In dc generator,is used tocollect current and send it to the externalcircuit.О yokebearingsbrushescommutator

Solution : Here there asking the function of one of the part of the DC generator circuit.…

Answered: In dc generator, is used to collect…

Engineering

Electrical Engineering

In dc generator, is used to collect current and send it to the external circuit. O yoke O bearings brushes commutator

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter33: Single-phase Motors

Section: Chapter Questions

Problem 36RQ

See similar textbooks

Related questions

Q: A 4 pole, lap wounded, de generator has 42 coils with 8 turns per coil. It is driven at 1200 R.P.M.…

A: Given, P=4N=1200 rpmϕ=21 mWb

Q: Suppose for designing a diesel engine power plant you have brought a diesel engine & an 8 pole…

A: No of poles, P= 8

Q: A 3-phse 400kVA 6.6kV 1500rpm 50Hz alternator is running in parallel with infinite bus bars. Its…

A: According to the question we have to find synchronizing power and torque per unit mechanical angle…

Q: A correctly adjusted single-phase 240V, induction watt-hour meter has a meter constant of 600…

A: Given values, Voltage, V= 240 volt Current, I= 10 A Power factor, cosϕ= 0.8 lagging Meter constant,…

Q: The shaft of a three-phase synchronous generator is rotating at 1800 RPM synchronous speed. This…

A: In this question , we will find total loss and torque induced in generator....

Q: is 5 0. The infinite bus voltage is 10 kV. If the generator delivers its rated power at 0.8 power…

Q: The ohmmeter registers the value of the resistances as follows: Ra= 0.02 ohms; Rf= 80 ohms; Rse=0.03…

A: To determine the load current delivered in a short shunt compound generator

Q: 1-Which function we call for three phase short circuit occurs in synchronous generator armature…

A: When a fault is taking place on a 3 phase system the electrical quantities are severely unbalanced.…

Q: Which of the following is essential condition of paralleling two DC generators? Equal currents Equal…

A: According to the question we have to discuss, the condition for the parallel operation of the two DC…

Q: The emf generated by a dc generator depends upon the number of conductors only. Select one: O True O…

Q: Under equilibrium condition in a power system, the difference between rotor angle between any two…

A: Rotor angle defines the stability of interconnected synchronous machines so that they do not lose…

Q: In a three phase cylindrical rotor alternator, the resultant armature reaction MMF behaves like a…

A: Armature reaction in three phase alternator: Armature reaction in any machine is the distortion in…

Q: A three phase motor can run without neutral connection. Select one: O True O False

A: Three phase induction motor is balanced three phase load.

Q: A 500 KVA, 1100 V, star connected alternator has an effective armature resistance of 0.2 Ω per…

Q: A 220 V,50HZ, 4 pole single-phase induction motor gave the following equivalent circuit parameters :…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: A shunt generator running at 1000 r.p.m. has generated e.m.f. as 400 V. If the speed increases to…

Q: A hydro generator on the Jordan Valley has a rating of 1 MW, 1000 rpm. Then, the number of rotor's…

A: Given: A hydro generator in Jordon valley has a rating of 1 MW , 1000 RPM . To find the number of…

Q: Two alternators are operating in parallel and sharing a common load. For increasing the load shared…

A: The explanation is as follows.the answer for the question is true.(a)

Q: A synchronous 3-phase 2 pole / 6Hz generator has a rotor of radius 57 mm, length of 180 mm and an…

Q: A 120 V, 60 Hz, single-phase induction motors 1 and 2 are connected in parallel. Motor 1 takes a…

Q: A three phase 500 MVA, 22 kV generator has winding reactance of 1.065 Ω. Find its per-unit…

A: Given,For a generator,MVA = 500kV=22Winding reactance = 1.065Ω

Q: A single phase,10.0 kw, 220V line-neutral, 60HZ, generator with 0.1 Ohms sync impedance operating in…

Q: A dc 4 pole wave wound generator is running at 1000 rpm having 1200 conductors and flux density is…

A: Given Data: Z = 1200 N = 1000 A = 2 P = 4 flux = 10 mwb

Q: A flat-compound DC generator is used when an essentially unvarying voltage is required True False

A: In this question we will write about flat compound generator...

Q: The distribution factor for a 36-slots, 4-pole, single layer, 3-phase winding machine is given as:…

A: Given, A 3-phase machine with, Total pole, P = 4 Total slots = 36

Q: A synchronous generator is rated 645 MVA, 24 kV, 0.9 pf lagging. It has a synchronous reactance 1.2…

A: Rating of the generator = 645 MVA Terminal voltage = 24 kV Power factor of the load = cos φ = 0.9…

Q: A 50 MVA, 11 kV, 3-phase generator has a stored energy of 400 MJ. Its inertia constant is?

