In 3-5 sentences, describe flood mitigation techniques the federal government might use.

Q: The average daily traffic entering the España – Governor Forbes intersection is 27000. If the accide...

A:

Q: Q2: From the following excerpt of field notes, plot the cross section on graph paper and superimpose...

A: We have to determine the area by coordinate method as per the given data like slope 3:1 and subgrade...

Q: 97. A helical spring is subjected to an axial load W and corresponding deflection in the spring is d...

A:

Q: The trusses are pin connected and suspended from the parabolic cable. Determine the maximum force in...

A:

Q: From the following figures, find the following materials required for its construction. 15 x 20 x 4...

A:

Q: Problem Number 2: In The given cable carrying concentrated loads W,V & A, determine the maximum tens...

A:

Q: m, and 27.7 mm, respectively. What is the approximately area of this parcel in acres? 3. On a vertic...

A: data given focal length of column f =88.9 mmflying height H = 3910 ft = 1191.768 m elevation of land...

Q: 7. A helical spring is subjected to an axial load W and corresponding deflection in the spring is 8....

A:

Q: A soil sample taken from a field contains a volume of 11O cm3 , weighs 220 grams when taken, and 165...

A:

Q: +y") dx ly

A:

Q: 5. The steel shaft, 3 ft long and 4 in. in diameter, carries the end torque of 15 kip-ft. (a) determ...

A:

Q: 6-23 The T-beam is subjected to the loading shown. Draw the shear diagram for the beam. 2 kip 100 lb...

A:

Q: 97. A helical spring is subjected to an axial load W and corresponding deflection in the spring is 8...

A:

Q: Answer the ff: a) The effective stress right above the depth of 20 meters from the ground surface is...

A: solution From zone A to B the dry unit weight of sand γdry1=γwG1+e=9.81×2.671+0.45=18.064 KNm3From z...

Q: A soil sample taken from a field contains a volume of 110 cm3 , weighs 220 grams when taken, and 165...

A: Given data  Volume of the sample V= 110 cm3 Original Weight of the sample = 220 gms Oven dried weigh...

Q: kN kN A simply supported beam AB supports a trapezoidally distributed load (see figure). The intensi...

A:

Q: A soil sample taken from a field contains a volume of 110 cm3 , weighs 220 grams when taken, and 165...

A: KINDLY NOTE: As per our guidelines, we are supposed to answer the first 3 parts of a multiple part q...

Q: A. DRAW THE FREE BODY DIAGRAM B. DETERMINE SUPPORT REACTIONS C. DETERMINE THE SHEAR AND MOMENT...

A: w = 24KN/m

Q: Find the scale ratio for the described below. map 1 mm (map) = 5 m (actual)

A:

Q: complete solution

A: Given data- Compressive strength (fy)= 21.9 Mpa Steel yield strength (fs) = 326Mpa Width(b) = 256mm ...

Q: A three-span continuous one-way slab with clear spans of 3.5m and thickness of 100mm is supported on...

A:

Q: Draw the shear and moment diagrams of the beam shown below. There is a fixed support at A, an intern...

A: We have given that -  

Q: Define The depth of the loaded area below the ground surface

A: depth of the loaded area below the ground surface Whenever a heap is applied to soil, it is conveyed...

Q: Find the interest on P6,800 for 3 years at 11% simple interest P2,244 P1,987 O P2,144 P1,875

A:

Q: A dam cross-section is a square facing a water depth of D=15m. Assuming a 1m strip for analysis and ...

A: Given data,  FOS for overturning = 2 D = 15 m Coefficient of friction = 0.5  To find out the dimensi...

Q: Mat foundations are essentially large spread footings that usually encompass theentire footprint of ...

A: Mat foundation is a type of shallow foundation which is used under the following conditions: When s...

Q: m. A car can travel a maximum speed of 80 kph. Find the coefficient of friction between

A: Given data- Super elevation (e) = 0.12 Maximum speed(V) = 80kph                  V = (80× 5)/18 = 22...

Q: 3. The circular shaft is supported by two journal bearings at A/C and B. internal shear force V(x) a...

A:

Q: The bin is 2 m wide and is filled with oil to the depth shown. Determine the location of the resulta...

A:

Q: In fig. if the pipe diameter = 25 mm, * ?---=V2= 6m/s , Q=--? h U-tube Liquid Z, Elevation reference...

A: Given- Pipe diameter (D) = 25mm Velocity of liquid at point 2 (V2) = 6m/s           Calculate- Disc...

Q: diameter of sewer pipe 1.8m Depth of water = 1.6m Q = 2.5m/s Given: Compute the velocity.

A: The main idea here is to calculate the area of flow. Using the formula provided in the image below.

Q: 50 lb-ft T2 (1) 30 lb-ft A (3) B C D Assume for the above sketch that the shaft is restrained from r...

A:

Q: Figure 4. 300 mm M 30 mm 30 mm 150 mm 150 mm If the beam is made of material having an allowable ten...

A: Given data  Allowable Compressive stress = 150 Mpa Allowable Tensile stress  =125 Mpa   To Calculate...

Q: +7% grade meets a -4% grade at the vertex V with elevation of 30m and stationing of 2+000. It is req...

A:

Q: Water from the reservoir flows through the 150-m long, 50-mm diameter pipe into the turbine at B. If...

A:

Q: A soil sample taken from a field contains a volume of 110 cm3 , weighs 220 grams when taken, and 165...

A: Given data-

Q: A 500 mm square column will support a total dead load of 700 kN and total live load of 700 kN. The c...

A: Punching shear : When a concentrated force is applied to a small area of a slab, or when a column re...

Q: The figure below shows two flow lines for seepage across an interface between two soil media of diff...

A:

Q: The chords of a compound curve from PC to PCC and from PCC to PT are 130.60 m and 139.16 m, respecti...

A:

Q: o be built such that the estimat mine the reguired flow oyer the

A:

Q: In relation to construction materials and testing, why do we grease the moulds? DISCUSS AND EXPLAIN ...

A:

Q: Compound Curve Consists of two or more consecutive simple curve having different radius, but whose c...

A: Solution_1

Q: PROBLEM 2 A driver is driving at an initial speed of 40 kph. At the back of his truck is a mounted c...

A:

Q: A slope made of granular material contains saturated unit weight(7sat) of 18kN/m³, and 0=33°. If the...

A:

Q: Determine the velocity and pressure at sections 2 and 3 if the water flows steadily through the pipe...

A:

Q: A soil sample taken from a field contains a volume of 110 cm3 , weighs 220 grams when taken, and 165...

A: We will apply basic formulas.

Q: A uniform bar of length L, cross-sectional area A, and mass density p is suspended vertically from o...

A: Given: Bar length L, cross-sectional area A, mass density of the bar ρ, E= modulus of elasticity

Q: Determine the thrust block bearing areas for the conditions given below. Assume a maximum static pre...

A: F (Thrust Block) = 2PA*Sin∅2   {here, P is pressure, A is area ∅ is bend angle}

Q: 1. Water flows in a pipe that has a 4 ft diameter and the following hypothetical velocity distributi...

A:

Q: 20 KN/m 40 KN 1. А Ac 8 m 8 m 3 m 3 m

A:

Concepts of Flood Control

Flooding is a temporary overflow of water that submerges or covers the the usually dry land. It can also be defined as the overflow of the excess amount of water that covers a huge area of land which is normally dry.