In a single phase transformer, the primary winding resistance is 4 ohms while the secondary winding resistance is 12 ohms. If the primary current is 12 amperes and the secondary current is 4 amperes, the total copper loss is .. O a) 96 watts O b) 192 watts Oc) 576 watts O d) 768 watts

Q: а Full adder Y D carry-out y Clock Reset Fig: Circuit for Mealy type serial adder FSM The flin-flon…

A:

Q: Id 6 mA - 3V Q, is a depletion N-channel MOSFET (D-MOSFET) with parameters as shown above. Compute…

A: In this question,   We need to determine the Q point of the given circuit.  We are solving this…

Q: Von Rp Rus RL RG R, For the circuit show above, if circuit parameters are: Cc = 0.5 µF, Cs 2 µF CG =…

A: JFET It means junction field effect transistor, it is a type of transistor or semiconductor tool…

Q: control, Current Control, DC bus voltage control) for each of the following cases • A stand-alone…

A: Stand alone inverter connected to a battery and Feed AC load - Proper control method is DC bus…

Q: 16. Consider the circuit of Fig. 13.46. The two sources are is1 = 2 cos t mA and i2 = 1.5 sin t mA.…

A:

Q: Subject 1: Logic Circuit and Switch Theory   Simplify the given equation XY' + XYZ' + (Y+X'Z)' +…

A:

Q: Determine the current in the loop of 12ohms, 0.1vx, 12 ohms. (Express your answer in milli (103))

A: In this question we will find current in the loop of 12 ohm, 12 ohm current source....

Q: If V1 is a sinusoid with amplitude = 1mV and freq=1kHz, choose a combination of V2, R1, R2, and Rf…

A:

Q: R 500 Q RB Vcc Bpc=200 %3D VBB+ 18 kO 2.5 V What is the value of VCC if the VCE = 10V? %3D O 20 V O…

A:

Q: Increasing the L/C ratio of a series resonant R-L-C circuit while maintaining constant resonant…

A: Given  L/C ratio of a series circuit is increased while maintaining resonant frequency constant then…

Q: Shape Fill Тext Box Quick Z Shape Outl Convert to Picture Shapes Arrange BIUab x x, AV v Aa v…

A:

Q: Two relays R1 and R2 are connected in two sections of a feeder as shown in Figure Q2. Relay R1: CT…

A:

Q: A sine-wave has a frequency of 1 kHz. Ten complete cycles will require a time of: a) 100 ms Ob) 100…

A: One complete cycles is called time period. Time period and frequency has inverse relationship T= 1/f…

Q: Re 1.5 kQ Rg + Ve 15 V CC Bo= 100 DC VBB-4.0 V Assume Rp = 33 kN. The collector current will be…

A: The solution is given below

Q: Problem 5:   A V = 86-V source is connected in series with an R = 1.8-kΩ resistor and an L = 28-H…

A:

Q: Why is it a shorted circuit and not treated as a wye and dye?

A: We have labeled the nodes as shown in the figure below.

Q: Consider the following JFET circuit. If Ip = 4.3 mA, the voltage at the drain is: +12V b (mA) - 8.0…

A:

Q: "The instruction MOV DS:[2000H], AL" has mixed sizes operands O copies byte-size data in AX to the…

A: Correct option is 4 :  "is illegal,not allowed". Because " should not be present in instruction and…

Q: A transformer has a turns ratio of 4:1. If the secondary winding contains 30 turns, the number of…

A: The solution is given below

Q: D1 R1 1N4004 1000 V1 D2 (1N4004 5V R2 100Q

A:

Q: The collector current for the following stiff voltage-divider is: Vcc +10 V RC 1.0 kN 10 kN R2 5.6 k…

A:

Q: 7. Specify the applications of BFSK?

A: BFSK : BFSK is known as binary frequency shift keying it is a tyoe of modulation technique which…

Q: Question1: Simplify the following block diagram.

