Q.4In BJT transistor VBE 0.7 V and V₁ = 25 mV and reverse saturation current ismA(TA).V10-13 A. Find the transconductance in

Answered: Image /qna-images/answer/0a281300-90d0-4f0f-837a-4a82233a5f9c.jpg

Answered: In BJT transistor V, BE = 0.7 V and VT…

In BJT transistor V, BE = 0.7 V and VT = 25 mV and reverse saturation current is 10-13 A. Find the transconductance in mA V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: From the following trifilar circuit let Van = Vnb = 120 ∟0° Vrms, determine: a.) InN b.) The active…

Q: A base current of 50µA is applied to the transistor in the given figure , and a voltage of 5V is…

Q: A circuit is to be biased at a current of 5 mA and achieve an input resistance of at least 1MΩ.…

A: To determine the circuit which is biased at a current of 5 mA and achieve an input impedance of at…

Q: The resistance of a certain copper wire is 0.5 Ω. Determine the resistance of a tungsten wire having…

Q: Determine the value of Ip for self bias p- channel JFET which has Ipss = 6mA and %3D VGs(off) = -…

A: IDss is the maximum current that can flow when vgs = 0. If we start applying negative voltage ( vgs…

Q: The D-MOSFET in the figure has: IDSS-10 mA. The drain to source voltage equals approximately: VDD…

A: Given, A D-MOSFET circuit is given below, The drain current in zero bias, IDSS=10 mA.

Q: circuit is built around a bi-polar NP?N transistor. The Base network has a resistor (RB) and diode…

Q: For a common-collector amplifier, RE = 1002, r'e = 102, and 30ac = 150. The ac input resistance at…

A: Given, Common collector amplifier in which RE=100 Ωr'e=10 Ωβ0ac=150

Q: Solve the emitter voltage of a voltage-divider bias circuit with Vcc=9V, R1=560k ohms, R2=560k ohms,…

A: Types of biasing for Transistor Fixed bias Self bias Voltage divider bias Collector bias Emitter…

Q: A) Assume ß=100, find Ic, B) the value of Rc so Ve = -3V C) keeping all other values from part B the…

A: Let's first check about the operating condition of device. Firstly I am going to check about emitter…

Q: A base bias method is used in the following circuit. For BDc 100, the value of collector current is:…

A: In the above circuit Firstly we need to find the value of IB and after that by using the formula of…

Q: Q-1: In Ge transistor circuit of the figure shown, Rg 500 KA, Rc = 2 KN, Rg 0, Vcc = -15V, ICBO =…

Q: Solve for the base current if collector current is 600 mA and the current gain is 20.

A: Given Collector current is 600 mA Current gain is 20.

Q: A base current of 50 μA is applied to the transistor in Figure below, and a voltage of 5V is dropped…

A: given data :Base current IB=50μA.Voltage drop across Rc=5V.Circuit diagram is given as,

Q: Transistor is said to be operated in saturation region when both EB junction and CC junction are…

A: MOSFET Metal oxide semiconductor FET

Q: (b) Find the drain current ID for various values of VGs = 0V, -3 and -6 V. The value of VGs(OFF) =…

Q: Given IDSS=12mA and Vp= -4V. Sketch the drain and transconductance curve for VGS = +2V, +1V, 0V -1V,…

Q: Determine Rc the circuit to operate with a saturation current of 8 mA using a transistor with a beta…

A: Given circuit is , Given Data : VCE=0.2Vβ=100 Saturation current Is=8 mA

Q: Listen A base bias method is used in the following circuit. For Bpc 100, the value of collector…

Q: The transistor shown in the crout below has a oument gain of p-100. You may assume the voltage…

Q: What are the operating regions of the transistors Qp and QN, respectively at point G? O Qp in…

Q: Design a DC bias circuit for an voltage divider amplifier circuit . Proved design…

A: Given, VCC=20 VVCEQ=8 VICQ=10 mAβ=80VBE=0.7 V

Q: C IDER A TWO- BJT CONFIGURATION IN FIGURE 1. You ASSUME THAT BOTH TRANSISTORS ARE THE SAME WITH SAME…

Q: The screen of a CRT is 60 cm from the centre of the plates. The parallel deflecting plates are of…

A: Given- Screen of CRT L = 60 cm, Length of parallel deflecting plates l=2 cm, Distance d=5 mm, Anode…

Q: 1. Chapter problem #2.11 For the circuit shown below, A) Find i B) Find the power supplied by the…

Q: BASIC ELECTRONIC Given Sketch the drain and transconductance curve for VGS = +2V, +1V, 0V -1V,…

Q: For the transistor in the Figure: B = 100 and VBE(ON) = 0.7V. +10 V The collector-emitter voltage is…

Q: B=100, thus a is equal to, Select the correct response: O 1.010 0.090 O 0.990 O 0.909 Common-Emitter…

Q: B = 100, Vcc = 12V, R₁ = 6.8k, R₂ = 2.7k92, Rc = 1kΩ, RE = 470Ω (The BJT can be assumed to be ideal)…

A: A BJT (Bipolar Junction Transistor) is a type of transistor that operates by controlling the flow of…

Q: In all of the circuits, the voltage of the Vin input signal is 200mVp and the frequency is 1KHz.…

A: We have given the following diagram In all of the circuits, the voltage of the Vin input signal is…

Q: Explain how the built-in potential is formed in the PN junction UTM

A: Consider a P type and N type material joined together as shown below, N-type material have excess…

Q: Which are the two junctions of a transistor? Emitter-base and Emitter-collector Emitter-base and…

Q: small

Q: 1. Draw the small-signal equivalent circuit and derive the input resistance of the bipolar…

A: Given: Brief description: In the above given question they have mentioned an NPN transistor…

Q: DEPAV/PAPPA, OP Q4: 4. For the following circuit, the value of Boc is 200. A) Calculate the…

A: In this question we will find collector current and collector to emitter voltage.....

Q: (P. 6) For a particular junction for which Co= 0.6 pF, Vo = 0.75 V, and m= 1/3, find C, at…

A: All the values are given as, Cj0 = 0.6 pF V0 = 0.75V m = 1/3 VR1 = 1V VR2 = 10 V. Cj = ?

Q: Solve the collector voltage of a voltage-divider bias circuit with Vcc=9V, R1=560k ohms, R2 = 560k…

A: We need to find out the collector voltage for given circuit

Q: The value of B DC is the ratio of collector current to base current O emitte current to base current…

A: Given: To define the value of βDC.

Q: Solve the Emitter Stabilizer Bias (BJT). Show your complete solution. 2 +24v Find Is 420knž 2.4 Okn…

A: We will find out current and voltage for given bjt circuit .

Q: According to the Compensation Regulation, the inductive reactive power should not exceed 20% of the…

A: Given Q =20%PQ=0.2 P

Q: Re 220 N Vex Vec 10 V Ra 10 kn Boc=200 OV-5 V

A: We need to draw collect characteristics curve ,

Q: The collector current Ic (see the circuit below) is:

A: The following circuit diagram is given:

Q: Assume for both transistors transistor current gain ß-30. Take VBE 0.7V. Design the value of RI such…

Q: a) List and explain the plannar process technology as applied to IC fabrication b) A circuit is…

A: a) There are multiple stages in plannar process technology as applied to IC fabrication Lithography…

Q: 14) Calculate the transconductance using the VGS values of -2V and –3V. For ID values of 2.5 mA and…

Question

Q.4
In BJT transistor VBE 0.7 V and V₁ = 25 mV and reverse saturation current is
mA
(TA).
V
10-13 A. Find the transconductance in

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A common source N-channel MOSFET amplifier has an RGl = 18M2, Re2=2M2. Rp= 1.2KQ, gm= 5mS and Vi = 3mVpeak, the output voltage of the amplifier when is equal to O -540mVpp O -18mVpp O -36mVpp O -1.44Vpp
Q-2: Explain the saturation of a transistor. Find the given unknowns for the figure below. a. Rc. b. Rg c. Rp. d. VCE e. V Also find the voltage V, at cutoff. 12 V 2 mA Rc 7.6 V V B-80 024 V Q-3: Define Lso and lao, How are they related? Find the following f le corresponding to V = +750mv and Va = +5V
Which are the two junctions of a transistor? a) Emitter-base and emitter-collector 10 b) Emitter-collector and base-collector c) Emitter-base and collector-emitter d) Emitter-base and base-collector (11 - 15) Select True or False
what is the small signal model? ro of the transistors approach infinity
22
Explain what happens at each of the nine steps of an 8 bit Successive Approximation Analog to Digital converter with a full output of 5V when measuring a 2.34 V signal.
A base bias method is used in the following circuit. For Bpc - 300, the value of emitter current is: -Vc. +15 V Rc 1.8 k2 RB 560 k2 7.82 mA O 6.84 mA O 7.27 mA
Using no analysis, what mode is the transistor in? VBB RC -5V, Vcc 20V, RB 1kN, and 1002. RC RB Vcc VBB
For Steady-State Operation o f Boost DC-DC Converter What is the duty ratio (D) How can it effects on the converter output (Vo)
C6 Shown in Figure C6 is a common emitter amplifier. Follow the specification below and calculate the value of R1 given the information provided. RC Voe vce Vbe vcc = 10 V, VE=1 v, VBE = 0.7 V, IC = 2 mA, B = 100, I(R1) = 10XIB, V(RC) = VCE = 4.5 v RI RL Ve Vbb Figure C6 Common Emitter amplifier with Potentiometer Bias A. No answers below are correct B. R1 = 13.5 ko C. R1 = 21.6 kO D. R1 = 8.5 kn
Calculate the collector currents and V CE voltages of transistors given below. (β=200, VBE =0.6V)
A silicon transistor is biased with base resistor method. If B=100, VBE =0.7 V, zero signal collector current IC = 1 mA and VCC = 6V, what is the value of the base resistor RB? Select one: O a. None of the above O b. 315 ΚΩ Ο c. 530 ΚΩ O d. 105 k