) In a half-wave rectifier, what causes the difference between the amplitude of the input AC voltage to that of the amplitude of the output voltage? b) In a full-wave rectifier, what causes the difference between the amplitude of the input AC voltage to that of the amplitude of the output voltage? c) Why is the value of the output voltage of a full-wave rectifier lower than the output voltage of a half-wave rectifier? d) What causes the differences between the average dc voltage of a half-wave and a full-wave rectifier?

) In a half-wave rectifier, what causes the difference between the amplitude of the input AC voltage to that of the amplitude of the output voltage? b) In a full-wave rectifier, what causes the difference between the amplitude of the input AC voltage to that of the amplitude of the output voltage? c) Why is the value of the output voltage of a full-wave rectifier lower than the output voltage of a half-wave rectifier? d) What causes the differences between the average dc voltage of a half-wave and a full-wave rectifier?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

How is a solid-state diode tested? Explain.
What is CEMF?
1. What is the rectifier? 2. What is the value of the peak inverse voltage on the diode in half -wave rectifier? 3. Discuss the results obtained for half -wave circuit with capacitors filter. 4. What are the advantages and disadvantage of capacitor filters? 5. What are the ripples?
What will be the out put of the D'Arsonval meters, if an average responding a.c meter of half-wave rectifier read (236 v), and true form foctor of input waveform is (114). *
3. The current supplied by a rectifier has a sinusoidal wave shape with a maximum value of 6.83 amp. What is the average current if the rectifier is of the (a) full-wave type, (b) single-wave type?
Discussion: 1- Calculate the theoretical output DC voltage of the half wave rectifier circuit and compare it with measured value. For the capacitive filter, obtain the theoretical values of the DC output voltage and the ripple voltage and compare these values with the measured quantities. 2- Explain the effect of increasing the filter capacitance on the output voltage. 3- What is the difference between Half-Wave Rectifier and Full -Wave Rectifier? 4- What is the advantages and disadvantages of Full-Wave Bridge Rectifier over Half Wave Rectifier?
04: A full-wave bridge rectifier at (2:3) transformer with a [77 sin(2n x 100 x 10°t)] rms input signal has a loud resistor of 3.3k0. Draw the rectifier circuit and: 1. Sketch and determine effective waveform voltage (VLp) at the load. 2. Determine the required PIV rating of the diode. 3. What input frequency and output frequency ? 4. What is the de valtage available at the load? 5. Explain who could filtering output signal. 6. Draw circuit that give opposite out waveform. 7. Why connect circuit in this form.
4)Mark the correct statements: a) The frequency at the output of a half-wave rectifier circuit is 30 Hzb) The frequency at the output of a full-wave rectifier circuit is 60 Hz.c) To calculate the average voltage (DC) at the output of a full wave rectifier we use the formula: Ucc = 0.636 * Up.d) When using a bridged full wave rectifier, we know that the loss at the depletion barrier will be 2 * 0.7 Volts.e) None of the statements is correct.
1. A diode will pass only alternation of a sine wave. 2. A half-wave rectifier can produce positive or negative pulsating dc, depending on the that the diode is placed in the circuit. of a sine wave. 4. In terms of polarity, the output of a full-wave rectifier has both alternations of the sine wave input 3. A full-wave rectifier passes both. voltage going in the direction. 5. What is the main advantage of full-wave rectifier over the half-wave rectifier? 6. The main advantage of the bridge rectifier over the standard full-wave rectifier is that it does not require a transformer. 7. When one of the diodes in the bridge circuit opens, one of the will be missing at the output. 8. From the data, what conclusion can you draw about the relationship between the dc voltage across RL and peak voltage in a full-wave rectifier?
1. Compare the output waveform for Half-Wave Rectifier with and without capacitor. Compare the output waveform for Full-Wave Bridge Rectifier with and without capacitor.
The rectifier below is operating at a frequency of 60 Hz, and the RMS value of the transformer output voltage v, is 6.3 V. (a) What is the value of the dc output voltage Vo (the peak V.) if the diode voltage drop is 1 V? (b) What is the minimum value of C required to maintain the ripple voltage to less than 0.25 V if R = 0.50? (c) What is the required PIV rating of the diode in this circuit? (d) Sketch the output waveform labeling Vpeak (the dc value), Vripple, and sketch the general shape of the diode current Ip below the voltage waveform. + D1 R
Asap