A: Given a 3-phase generator with, MVA rating, S = 50 MVA Stored kinetic energy, K.E. = 400 MJ

Q: The difference between AC and DC generators. Provide also its operation, components/parts. and how…

A: AC GENERATOR : An alternating current generator (AC generator) is a type of electric generator that…

Q: c) Compute the no load line voltage of a star connected 4-pole alternator for the following data:…

A: Given data, The flux per pole =0.12Wb, Slot per pole per phase = 4 Conductor/slot = 4, Two-layer…

Q: A shunt generator running at 1000 r.p.m. has generated e.m.f. as 300 V. If the speed increases to…

A: This is a problem of electric machine The solution is shown in the next step

Q: To control a three phase motor from two different places we need two contactors. Select one: True…

A: To control the three-phase motor from two different places with the same power supply, a single…

Q: A 30kW series generator has an efficiency of 88% when operating at rated load. If the stray power…

Q: C shunt generator with the terminal voltage 375 V, arn

Q: In watt meter both voltage & current coils are energized to produce bidirectional torque. Select one

A: Choose the correct option The given Statment In watt meter both voltage & current coils are…

Q: 5. A 3-phase, 16-pole alternator has a star-connected winding with 144 slots and 10 conductors The…

Q: 1. A 40 MW water turbine is coupled to a 50 MVA 3-phase AC generator rated for 0.8 lagging power…

Q: The shaft of a three-phase synchronous generator is rotating at 3000 RPM synchronous speed. This…

A: Principle of Machine: In any electrical machine either it's a DC machine or AC machine, the EMF in…

Q: Q2) Three shunt generators operate in parallel and supply a load current of 12000 A, connected…

A: Given For Generator A Ega =450 VRga =0.02 Ώ For Generator B Egb =460 V Rgb =0.025 Ώ For Generator C…

Q: The power input to a 4160 V, 50 Hz, three-phase motor is 390kW and it operates with power factor of…

A: GivenInput volttage=4160vFrequency=50HzPower input=390KwPower factor=0.7 lag

Q: A 300kw , 250v, 8pole , generator has a simplex lap winding. Determine the voltage generated per…

Q: A shunt generator running at 1000 r.p.m. has generated e.m.f. as 250 V. If the speed increases to…

A: For general lighting, shunt generators are utilised. Because they can be designed to provide a…

Q: Q2) Three shunt generators operate in parallel and supply a load current of 12000 A, connected…

A: Applying KCL at node gives terminal voltage or load voltage. Armature current supplied by…

Q: A two-pole Y-connected synchronous generator rated at 470 kVA, 480 V, 60 Hz, and 0.85 PF lagging.

A: NOTE_ “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: A 3-phase, 50 Hz, 16 pole generator with concentrated windings has 144 slots with 10 conductors per…

A: we need to find out line emf.

Q: The following information is given in connection with an alternator: slots = 1.44; poles = 8; rpm =…

Q: Q2) Three shunt generators operate in parallel and supply a load current of 12000 A, connected…

A: We will apply KCL at node to find terminal voltage. Armature current=generated voltage- terminal…

Q: Q1. A single-phase motor is taking 10A at 0.8 lagging power factor from a 240V, 50HZ supply. What…

A: Given data: Vrms=240V I=10A PF=0.8 F=50Hz The reactive power consumed…

Q: DC Electric Machine: A 3-phase, 2-pole, round-pole and delta-connected synchronous generator with a…

A: Given data about a 3-phase delta connected synchronous generator: Number of poles P=2. Operating…

Concept explainers

Magnetic Moment

The magnetic moment is defined as the alignment of a magnet and its strength when the magnet is creating a magnetic field. There are number of examples of the magnetic moment, few are a current carrying conductor in the form of coil, elements at microscopic levels like electrons and many more.

Question

In dc generator,
is used to
collect current and send it to the external
circuit.
О yoke
bearings
brushes
commutator

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

3) 4 Pole generator has a wave wound armature with 32 conductor per slot. The flux per pole is 40mWb and the speed of the generator is 480rpm. Find the total number of slots to generate an EMF of 409.6V
A 4 pole generator with wave wound armature has 50 slots each having 22 conductors. The flux per pole is 0.01 Wb. At what speed must the armature rotate to give an induced EMF of 220V is,
A 4 pole dc generator with duplex wave winding has 48 slots and four elements per slot. The flux perpole is 2.5 x 10 Maxwells and the speed of the prime mover is 30 rpm. What is the average generatedarmature voltage? Neglecting brush drop.
A 4-pole lap winding generator with 16 slot, 42 conductor per slot, 480v runs at 1800rpm. Find the flux produced per pole
A 6 pole DC lap wound generator has 32 armature conductors with flux per pole is 44 mWb and the e.m.f generated is 74 V, then the speed of the machine is O 3.28 rps 0.33 rps 52.56 rps O 52.56 rps arch op
A 4 pole generator with wave wound armature has 55 slots each having 25 conductors. The flux per pole is 0.02Wb. At what speed must the armature rotate to give an induced EMF of 220V. What will be the voltage developed, if the winding is lap connected and the armature rotates at the same speed.
2. A synchronous generator is connected to an inductive load, please draw phasor diagram to show the relationship between the internal generated voltage of the generator and the terminal voltage across the load. If the same generator is connected to a capacitive load, please draw phasor diagram to show the relationship between the internal generated voltage of the generator and the terminal voltage cross the load again. Explain the difference of the terminal voltage responses at these two types of loads.
A 6 pole DC lap wound generator has 38 armature conductors with flux per pole is 42 mWb and the e.m.f generated is 78 V, then the speed of the machine is 48.87 rps O 3.87 rps O 0.39 rps O 48.87 rps When the load on a series generator is decreased, then the flux produced will be increased. Select one: O True O False
The type generator field winding is supplied from the external D.C. source. separately excited Compound Shunt Self excited
A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then line current is a. 2A b. 1A c. 9A d. 10A
A DC generator with 8 pole, duplex lap winding excited with a flux of 3mWb/ pole. The number of parallel path in the winding is A 12 B 8 C 16 D 4
The field system is the rotating part of the DC Generator Select one: True False