"In the experiment to measure the capacitance (C) of a capacitor, the capacitance comes out to be 1800 microfarad and Resistance (R) = 11000 ohm. Find out the capacitive time constant." O 19.8 seconds O 19.8 minutes O 13.4 seconds O None of these

"In the experiment to measure the capacitance (C) of a capacitor, the capacitance comes out to be 1800 microfarad and Resistance (R) = 11000 ohm. Find out the capacitive time constant." O 19.8 seconds O 19.8 minutes O 13.4 seconds O None of these

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 55P: An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations...

See similar textbooks

Related questions

Q: For circuits used for transporting electric power, a low power factor implies large power loss in…

Q: Given a frequency of 60HZ, determine the value of the voltage at time t=1s of the voltage source e =…

Q: The capacitor in the circuit shown is initially uncharged and the switch is closed at t=O. 1. What…

Q: Create a circuit with four resistors linked to a source (EMF = 10V), where R1 and R2 should have the…

Q: (!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION R GIVEN HERE. In the circuit shown in the…

Q: How can a color- blind person determine the value of a resistor, using only the color code?

A: In this question we have to answer how can a color- blind person determine the value of a resistor,…

Q: "In the experiment to measure the capacitance (C) of a capacitor, the capacitance comes out to be…

Q: for this circuit : 3µF 4ΜΩ E=12V a) the maximum value of Capacitor C b) the maximum value of Current…

A: Answer only to part D is provided here , because only part D was asked to be answered.

Q: ind the voltage across the capacitor as a function of time for t>0 for the circuit in Fig. .72.…

A: Given: Voltage V=20 V resitance R1=5 ohm, R2=1 ohm L=0.25H, C=1 F To find: Voltage Across the…

Q: Hame Work se PiJ A series Circuit consists of three resistors R=25k R2 = 65ksn, R3=80 k.17 the…

Q: A capacitor is connected in parallel with a load of S= 6000 VA, and pf=0.8 lag. The load is…

A: Write a given value of this question. V=180Vf=60Hzpf=0.8lag Apparent power. S=6000VA

Q: If an incandescent light bulb is connected to a 120 V, 60 Hz electrical outlet, how many times per…

A: A sinusoidal current has a waveform similar to a sine waveform. Therefore in one complete…

Q: A circuit connected to a power supply with potential of, = 1.2 kV consists of three identical…

Q: A capacitor having a capacitance of 40 uF is connected across 250 V DC source. The charging current…

A: Charging current will drop to zero when-(c) capacitor is fully charged. It is because when capacitor…

Q: Two capacitors are connected in parallel across a 24-V ms, 7.5-kHz sine-wave generator, and the…

Q: Rank, in order from largest to smallest, the potential differences (AVc)1 to (AVc)4 of these four…

A: The potential difference across a capacitor is defined as ∆V=QC Then potential differences across…

Q: The figure below shows a capacitor, with capacitance C = 20.0 µF, and a resistor, with resistance R…

A: The time constant of a circuit is defined as the time taken by the circuit or system to respond to a…

Q: Consider a capacitor of capacitance C that is being discharged through a resistor of resisiance Ras…

A: Given,

Q: S R1 C R2 = 1N and 3. Given that the battery has a potential of 12 V, resistors R1 R2 3N, and…

Q: Consider the following two circuits with identical batteries and re- sistors. A B C R R RS R If the…

Q: (!) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION R GIVEN HERE. In the circuit shown in the…

Q: A circuit is made with the components: capacitor, resistor, battery and switch, all in series. The…

Q: Hi, here's my question. 26.40: In the figure, a battery (e=36.0 V), resistor (120 W), and a…

A: Given:Emf of the battery = 36 VResistance = 120 ohmCapacitance = 5 mF

Q: The timing device in an automobile's intermittent wiper system is based on an RC time constant and…

Q: Determine the range of values for the input voltage that will keep the value of the load voltage…

Q: R1 R3 R R5 In the above circuit, R1 10Ω, R. =40Ω, R3 = 300, R4 = 200, R5 = 600. The battery voltage…

Q: In a parallel electrical circuit, the same current flows through each component, whereas the…

A: A circuit in parallel connection has two or more ways for current to flow through the circuit.

