Answered: In matlab, To obtain voltage and…

In matlab, To obtain voltage and current waveforms from transmission line which tool can be used O a. voltage measurement O b. Three-phase VI measurment O c. Series RLC branch O d. Parallel RLC load

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 22RQ

See similar textbooks

Related questions

Q: a/From Short Circuit test delta find Zea, Rea, Xea for the rated Current At Sbor Circuit test Is.c…

A: In a Short circuit test/ block rotor test low voltages is applied due to which rotor is not able to…

Q: In a star connected system the phase angle between line and phase voltage is 30 degree. Select one:…

Q: la the balanced three phase paralel cireuit belew, complete the tablen uing the previded valus…

Q: In a star connected system, the three phase currents are mutually displaced by 120 degree. Select…

A: In star connected systems each phase is differ by 120 degrees apart. Ex: Phase A current : Ia= Ia at…

Q: A 3-phase motor is rated at 100VA 0.9pf lag when operated with 100V 60Hz. The motor must be operated…

Q: Three Impedances each of (10 – j16)Ω are connected in mesh across a three-phase 415V ac supply.…

Q: 22 CS Scanned with CamScanner

Q: A 415 V, 55 Hz 3-phase supply is connected to a 3-phase star connected balanced R-L load each of…

Q: 132 IoA 1172 エAG 12 www エらら 1BC 20L-90°y -J992 204 30V ひtl A ICA -j99n IcC al Find the load current…

A: A)find the load current=?…

Q: 13. What is the value of reactive power, if the angle between star connected three phase 415 V a.c…

A: Given, Star connected three phase ac supply has, Line voltage, VL=415 V. Line current, IL=5.2 A.…

Q: Two single-phase alternators are connected to a 50-Hz bus-bars having a constant voltage of 10 ∠ 0o…

A: Bus bar frequency, f = 50 Hz Bus bar voltage, V = 10 ∠0° kV Generator A induced e.m.f, EA = 13…

Q: Overhead power transmission lines are Select one: O a. Three phase two wire O b. Three phase four…

A: we need to answer overhead power transmission lines are of which type ??

Q: 22 (a) Three-phase generator consist of three set of single-phase generators, with voltages equal in…

Q: A three-phase supply is generated, when the three coils are placed in 120 degree apart. Select one:…

A: Three phase supply is produced when three coils are positioned at 120 degree apart in a piulsating…

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377…

Q: A 3-phase motor is rated at 100VA 0.9pf lag when operated with 100V 60Hz. The motor must be operated…

Q: In a 390V, 57 Hz, three phase system, the value of the reactive power without capacitor bank is…

A: Reactive power supplied by capacitor=reactive power power to load without capacitor-reactive power…

Q: 9. The phase angle between the phase voltage and the line voltage of a A-connected gener degrees.

A: As per our guidelines we are supposed to answer one question, kindly repost further questions. 9)…

Q: For a 3-phase ac device, full load current is 40A, line voltage is 450V and reactance value is…

Q: 415 V, 54 Hz 3-phase supply is connected to a 3-phase star connected balanced R-L load each of…

Q: 2A 10V 52 4A 22 '6Ω

A: There are three nodes in the circuit, the left node says node1, the middle node says node 2, and the…

Q: What is the phase sequence of a three phase motor for which Van=220∠-100V and Vbn = 220∠140V? Select…

A: Phase sequence is the sequence on which voltages are appeared. If phase sequence is ABC then we say…

Q: A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R…

A: In RL parallel connection branch resistor and inductor are connected in parallel with each other and…

Q: Three loads, each of resistance of 20 Q and inductance of 120 mH are connected in star with a…

Q: In a 3-phase - Y- connected generator, each phase voltage has a magnitude of 90 Vrms, what is the…

Q: A 3-phase motor is rated at 100VA 0.9pf lag when operated with 100V 60Hz. The motor must be operated…

Q: A three phase load has a rating of 200 KW, 4000 volts, 0.7 power factor lagging and a frequency of…

A: The solution can be achieved as follows.

Q: Determine a. total impedance b.,. current Ip and c. total power drawn by the circuit

Q: Q2/ o.l H 150 uf 102 For the cct shawn Pind I,0, VR, Ve, VL » phaser 200v 50HZ Q3/ For the cct shown…

Q: 5. A three phase load of operates at 0.707 pf lagging. A synchronous condenser having a pf of…

Q: Why tertiarv winding is used? Select one a To connect static capacitors for reactive power injection…

Q: An AC circuit with R, Land C in parallel, has the following branch currents. Resistive branch - 12 A…

A: The solution can be achieved as follows.

