In a proposed reservoir, the areas containing within the contours are:- Using the method of end areas, calculate: (i) Capacity of the reservoir when it is full at 100 m level. (ii) Elevation of the water level when it is 60% full. Ignore the volume below RL 65 m. Give your remarks abut the method of 'end areas'. Contour in (m) Area in (ha) 32 26 24 18 15 13 7 2 100 95 90 85 80 75 70 65

In a proposed reservoir, the areas containing within the contours are:- Using the method of end areas, calculate: (i) Capacity of the reservoir when it is full at 100 m level. (ii) Elevation of the water level when it is 60% full. Ignore the volume below RL 65 m. Give your remarks abut the method of 'end areas'. Contour in (m) Area in (ha) 32 26 24 18 15 13 7 2 100 95 90 85 80 75 70 65

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The area bounded by the water line of a reservoir and the contours with a contour interval of 2 m. are as follows: A1 = 10250 m2 A2 = 8350 m2 A3 = 7750 m? A4 = 6900 m? A5 = 5250 m? Compute the volume of reservoir using prismoidal and end area method.
The areas bounded by the water line of a reservoir is determined by using a planimeter.The contour interval is 2m.A1 = 20,400sq.m.;A2 = 18,600sq.m ; A3 = 14,300 sq.m ;A4 = 10,200 sq.m. ; A5 = 8,000 sq.m ;and A6 = 4000 sq.m..Determine thecapacity of the resevoir.
Q In a proposed reservoir, the areas containing within the contours are: Contour (in m) 90 85 80 75 Area (in ha) 18 Using the method of end areas, calculate: (i) capacity of the reservoir when it is full at 100 m level; (ii) elevation of the water level when it is 60% full. Ignore the volume below RL 65 m. Give your remarks about the method of 'End Areas' 100 32 26 24 70 65 7 2
Determine the volume of the lake shown below. Contour interval is 5 meters. The areas bounded by each contour line has been calculated as shown. Note: Donot round.offintermediiate values wert four decimal
OTO 'T (1 Hydrology • Flood Routing . HW • Q1// • The inflow and outflow hydrograph for a river reach are as shown in columns 2 and 3 of the Table. Determine K and x for the reach. Assume x = 0.1,0.2, 0.3 ||| = t + فلاتر O Inflow Time (hr) (cms) 0 12 24 36 48 60 72 84 96 108 120 132 400 144 156 168 Outflow (cms) 0 A.BREEEEEEE. 14.5. 28.4 31.8 29.7 25.3 16.3 12.6 a 2 7 11.7 16.5 24 29.1 28.4 23.8 19.4 15.3 11.2 82 6.4 5.2 إضافة شرح... × mum
3. The boundary of the water surface of a reservoir is shown by irregular outline KLMNOPQR. Soundings were taken on parallel ranges QK, PL, and OM for the purpose of determining the volume of water in the reservoir. The horizontal distances (m) which were measured for locating the ranges and the soundings, and also the depth (m) which were measured where soundings were taken are shown. Calculate the following: a. Areas (sq.m.) of the cross-sections of ranges QK, PL, and OM. Assume that the cross-sectional areas of ranges R and N are negligible or nearly zero. b. Volume (cu.m.) of water between ranges. c. Total volume (cu.m.) of water contained in the reservoir. R 5.275 Q 858 K. -5.591- -7.874 4.754 612 2 450 6.495 -6.725 3.052- -7.151- -6.499- -5.498- 2.55A 1.076 2.077 2.636 3.428 8.390 -5.251- -3.676- -5.994 -5.497- 6.031- 0873 0.902 M 1.714 2.702 9. 106 N
The areas within the contour lines at the side of a reservon and the face of the proposed dam are as Sallows Contur (m) 101 102 103 104 105 106 107 108 109 m) 1000 12.800 95,200 147600 872,500 1550,000 1985,000 2286.000 2512.000 If the bottom and full reservoir levels are 101 m and 100 m respectively, calculate the capacity of the reservoir by the prismoidal formula,
3. The boundary of the water surface of a reservoir is shown by irregular outline KLMNOPQR. Soundings were taken on parallel ranges QK, PL, and OM for the purpose of determining the volume of water in the reservoir. The horizontal distances (m) which were measured for locating the ranges and the soundings, and also the depth (m) which were measured where soundings were taken are shown. Calculate the following: a. Areas (sq.m.) of the cross-sections of ranges QK, PL, and OM. Assume that the cross-sectional areas of ranges R and N are negligible or nearly zero. b. Volume (cu.m.) of water between ranges. c. Total volume (cu.m.) of water contained in the reservoir. R 5.275 Q 2658 t612 -5.591- -7.874- -4.754- 2.150 6.496 -6.725 -3.052- -7.151- -6.499- -5.498- 2,55N 1.076 2.077 3.754 2.636 3.428 8.390 -5.251- +3.676 -5.994 -5.497- -6.031- !! 0.873 0.902 1.714 M 2.702 9. 106 N
Catchment area = 586 Solve it fast plz
Situation 7: The areas bounded by the waterline of a lake and the contours with contour interval of 2 m are as follows: A1- 8,740 m2, A2 = 8,520 m2, A3 = 7,860 m2, A4 = 6,200 m2, and A5 = 5,750 m2. 65. Calculate the volume of water in the lake by End-Area Method. a. 57,393.33 m3 b. 59,650.00 m3 C. 53,650.00 m3 d. 59, 393.33 m3 66. Calculate the volume of water in the lake by Prismoidal Formula. a. 57,393.33 m3 b. 59,650.00 m3 C. 53,650.00 m3 d. 59,393.33 m3
2. A lake 800 m long had soundings taken at right angles to its length on ranges 0, 225, 400, 650, and 800 m (measured from one end of the lake). The calculated cross-sectional area of the different ranges are: Ao = 60 sq. m, A225 = 930 sq m, A400 = 640 sq m, A650 = 750 sq m, and As00 = 120 sq m. Compute the total volume of water in the lake.
Given the area of STA 1 + 260 is 140.55 sq.m., and the area of STA 1 + 300 is 143.48 sq.m. Find the volume of earth material for backfill by Prismoidal formula. Kindly put the complete solutions. a) 5681.60 cu.mb) 5680.73 cu.mc) 5680.60 cu.md) 5680.60 cu.m