Implement 1-to-8line demultiplexer with active low enable input using logic gates
Q: Switching, Cords and Cables, Motors, and Related Systems 15.a. Information such as manufacturer's…
A: Motor:- Motors are used for the conversion of electrical energy into mechanical energy. On the basis…
Q: A 3-bit PCM system with a linear midrise quantiser of step-size A = 1V is used to digitise the…
A:
Q: Draw block diagram of 8 to 1 multiplexer also draw truth table and state Boolean expression for same…
A:
Q: 3. A coil consists of a Resistance of 980and an inductance of 180 mH. if an alternating voltage…
A: Given data, Resistance R=98 Ω Inductance L=180 mH = 0.18 H Voltage equation V=180sin480t V
Q: A = 1 +j3 B = 2230° C = 5e/
A: here we have to convert the given B and C forms to rectangular form. we know that r∠θ° =r cosθ + j…
Q: Q1) Analyse the circuit in figure through nodal analysis and answer the questions using the concept…
A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…
Q: Calculate Z, if ST = 3373 VA, fp = 0.938 leading and the 3 Ω resistor consumes 666 W. Work it single…
A: Given data, Apparent Power (ST)= 3373 VA Power factor (fp) = 0.938 leading Resistance (R) = 3 ohm…
Q: Q.2 (a) Consider the circuit in Figure Q.2(a). Using Nodal analysis, find: (1) P₁. V and Vs. (ii)…
A:
Q: Q1. For the scheme shown in figure Q1, using the message signals spectra shown a) Draw the spectrum…
A: All the frequency are written in kHz. Now adding M1'(f) and M2'(f), we get, cos220,000 πt=1+cos…
Q: G1 G2 H5 G6 H2 2 G3 H1 G4 G7 H4 H3 G5 H6
A: Given, H2 , H3, H6 Are Negative Feedback Signal Flow Diagram :
Q: 2.21 Find V, in the circuit of Fig. 2.85. ISV ΤΩ Μ 292 2 V 5Ω
A: Given,
Q: The open-loop transfer function of a discrete system is given by expression: Y(z) 1 U(z) z²z+0.5…
A:
Q: For the circuit shown in the figure below, the value of currents 1₁ and 12 is: |I₁ R₁ = 300 R₂ = 600…
A: Given circuit,
Q: Some linear system has a transfer function 7(s+3)/(s+4). If the input is 5sin(7t) volts, the ouptput…
A: For any sinusoidal signal, x(t)=Asin(ω0t±θ), passing through a linear system having transfer…
Q: What is the voltage applied across the resonant circuit if the ac voltage across resistance R,…
A: Given data, Voltage across resistor VR=10 V Voltage across inductor VL=20 V Voltage across capacitor…
Q: Q5. Consider x[n] as given below. x[n] = {"(- -n(-1)"-3, -3≤n≤2 otherwise
A: In the question x[n] is given in the range of n from -3 to 2. In part C , circular time advancement…
Q: (15 Points) Assuming an ideal op-amp in the circuit, determine the output voltage Vo- 4 ΚΩ ww 6 V 1…
A:
Q: Q3. At a frequency of 4000 Kilo-Hertz a parallel-wire transmission line has the following…
A:
Q: A 12-pole induction motor has a frequency of 60 Hz. Its synchronous speed would be: (a) 600 rpm (b)…
A: Given: Total number of pole, P = 12 Induction motor frequency, f = 50 Hz
Q: The period of x[n] given by x[n] = = COS is s (1. 2 πη) + sin (0.6πη)
A:
Q: (c) Determine the equivalent resistance Ray of circuit. 2 ΚΩ 3 ΚΩ Rea 6ΚΩ 3 ΚΩ
A: Given circuit:
Q: 2. For the half-wave rectifier shown below, the cut-in voltage is 0.7 V. Sketch the voltage transfer…
A: Given circuit is a Half wave rectifier we have asked to solve vi,vii,viii,ix,x, Note: output we…
Q: (a) Explain the formation of a harmonic oscillator for current in a circuit containing inductor and…
A: Conditions For Oscillation: For Oscillation the condition should be Undamped or Underdamped and For…
Q: 3. Draw the equivalent circuit using the superposition theorem by considering the current source to…
A: Superposition theorem: In any linear, active, bilateral network consisting of no energy sources,…
Q: Consider the circut in Figure @1f, If the power supplied by the Current source is loow, Find Ice to…
A:
Q: This equation H = Hmax Cs/(Ks + Cs) is known as the O Moser O Powell O Monod O Tessier equation.