Q: = 7200 ∠ - 130 ° V VBN = 7200∠110 ° V? Also, find VCN

A: The sequence components are equal in magnitude and displaced by 120 degree. The angle between the…

Q: Q13. The input voltage wavef orm of single phase bridge is having only DCcomponent. O True O False

A: The input voltage waveform of single phase bridge is having only DC component?

Q: A balanced 3-phase load comprised of a 1002 resistor in series with a 1H inductor is connected to a…

Q: 20. If you stub a motor winding, you A. reinforce the insulation. B. form phase-pole groups.

A: Insulation in slots is no need to change or reinforce. If motor winding is stubbed then it should…

Q: From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri…

A: Given Vp = 120 Rms Transformer ratio is N1:N2 = 6 :1 Find Vsec

Q: Q3/ Fincd Yt,ZT, V, G, phaser f (R,Ie, エァ」Ur) Ip:2120 mA 20k

A: For total impedance ZT take parallel combination of 10k and 20k…

Q: Analysis Problems: Prob 1. What will happen in each of these systems to the phase voltages of the…

A: In the given problem the one of the phases of the delta and wye circuits are open. Their effects on…

Q: Q21-7he Line Volta8es at the terminal of abalanced Yeomected Lood 15 VAB=1206 Each Phase of the Lood…

A: Line voltage at load terminal is VAB=120∠0° Impedance for each phase=10∠30°ohm We know that…

Q: The rated single phase supply in Oman is Select one: O 230 V, 60 Hz O 440 V, 60 Hz O 440 V, 50 Hz O…

A: Single phase supply is generally used in household networks. It has one Line wire and one ground…

Q: Problem: For the cct shown draw the phaser diagram. 60 Q VR VL 14 V = 220 Sin 314 t

A: We need to draw phasor for given circuit

Q: For a 3-phase ac device, full load current is 50A, line voltage is 400V and reactance value is…

A: Note: Since you have not specified any question to be answered, as per our honor code, we are…

Q: A three phase system has a supply voltage of 440v, current supplied 120A and a power factor angle of…

A: Given data: Vs=440 V Is=120 V θ=5o Solution: Reactive power is obtained by the below formula,…

Q: 100 A 220 V 50 Hz 0.138 H f(x) = 0 90 ohm Solver Configuration Electrical Reference

Q: 29. Obtam FIR Lineas phase and cascade deali zation of the system function - It

A: The transfer function of an FIR system is given. The same can be implemented using delays,…

Q: A three phase motor draws 30 kVA at 0.80 power factor lagging from a 480 V three phase generator. It…

A: In this question we need to find a capacitor bank rating use to increase the power factor from 0.8…

Q: For the admittance locus diagram shown below: find the value of each element in the circuit if w=377…

A: Equivalent Electrical Diagram: for first branch:…

Q: A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

In matlab, To obtain voltage and current waveforms
from transmission line which tool can be used
O a. voltage measurement
O b. Three-phase VI measurment
c. Series RLC branch
O d. Parallel RLC load

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
Ohmic components have a V-I curve O Non-linear VI curve. Parabolic VI curve. Sinusoidal VI curve. Straight line VI curve.
In case RL load, it is desired to get an average load voltage of 75 V. Determine the firing angle if the ac supply voltage is 200V per phase. If the load resistance is 302, calculate the average load current and power. Design the thyristor. 4-
1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c source. What must be the value of the capacitance to be connected in parallel to the circuit to raise the power factor to 0.96 lagging. Draw the circuit diagram.
Which cannot be said since Z is an inductive load in the circuit given below? A) load voltage period is 0.02sec. B) Load voltage peak value is 311V. C) Load voltage frequency is 50Hz D) Load voltage average value is 220V.
4. Design the network in the figure to have the following characteristics: i. BW - 500 Hz ii. Qp = 30 iii. Vemax = 1.8 V 0.2 mA Z0° C7 R, = 0 N
.H.W Show the voltage waveforms across each half of the secondary winding and across RL. • Find the average value of the full-wave rectified voltage in Figure. ● 120 Vrms elller 4:1 D₁ WI RL 1.0 ΚΩ
The distribution factor for 90 slots, 10-pole, 3-phase winding is A 0.90 B 0.895 C 0.959 D 0.978
In star connection three phase reactive power is ?
In a series AC resistive circuit: a) voltage leads current by 90°(degrees). O b) current leads voltage by 90°(degrees). © current and voltage are in phase. d) d current and voltage cancel.
148 Determine the rms value of the voltage waveform shown in Figure 14-24. vít) WW 18 24 12
6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll