power system shown, find short circuit level and short circuit current at the F1 & F2 poi...

Q: Wire the circuit in figure 1 with the same resistors. Take readings in different places shown in fig...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: How does RFID Work?

Q: 5. Consider the networks below. Use superposition to find the indicated branch currents. I1 j42 A.07...

A: In this question, We need to all current using the super position theorems. Here 2 independent ene...

Q: Answer the question briefly. 1. What is Alternating Current (AC)? Draw a simple graphical representa...

Q: 8 20°A 220°A I2 I3 I4 62 -j207 1220°v I1

Q: Draw the logic diagram for the following functions, then map it using NAND only technology and NOR o...

Q: A capacitor has a reactance of 80 ohms when connected to a 50 Hz supply. Calculate the value of capa...

Q: Which of the following PAL schematics has the correct connection points included (i.e., the X's) to ...

A: X is indicating the particular connection that is taken as input for the particular logic gate. Ther...

Q: Below given figure depicts a discrete time signal processing system, {xx} D D a) Find difference equ...

A: (a) yt=Z-1χ1tχ1t=Z-1χt-14χ1t-15ytZ-14+1χ1t=Z-1χt-15Z-1yt Implies, yt+Z-14yt=Z-2χt-15Z-2tyt1+Z-14+Z-...

Q: For the given circuit and input waveform determine the output waveform 2.2 kn 20 5 V -5

A: Given circuit is a series negative clipper with positive reference voltage This reference voltage te...

Q: What do you mean by over modulation?

Q: 3. For the system shown below, find the range of the gain, K, to ensure that the system is stable. U...

Q: Find the Laplace Transform of sin5tcos5t

Q: 5 k2 IL 80 – 120 V 50 V 10 k2

Q: 2. Which momentary voltage occurs when the conductor loop is in a uniformly rotating generator at 45...

A: When a conductor of length (l) moving with velocity (v) in Magnetic field of density (B) Then it exp...

Q: - Solve for the indicated variable I using nodal analysis.

Q: 3. How dose the bandwidth change in relation to increasing signal amplitude? FM

Q: 4) A Hall probe, consisting of a rectangular slab of current carrying material, is calibrated by pla...

A: Given: Magnetic field, B=0.10 T Hall emf, VH1=12 mV Probe is placed inside unknown magnetic field, H...

Q: How does a Direct On Line Motor Starter work?

A: The electrical machines work on the principle of electro-mechanical energy conversion. The current c...

Q: The source impedance Z, = (12 + J5) Q in the circuit shown (Fig. 2). Maximum power is transforred to...

A: Given circuit, Source impedance, Zs=12+j5 Ω

Q: 3. What is the rms value of a square wave with an amplitude of 10 A and a frequency of 1 Hz? 4. A si...

Q: 1.2 kW 0.8 KVAR (cap) 100/90° V 2 kVA 4 kW 0.707 pf leading 0.9 pf lagging

A: The solution is given below

Q: What is HRC fuse : working & it's applications

A: Solve the problem

Q: Find the phase angle between i1 = -4sin(377t + 25°) and i2 = 5cos(377t - 40°). a. 155 degrees b. 1...

A: The solution is given below

Q: Find current through R2 resistor. R1 R3 10 Il 12 Select one: O a. 3.04 O b. 2.67 O c. 3.75 O d. 2.43

A: Given circuit,

Question

Kindly provide a CLEAR and COMPLETE solution.

#37

Inductive reactance results in a
current that
lags the voltage by n/2 rad
leads the voltage by n /2 rad
Leads the voltage by 90 degrees
O Is in phase with the voltage

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

question will save this response. UP O1 Question 2 All of the following are correct definitions except The voltage lags the current in a capacitive circuit by 90 degrees O. The current and voltage are in phase a purely resistive circuit The current lags the voltage in an inductive circuit by 90 degrees The current and voltage are in phase a capacitive circuit AMoving to another auection vdl cave this response
Value of series impedance if inductance is 5mH , resistance is 4 ohm and frequency is 50 Hz.
• 1. Determine the equivalent impedance and the equivalent admittance. 2n -j40 Zeg jon -jsn ele
In A.C resistive circuit both the current and voltage phasors are O None of the choice O Current leads the voltage O current lags the voltage OIn phase
A 206.0-2 resistor and a 2.80-µF capacitor are connected in series across the terminals of a sinusoidal emf with a frequency of 150 Hz. The inductance of the circuit is negligible. What is the impedance of the circuit?
Desian aproblem for wye delta thaasform adions Determinc. the eauivalend resistance betreen the terminals A and B
In star connection three phase reactive power is
Desian aproblem for wye deltatransform ations Defrminc the eauivalend resistance betreen the terminals Aand B
Question A 50 Hz, bar primary CT has a secondary with 500 turns. The secondary supplies 5A current into a purely resistive burden of 10. The magnetizing ampere-turns is 200. The phase angle between the primary and secondary current is A 4.6° B 85.4° C 94.60 D 175.4°
If all resistors has a value of 4 ohm and inductive reactances, are j82, what is the total resistance across terminal AC. E G H 12 + j24 3 + j4 O 3 + j6 4 + j8 ellle
A elearning.adpoly.ac.ae * Question Completion Status: QUESTION 16 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in parallel. What is the total inductance? O Without knowing the coupling factor the total inductance cannot be found. O 45mH. O5 mH. QUESTION 17 E-06, PC-04. The time constant in an inductive circuit is the time required for the current to reach? O 70.7% of maximum value. O 63,7% of maximum value. O 63,2% of maximum value. QUESTION 18 E-06, PC-01. When more than two inductors of different inductance are connected in parallel in a circuit, the total inductance is? O Less than the inductance of the lowest rated inductor. O Equal to the sum of the individual inductance. O Equal to the inductance of the highest rated inductor. QUESTION 19 E-06, PC-02, Three inductors 15 mH, 15 mH and 15 mH are connected in series, What is the total inductance? Click Saue and Submit to save and submit. Click Save All Answers to save all answers.
the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a phase to ground c. none of the answers O d. Between phases