In ac analysis of transistor biasing circuits, coupling capacitors should be open circuit

Q: discuss some design specification of a typical outlet.

A: Electrical outlets 15-amp duplex receptacles are the most popular electrical outlets; 15-amp outlets…

Q: 2- What is the amount of power saving in the AM-DSB-SC, when compared to other types of AM systems?

A:

Q: Discuss pcb design guidelines for reduced electromagnetic interference

A:

Q: does line current need Vrms or the given peak voltage to be

A: In this question we will write about line current....

Q: What basic steps are involved in a power quality evaluation procedure?

A: There is wide range of different phenomenon associated with  Power Quality, each phenomenon's have a…

Q: 2-What is the amount of power saving in the AM-DSB- SC, when compared to other types of AM systems?

A:

Q: With necessary sketch, Explain the mode of operation of chopper which is turn off due to external…

A: A chopper is a static device that converts fixed dc input voltage to a variable dc output voltage…

Q: 6. What is the main advantage of using a phase modulator rather than a direct frequency modulator?

A: NOTE: We are authorized to answer the first question since the exact one wasn’t specified. Please…

Q: 3. Why the copper loss in the primary can be neglected, in the open circuit test?

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Why input impedance of a MOSFET is very high?

A: In a typical MOAFET, the Gate terminal is seperated from the Source and the Drain terminal by a…

Q: why is the piv rating important for IS AN AC CIRCUIT THAT CONVERTS AC SIGNAL TO DC SIGNAL

A: The answer as given below steps:

Q: What is the ripple factor and what causes it? Discuss and explain how this factor can be used as a…

A: When a sinusoidal voltage is converted into dc, the output voltage waveform inherently contains…

Q: What point in a single-phase ac waveform is used as a reference point for timing the thyristor gate…

A: The thyristor is turned off at zero current. For resistive load zero current and zero voltage occur…

Q: How do I calculate the duty cycle of a full bridge DC bidirectional converter operating in bipolar…

A: We have to derive the expression for duty cycle of a full bridge DC bidirectional converter in…

Q: With necessary sketch, Explain the mode of operation of chopper which is turn off due to external…

A: A chopper is a power electronic device which is basically a dc to dc converter. It is a device which…

Q: about nyquist stability criterion in deatials

A: Need to find about nyquist stability criteria

Q: What scaling challenges and device performance improvements led to the change from planar MOSFET…

A: Transistor scaling: Scaling is a term similar to advancement or making progress. The semiconductor…

Q: What is the importance of phase inversion in transistor?

A: The explanation is as follows.

Q: Discuss the main fifferences between the Ac/DC circuit breakers?

A:

Q: Describe the over-all ac analysis procedure for a common collector.

A: The Common Collector Amplifier (CCA) is a bipolar junction transistor (BJT) with the input signal…

Q: Discuss uncertainty relating to voltage, DC-resistance measurements, and AC-impedance measurements.

A:

Q: Describe what coupling capacitors are and what are they for?

A: Question: What is a coupling capacitors Answer : Coupling capacitors are also known as DC blocking…

Q: What is load curve

A:

Q: Construction and analysis of common collector amplifier on Uni-train system

A:

Q: What is a short circuit explain simply for a dummy? What is an open circuit explain simply for a…

A: Short circuit means we have current flowing in the circuit in unintended path Open circuit means we…

Q: What is the term for total AC circuit resistance when dealing with AC inductors and capacitors?

A: According to the given question, it is only required to determine the term for total AC circuit…

Q: The dc load line on a family of collector characteristic curves of a transistor shows the

A: In this we will write about dc load line of collector characterestics  curves...

Q: 1- What is the amount of power saving in the AM-DSB-SC, when compared to other types of AM systems?

A:

Q: What can we eliminate negative parts of an AC signal, with and without using offset

A: Eliminate the negative part of the ac signal without using offset voltage  Using a positive clamper…

Q: For the common emitter amplifier circuit in Figure Q4(a), determine the low cut- off frequency for…

A:

Q: Describe different control schemes of AC regulators and derive the expressions of average and…

A:

Q: What are the advantages of AC bridges?

A: AC Bridge:                 The source, balanced detector, and four arms make up the ac bridge. The…

Q: Describe different control schemes of AC regulators and derive the expressions of average and…

A:

Q: In class C operation, the operating point is generally located above cut off point + of the DC load…

A: Bartleby has policy to solve only first question. For rest questions re-upload.

Q: . Discuss in detail about the line commutated converters and voltage source converters for DC…

A: Line-commutated converters (LCCs) It is the standard technologies that is used to convert electrical…

Q: 14. Short-circuit failure mode is associated with microcircuits, transistors, resistors and…

A: A short circuit failure mode causes is also known as steady state failure in this failure the…

Q: For a series ac circuit having resistive and reactive components, What does volt-ampere (VA) mean?,…

A: AC circuit any of the Resistive, inductor , capacitor circuit.  Let the voltage applied to the…

Q: Redraw figure for p channel case

A: The band diagram of the MOSFET of p-channel is shown below,       In above diagram, the conditions…

Q: Biasing in integrated circuit design makes use of what type of DC source? Explain.

A: In the Integrated circuit biasing the load circuit usually includes one or more additional MOSFET…

Q: Write about the uses and importance of twisted pair cable - crossover cable

A: Twisted pair cable :-  These cables have two questions insulated conductors which are generally made…

Q: Are there some part of the curves that has distorted signal? explain why

A: Filters, either time-domain filters or Fourier-based frequency decomposition, can be used to…

Q: please write introduction about AC Circuits and Parallel Circuits

A: Ac circuits Generally, series A.C circuits are of 3 types-      R-L series A.C circuit  R-C series…

Q: What is the injection ratio (emitter efficiency)? Why should it be as close to one as possible?

A: The injection ratio is the ratio of the emitter's electron current, to the total of the electron and…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.