Answered: In an inductive circuit, What is the…

In an inductive circuit, What is the value of the instantaneous current if t=40 s.L= 10mH and v(t) = 5 cos(100nt – 100) %3D

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3RQ: A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted...

See similar textbooks

Related questions

Q: 14 A. Assume the inductance of the coil is 10.5mH, having the flux 0.2mwb developed in the coil when…

A: Given Data: I = 6 A L = 10.5 mH flux = 0.2mWb

Q: The energy stored in an 1400 turns inductor is 15 Joules, if the inductance value is 1 H. Find (a)…

Q: Q7. A coil with number of turns 1000 and inductance, 10.5H. Determine the following, i. Average emf…

Q: Calculate the inductive reactance, X₁, of a 2.5 H inductor when operated at a frequency of 50 Hz…

A: Given: Inductance, L=2.5 H Frequency, f=50 Hz

Q: Q1] find the current of the inductance 0.04H if the value of the source is: 3sin(100πt+30) volt…

Q: 7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform…

A: In an inductor voltage leads the current And in capacitor current leads voltage. The pahsor diagram…

Q: Mutual inductance between an infinite current filament placed along y -axis and rectangular coil of…

A: First calculate magnetic flux density due to infinite line and than find flux linking the given loop…

Q: QUESTION 3 An inductor with an inductance of .5 henrys (H) is to be connected to a 60 Hz circuit.…

A: For the given Inductance and frequency value, Inductive reactance is calculated as shown below

Q: 7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mH inductor. To…

Q: HW 2-17 Determine the capacitance of a conducting sphere of radius 5 cm deeply immersed in sea water…

A: The capacitance of conducting sphere is

Q: 57. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following…

A: This question belongs to circuit theory . It is based on the concept of ac analysis for circuit . It…

Q: What is the inductance of the coil whose resistance is 100 ohms if it draws 0.55 A from a 110 V. 60…

Q: A non-inductive resistor is connected in series with a coil across a 230V, 50Hz supply. The current…

A: Let 'R' be the non inductive resistor and a coil with resistance 'r' and inductance 'L' may be all…

Q: Mutual inductance between an infinite current filament placed along y-axis a rectangular coil of…

A: Find the mutual inductance of the infinite current filament and rectangular coil.

Q: Question 1 Inductive reactance opposes a sine wave current, thus reducing the current. True False…

A: If the voltage across an element is directly proportional to the time rate of change of current…

Q: A coil of 500 turns has a flux of 0.4 mWb linking with it when carrying a current of 2 A. Determine…

Q: A solenoid has an inductance of 1.58 mH. How many turns of wire does it have if the solenoid is 25…

A: To calculate the number of turns

Q: (b) Determine the equivalent inductance for the circuit shown in the following Figure 2: 20 H

Q: 14. i. Assume the inductance of the coil is 10.5mH, having the flux 0.2mwb developed in the coil…

A: 14 i)Assume the inductance of the coil is 10.5mH ,having the flux 0.2mwb developed in the coil when…

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt

A: The voltage across the inductor can be calculated by reducing the network and by using the voltage…

Q: The instantaneous current in an ac circuit is given by i = 50 sin ot 7 The current becomes 45 mA at…

Q: The current in a circuit falls to 0 from 16 A in 0.01 sec. The average emf induced in the circuit…

Q: Find the equivalent inductive reactance if the frequency is 61 Hz. L, 3 6 H 4 H 2 H 3 H Round your…

Q: A solid specimen of dielectric has a dielectric constant of 4.2 and tan 8 = 0.001 at a Frequency of…

A: Given: εr=4.2 tanδ=0.001 f=50Hz E=5KV/mm=5×104/cm

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

A: We need to find out diameter of wire for given inductance

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100|t) volt R3 R2…

A: Given figure,

Q: 19. The following table lists values for an inductive circuit. Complete the table. V ms Ims XL 12 V…

Q: Question 20 The average power absorbed by an inductor is zero. True O Neither Either O False

A: It is true.

Q: Three inductive coils each of reactance 87 ohms and frequency of 50 Hz, 420V supply. Calculate the…

A: Given: XL=87 ohms/coilsf=50 HzV=420 V

Q: Mutual inductance between an infinite current filament placed along y -axis and rectangular coil of…

A: From magnetic flux

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R1…

Q: Mutual inductance between an infinite current filament placed along y -axis and rectangular coil of…

A: we need to find out mutual inductance.

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R2…

Q: Question 8 Calculate the total reactance of three 10mH inductors all connected in parallel and…

Q: Which of the following best describes the instantaneous power consumed by an inductor? O Always zero…

A: Choose the correct option Which of the following best describe the instantaneous power consumed by…

Q: 28. Assume an inductor is connected to a 180-V AC line and the inductor has an induced voltage of…

Q: H.W 4: For the following pairs of voltages and currents, determine whether the element involved is a…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: A 200 V, 50 Hz inductive circuit takes a current of 10 A, lagging 30 degree. The inductive reactance…

A: Given a inductive circuit having, Source voltage, Vs=200 V Current, I = 10 A Angle, ϕ=30° (lagging)…

Q: Qlo. determine both normalized energy x power X (t) = 2 Sin (8rt) %3D

Q: 5. Below is an image taken from an oscilloscope: Knowing that the oscilloscope voltage setting is…

Q: An alternating voltage v = 100 sin 120pi t volts is applied across a coil of resistance 32 Ω…

A: Given: An alternating voltage is v=100sin120πt And coil of resistance R=32 Ω Inductance of coil,…

Q: 21. a conductor has a conductance of 70µS is used to supply a load. Find its equivalent resistance…

Q: Mutual inductance between an infinite current filament placed along y-axis and rectangular coil of…

Q: A circuit has inductance of 2h. If the circuit current changes at the rate of 10a/second, then self…

A: The inductance of the circuit is given as: L=2 H The rate of change of the current is given as:…

Q: Problem 3 a) In Figure 1, the current through a 550 nF capacitor is i= 12 x 10-3 A sin(2000t + 20°).…

A: In this question we need to find a voltage expression for capacitive circuit and current expression…

Q: 13. A coil has a resistance of 6 ohms and an inductance of 0.02 H. When a non-inductive resistor is…

Q: If the voltage across a 12 F capacitor is 14 t e-3t V, calculate the power at t = 23 ms.

Q: The energy stored in an 1400 turns inductor is 15 Joules, if the inductance value is 1 H. Find (a)…

A: Energy E=15J Inductor L=1H No of turns N=1400 a. Current flowing through the coil? b. Flux linking…

Q: The energy stored in an 1800 turns inductor is 10 Joules, if the inductance value is 4 H. Find (a)…

A: Energy stored =0.5 L×I2 Inductance=number of turns×flux current in coil. EMF =L×didt.

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

In an inductive circuit, What is the value of the instantaneous current if t=40 s.L=
10mH and v(t) = 5 cos(100nt – 100)
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
• The relationship between voltage and current in pure inductive circuit is, The current lags the voltage by 180 degrees The voltage lags the current by 90 degrees The current lags the voltage by 90 degrees The current and the voltage travel the same angle
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
Establish and analyze Ohm's Law applied for a capacitor in sinusoidal alternating current.
If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit be? Explain why. a) a pure resistor circuit b) a series or parallel R-L circuit c) a series or parallel R-C circuit d) a series L-C circuit
The current that varies sinusoidally with time. Blank 1
Problem 3 a) In Figure 1, the current through a 550 nF capacitor is i= 12 x 10-3 A sin(2000t + 20°). What is the sinusoidal expression for the voltage e? b) In Figure 2, the voltage across a 110 mH coil is e = 150 V sin(377t + 45°). What is the sinusoidal expression for I %3D the current i? i – - e e Figure 1 Figure 2 Page 1 of 2
Calculate the frequency a 15 V sinusoidal source should be set to so that a 800 mH inductor connected across it has an inductive reactance of 1350 Q. Answer: HzO kHzO MHz
a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor form for figure 1 is C)the impedance of the inductor for figure 1 is