A: AS per our guidlines we done 1st question

Q: Q2. 2. Calculate the dot product of the vectors F = -i + 3j - 6k G 7i - 5j + k. Select one: O a. 30…

A: Brief description : Here they have mentioned two vectors and they want to know the value of dot…

Q: How to interpret / read capacitor values or capacitance?

A: Concept :-  A.Write down the first two digits of the capacitance.  B.Use the third digit as a zero…

Q: C=Q,0001

A: In this question we need to find a current shown in the given circuit.

Q: Find v2, if i,= -1mA (express your answer in milli (103)) ANSWER:Blank 1 -2i I Blank 1 Add your…

A:

Q: Based on the figure below, choose the correct answer. y(t) 1 t-2 t-1 3 O t-21 O t- 2 >1 3 >t- 2 All…

A:

Q: The armature of a 270V dc shunt motor has a resistance of 0.20 ohm. If the armature current is not…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: The resistance and standstill reactance of each phase of a 3-phase induction motor with star-…

A:

Q: The reactance of a 6 nF capacitor @ 400 Hz is: O a) 6.63 k2 O b) 66.3 Q O c) 66.3 k O d) 66.3 M2

A:

Q: G3 G2 R G1 H1 H:

A:

Q: 6. What characteristics of the thermistor make it a flexible temperature transducer?

A: Thermistor: It is derived from two words i.e. thermal and resistor which means its resistance…

Q: Find the Laplace Transform of the following: f(t)= t sin5t

A:

Q: Determine and sketch v, for the network of the figure below for the input shown. Show the details of…

A: Solve the problem

Q: Peablense Find the banskr funchion by C9a) loy the fallowing adral ssteas by using black dia gram…

A: In this question,   We need to determine the transfer function using the block diagram reduction…

Q: The total capacitance of ten, 10uF capacitors placed in parallel is: O a) 1 µF O b) 100 µF c) 10 uF…

A: Given  10 capacitor are connected in parallel C= 10uF

Q: Calculate the value of i in the circuit ANSWER:Blank 1

A:

Q: All resistor values are in kiloOhm Assuming that beta=150, the Q-point of this circuit approximately…

A:

Q: Determine v, in the circuit (use superposition principle) 2 A

A:

Q: Figure 1 shows the simplified flow diagram of a nuclear power generating station supplying electric…

A: Let us first understand the problem associated with the fluctuation in demand. As load demand…

Q: The opamp in Figure Q3a has a gain bandwidth of 2.5 MHz. What bandwidth does the circuit have? R 18…

A: Given data, Gain bandwidth, GBW=2.5 MHz

Q: The light-dependent-resistor (LDR) R2 is 1M2 when it's covered and 5002 when exposed to light. Let's…

A: The circuit diagram is shown below, Here,β=100VBE(ON) = 0.7VVCE(sat) = 0.6VWhen covered, the LDR is…

Q: the circuit shoun belows VG) Velt)

A:

Q: Find the mesh currents in the circuit

A:

Q: What are some of the advantages of using high-tech lighting?

A: High-tech lighting : In high tech lighting system LED ystem are used for lighting purpose instead of…

Q: Given that the potential V = 2x²y3 + 4xyz2 Find E at (4,5,8). Give expression for pr c/mº. mv.

A: Given,Potential, V = 2x2y3+4xyz2 mVWe have to find electric field at point P4, 5, 8.

Q: Assume that Ic=le what is the value of vCE and VC. Atleast 2 decimal place for multiple digits. ...…

A:

Q: In an ideal transformer having a 1 to 2 turns ratio, the secondary: O a) current is half the primary…

A: In case of ideal transformer, transformer used for transfer the power and stepping up and stepping…

Q: Isten Increasing the resistance of a series resonant R-L-C circuit will: Oa) decrease the resonant…

A: In this question,  We need to choose the correct options A RLC  circuit if increase the R then what…

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.