In ladder logic, the only way to implement the Boolean equation OUT1 = IN1+ IN2 is (Hint: Demorgan's theorem) IN1 IN2 OUT1 IN1 IN2 OUT1 IN1 OUT 1 IN2 IN1 IN2 OUT1

Q: Five identical circuits having 20 dB S/N ratio each are connected in tandem with each other. What is...

A: The solution is given below 

Q: P 10.8-8 Determine the voltage v(t) for the circuit of Figure P 10.8-8. Hint: Use superposition. Ans...

A:

Q: Without bypass capacitor CE, determine the new voltage gain ... vc R1 Ro Co Q1 HE RE Zi - 1145.66 oh...

A:

Q: Fill in the blanks: 12 V Si GaAs 4.7 k2 Vo= V, 1 decimal Which diode is OFF? Si or GaAs

A:

Q: Calculate the current I for the network given below Si -10 V KK Ge 1.2 ka ... 3.3 K2 Ge Si 1.2 k2 Va...

A: We need to find out the current for given circuit

Q: Y(s RO) Et

A: Given       Signal flow diagram shown 

Q: A Moving to estion 11 The current gain(a) is greater than the current gain(B). True False thor quest...

A: According to the given question, it is required to determine whether the given statement is TRUE or ...

Q: When solving in AC Analysis, a negative sign in the voltage or current gain means that the output is...

A: When we get negative sign in output voltage it means that output is 180 degrees out of phase to inpu...

Q: Consider an input x[n] and a unit impulse response h[n] of a discrete-time LTI system given by: h[n]...

A:

Q: 2) What is your value the coefficient A? How does it compare to the theoretical value of: = 9 x 10-5...

A: Given curve shows current in RC series circuit while charging.   It is asked to find coefficient A a...

Q: Write the differential equations for this circuit then change this circuit so that The voltage at V...

A: The given circuit diagram is shown below, Here,V2=9.0 VRipple = 500mVppf=60HzVp=20Vα=45°

Q: In the figure is shown a battery having an emf of 12 Volts and an internal resistance of 0.40 Ohm. ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: What are the problems in an ordinary op-amp integrator?

A:

Q: 3) Find The transient currentin KLC urui1 C: 0. 125 farad -|c L: 8 henrys E= 300 cos at volts

A:

Q: 3. A conductor whose diameter is 0.175 inch has a resistance of 0.5 ohm. The wire is drawn through a...

A:

Q: If the secondary of the transformer is step down, the primary will have More turns Fewer turns O Hal...

A: In this question we will write about step down transformer primary and secondary winding  turn relat...

Q: Quèstion 11 The current gain(a) is greater than the current gain(B). O True False A Moving to anothe...

A:

Q: Answer the ff. What are the problems in an ordinary op-amp integrator? Why op-amp integrator output...

A: Note:  As per the  guide lines of the bartleby we are supposed to solve 3 questions, when they are  ...

Q: 12 V Si GaAs 4.7 k2 ID= mA Which diode is ON? Si or GaAs

A:

Q: Explain the operation of a full subtractor with necessary diagrams. What is the difference between h...

A: Full Subtractor : It is is a combinational circuit that perform subtractor it consist three bits. It...

Q: 10 20 30 E7v }7 A ig 2 310 20

A:

Q: Predict how the operation of this clipper circuit will be affected as a result of the following faul...

A: In the positive half cycle of input , the diode should be On ( means diode acts as short ) Output is...

Q: 11. Find the value of Rd if Vi 5mV and Vo = -58.16 m V. %3D +20 V Rd 82 MQ IDss = 12 mA Vp =-3 V la=...

A:

Q: 5Ω ww 6Ω ww 20Ω 600 100 40 a 15 0 300 15Ω

A:

Q: 10) Calculate the current through each resistor and voltage across each resistor. 32 0 50 0 200 + 30...

A: Given circuit,

Q: SKR a Si * se 12V IK

A:

Q: Provide your complete solution and formula. Sample Problem: [ EE Board October 1999 | The instantane...

A: According to the given question, it is required to find the rms Voltage for the below given instanta...

Q: using the conventional current flow, where is the direction of the current during the positive cycle...

A: The solution is given below 

Q: 1. Sketch the waveform of vo. Indicate the maximum and minimum values. R 10 Vpx E 4 V

A:

Q: 12 a ww 32 V 12 2 2 A RL Copyright O McGraw-Hill Education. b ww

A:

Q: 10 u(t) A 1/20 F

A:

Q: (1) Three point charges lie along a straight line as shown in the figure, where q, = 6.00 µC, 92 = 1...

A:

Q: (20+j12)= ( 10- j6)=(4+J5)#(2+j3) = Z. (45-J co) - ( 30 +j 10) =(5+ ja) = 5, (120+ J 100) + (1110+ 1...

A:

Q: For the circuit shown, assume ß = 100. Find the value of Rp so that Vca = 4V, and find the operating...

A:

Q: The current through an element is shown in Fig. 1.26. Determine the total charge that passed through...

A:

Q: a) Draw nominal - T model of Transmission Line. b) Write ABCD Parameters of the nominal T m...

A: Solve the problem

Q: We would like to sample the signal x (t) = cos(4rt). What is the smallest frequency, in Hz, that cou...

A: This question belongs to communication system . It is based on the concept of sampling frequency for...

Q: 60 V 12 A -30 V Q3/ (7 Marks) In Fig.1, the potential of pointA is -30V. Using Kirchhoff's voltage l...

A:

Q: Predict how the operation of this clipper circuit will be affected as a result of the following faul...

A:

Q: An impedance coil is connected in series with a capacitor across a 120 V, 60 Hz ac supply. The circu...

A: The solution is given below 

Q: With a neat logic diagram and shifting table, explain the shifting of given bit stream 1011001 enter...

A:

Q: Analyze the encircled symbol. * 1 9.

A:

Q: 4. A certain common-emitter amplifier has a voltage gain of 100. If the emitter bypass capacitor is ...

A: As per our company guidelines we are supposed to answer only first question kindly repost other ques...

Q: a. Use the node-voltage method to find v, and the power delivered by the 2 A current source in the c...

A:

Q: 50 10Ω 4Ω 5 io 5 i, v 20 N v§ 40 N v 96 V 11.5 i,

A:

Q: Q1) Reduce the block diagram shown below and write the transfer function C(s) /R(s) Cls) G2 (s) Ge G...

A:

Q: For the following circuit, draw the output signal. D- A- B- Y. B.

A:

Q: 2. Draw and explain the difference between clipper circuit and clamper circuit output waveform

A:

Q: d. For the feedback amplifier,. determine the base, emitter, and collector voltages of each transist...

A:

Q: 4. When two coils having inductances of 5H and 4H respectively were wound uniformly onto a non-magne...

A: We need to find out coupling coefficient.

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.