please answer with full given and readable solution. will give like or upvote 7.16In the system shown in Figure 7.16, a three-phase short circuit occurs at point F.Assume that prefault currents are zero and that the generators are operating at ratedvoltage. Determine the fault current.GURE 7.1611 kV20 MVA 15%G₁30 MVA 5%(3 + j5) Ωoblem 7.163811 kV33 kV1:310 MVA 10%G₂F

To find the fault current in power system, first it is important to find the base value of voltage,…

In the system shown in Figure 7.16, a three-phase short circuit occurs at point F. 7.16 operating at rated Assume that prefault currents are zero and that the generators are voltage. Determine the fault current. 11 kV JRE 7.16 G₁ 30 MVA 5% 20 MVA 15% (3 + j5) Ω * blem 7.16 33 kV F 11 kV 1:3 10 MVA 10% G₂

In the system shown in Figure 7.16, a three-phase short circuit occurs at point F. 7.16 operating at rated Assume that prefault currents are zero and that the generators are voltage. Determine the fault current. 11 kV JRE 7.16 G₁ 30 MVA 5% 20 MVA 15% (3 + j5) Ω * blem 7.16 33 kV F 11 kV 1:3 10 MVA 10% G₂

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter7: Symmetrical Faults

Section: Chapter Questions

Problem 7.16P

See similar textbooks

Similar questions

A generator is having an impedance of 0.93 p.u., before fault occurs in it. What is the possibility of impedance during fault?
7. Two 440V, 60Hz, 6 pole, 30 AC generators are running in parallel. The first supplies the busbars with 525kW of power at a power factor of 0.79 lagging. The second provides the busbars with 415kW at a power factor of 0.96 lagging. An additional load that requires 275kW at a power factor of 0.89 leading is added to the busbars. The two generators have their governor and magnetization controls adjusted so they provide 440V, 60Hz and share the active and reactive powers equally. What is the active and reactive power produced by each and their line currents and speeds?
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit.
15) Kirchhoff's Voltage Law (KVL) states that A) the product of the phasor voltages around any closed path must equal zero. B) the sum of the phasor voltages around any closed path does not have to equal zero. C) the sum of the phasor voltages around any closed path must equal zero. D) the sum of the phasor voltages around a closed path cannot include "through the air."
the two alternating e.m.f.s would reach their maximum and zero values at the same time such alternating voltages or (currents ) said to be: Phase with each other In phase with each other
The primary is 3000 turns, while the secondary is 6000 turns a. single-phase b. double-phase c. step-up d. step-down
A 100-MVA synchronous generator supplies 62.5 MVA of power at 0.8 lagging power factor. The reactance between the load and the generator is normally 1.0 pu, but it increases to 3.0 pu because of a sudden three-phase short circuit. The fault is subsequently cleared and the generator then supplies 43.75 MVA at 0.8 lagging power factor. Determine the critical clearing angle. Select one: a. 88.58 b. None c. 78.58 d 68.58
Transformers
The regulation of an alternator is likely to be negative in case of resistive load O True O False
The reactance of the synchronous generator after few cycles of short circuit is The sequence components have same voltage magnitude.
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance 5H. The circuit breaker interrupts a magnetizing current of 5 A (peak value). Arrangement shown in figure V-79 kV L-5 H 0000 R-790 www CB CH0.32PPC Fault (F)