Q: To get the maximum current, the connection should be in parallel. If you create a parallel…

A: This question is based on Current Electricity topic. The effective Resistance formula for parallel…

Q: The figure below shows a capacitor, with capacitance C = 30.0 uF, and a resistor, with resistance R…

A: In an RC circuit , the the maximum charge acquired by the charged capacitor will be at time t=0 sec…

Q: Different circuit properties are represented in the following plots as functions of time t after the…

Q: Imagine that we had a RC circuit with a 19.2 kilo-ohm resistor connected in parallel with a 16…

Q: 2. A 12.4-µF capacitor is connected through a 0.895-MQ resistor to a constant potential difference…

A: Capacitance C=12.4 μF Resistance R=0.895 MΩ Applied potential difference V=60 V

Q: PartII S, R c) We take the capacitor with only new material (x) and setup a series circuit with…

Q: A circuit has a 27 millifarad capacitor in a loop with a 127 ohm resistor and nothing else. At t = 0…

Q: "In the experiment to measure the capacitance (C) of a capacitor, the capacitance comes out to be…

A: C = 2400 microfarad R = 9000 ohm

Q: *64 A capacitor with an initial potential difference of 100 V is dis- charged through a resistor…

Q: A capacitor having a capacitarce of 10 uF is connected in series with a non- inductive resistor of…

A: For an RC circuit, The current(I), Real Power(P), complex Power (S), and phase difference angle (ϕ)…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

"In the experiment to measure the capacitance (C) of a capacitor, the capacitance comes out to be 1800 microfarad and Resistance (R) = 11000 ohm. Find out the capacitive
time constant."
O 19.8 seconds
O 19.8 minutes
O 13.4 seconds
O None of these

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Figure 21.55 shows how a bleeder resistor is used to discharge a capacitor after an electronic device is shut off allowing a person to work on the electronics with less risk of shock, (a) What is the time constant? (b) How long will it take to reduce the voltage on the capacitor to 0.250% (5% of 5%) of its full value once discharge begins? (c) If the capacitor is charged to a voltage V0through a 100-O resistance, calculate the time it takes to rise to 0.865V0(This is about two time constants.)
(a) F ind the voltage drop in an extension cord having a 0.0600-O resistance and through which 5.00 A is flowing. (b) A cheaper cord utilizes thinner wire and has a resistance of 0.300 O. What is the voltage drop in it when 5.00 A flows? (c) Why is the voltage to whatever appliance is being used reduced by this amount? What is the effect on the appliance?
An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?
earning Portal Courses Reports - e-Services - Academic Departments - ETC CIMS - During an experiment to verify Ohm's law, the voltage supplied and the current through a circuit are measured. [Voltage is measured in Volt (V) and current in Ampere (A)]. ww R Battery The measured value of the current is I = 3.5 ± 0.1 A and that of the voltage is V = 13 + 0.5 V. The resistance of the circuit (in Q) can be calculated using the formula, R = V/I, Calculate the, a) Resistance (in Q) = b) Fractional uncertainty in the resistance = C) Absolute uncertainty (in Q) in the resistance= Finish atten
Consider the following circuit: 15 μF 5 µF 10 µF 1. Find the equivalent capacitance of the circuit. 2. What is the charge stored by the 12 µF capacitor? 3. What is the voltage across the 5 µF capacitor? 4. What is the energy stored by the 15 µF capacitor? 20 μF 25 μ 8 µF 4 µF 12 µF IHH 40 V
Compute for the total energy of the entire circuit. Select one: a. 128.42 micro Joules b. 352.12 micro Joules c. 273.56 micro Joules d. 478.08 micro Joules
The capacitor shown below has an initial voltage of 0.15 V before the switch is closed. The resistance is 8.5 x 106 ohms and the capacitance is 2.0 microfarads. How long after the switch is closed in seconds does it take for the voltage across the resistor to drop to 0.083 V? R CH B A D
Te-Learning Portal Courses - Reports e-Services ▼ Academic Departments - ETC - CIMS Salim During an experiment to verify Ohm's law, the voltage supplied and the current through a circuit are measured. [Voltage is measured in Volt (V) and current in Ampere (A)]. ww R on Battery The measured value of the current is I = 3.1 ± 0.2 A and that of the voltage is V = 14 0.5 V. The resistance of the circuit (in N) can be calculated using the formula, R = V/I, Calculate the, a) Resistance (in 2) = b) Fractional uncertainty in the resistance = c) Absolute uncertainty (in 2) in the resistance=
The question is . A) What is the time constant for the circuit shown in the figure below if the value of of e=12.0 V, R=22.8ohm, and C= 88.1mF. B Suppose the switch is closed and the capacitor starts to charge. How much of the charge will be accumulated on each plate of the capacitor after 3 s of charging.. Submit answer the value of the charge (in mC, with two decimal places).
(c) For the circuit shown in Figure Q1 (c), find the unknown quantities (Voltage E, Currents I l2, I3 and R3) using the information provided. 2 A E ま6n U 6 R RT P = 12 W Figure Q1 (c)
QUESTION 6 a) What is the time constant for the circuit shown in the figure below if the value of ε = 12.0 V, R = 21.4 ohm, and C = 39.1 mF.? b) Suppose that the switch is closed and the capacitor starts to charge. How much of the charge will be accumulated on each plate of the capacitor after 3 s of charging? Submit the value of the charge (in mC, with tho decimal places) as your answer.
R1 R2 (ampere) R3 V(volts) For the Voltage-Current graph shown, R3>R2>R1. Select one: O True O False ere to search 近