A: This is predicated on the notion that the primary influences on growth rate are substrate transfer…
Q: A system has 30% overshoot and settling time of 5 sec for unit step input. The resonant peak of the…
A: Given, System has overshoot, MP=30%=0.3 Settling time, ts=5 s For unit step input.
Q: Analyze the given circuit and determine the minimum and maximum input voltage that the given Zener…
A: Diode is two terminal unidirectional device. Zener diode is special purpose diode in which current…
Q: CC For fixed bias circuit. Vcc=+12V, RB = 240KQ, R =2.2KQ and B-50. For what value of ß does the…
A: Given for a fixed bias circuit, Vcc=+12 VRB=240 kΩRC=2.2 kΩβ=50
Q: e(s) Git H₂ 4 ਉਪਰ ਤ H3 H₂ ($) H₁ ੭} G ( s),
A:
Q: Analyze the given circuit and determine the minimum and maximum input voltage that the given Zener…
A:
Q: 3 V 19 W M 1/6 F Figure Q1(b) t = 0 + vc(t) 2/3 H
A:
Q: 3. A coil consists of a Resistance of 980and an inductance of 180 mH. if an alternating voltage v-…
A:
Q: For the following voltage and current phasors,
A:
Q: e) calculate the input impedance, Zi, output impedance, Z, and voltage gain, Av.
A: It is given that:
Q: 1. what are the sources of heat in a power transformer?
A: Note: We are authorized to answer one question at a time, since you have not mentioned which…
Q: If two 115-volt loads were connectedin parallel with 240 volts, they would__________.a. burn dimlyb.…
A: The given loads are rated for 115 Voltage. The loads are connected in parallel, hence each load will…
Q: 4. What is the voltage gain of an inverting op-amp in which the feedback resistor has a value of…
A:
Q: Y Figure Q4(b)
A:
Q: A message signal is given by m(t) = 5 sin(500ft). If the message signal is sampled at 1 kHz rate…
A: Given: Message signal m(t) = 5 sin( 500*pi*t) Sampling frequency = 1kHz Pulse width = 200 micro sec…
Q: System AB is connected to system BC via a 1000 MW tie-line. The total capacity of the online
A: Given- AB system capacity= 10000 Watt Demand of AB = 8500 Watt BC system capacity=20000 Watt Demand…
Q: If the impedance Z1 = 0 +j10 and the impedance Z2 = 10-j10 are connected in parallel, the equivalent…
A: Given, Two impedance connected in parallel are, Z1=0+j10 ΩZ2=10-j10 Ω
Q: 5 advantages and 2 disadvantages of electrical illumination
A: Advantages of electrical illumination 1) Low maintenance – Longer life reduces the need for…
Q: A thermally conducting solid bounded by two concentric spheres of radii a and b. a<b, is such that…
A: Given that the temperature of the inner surface is T1 The temperature of the outer surface is…
Q: R(Resistance, Kohms) 3 C[nF] 4 E[V] 6 When t=0, q=0. a)Find q(t) and i(t), b)sketch curves q(t) and…
A:
Q: Design a circuit with a decoder( use block diag for decoder) for 3 bit binary inputs A,B,C that…
A:
Q: A Moving to the next question prevents changes to this answer. Question 15 Design a 5-tap FIR HPF…
A:
Q: 13.6 The initial charge on the capacitor in the circuit shown is zero. a) Find the s-domain Thévenin…
A:
Q: What will be the resultant capacitance of the given combination? 1mF=2mF 3mF=4mF= 5mF
A: Given circuit,
Q: G1 G2 H5 G6 H2 G3 H1 G4 G7 H4 H3 G5 H6
A: For the given figure, We have to derive the transfer function of the system using signal flow…
Implement 1-to-8line demultiplexer with active low enable input using logic gates
Step by step
Solved in 2 steps with 3 images
- what is the MAXIMUM number of diode OR gates that can be cascaded before the output is not recognized as logic high?In IC 74153,the input at pin number 14 is Options A-Connected to ground B-Connected to power/VCC C-Connected to LOGIC State D-Connected to LOGIC ProbeAn analog voltage (0 to 5) volt is to be converted to 8 bit digital form. d. What is the error made in quantization of 2.2 volt as a percentage of the input.
- Problem #4: Consider the Programmable Array Logic PAL module below '1' A B C D F₁ F2 F3 1. Determine the corresponding product term per row PRODUCT TERMS 000000Write an assembly 8051 code to count a hexadecimal digit every second and display it on the 7-segment.Total Number of active low pins in IC74LS138? Options A-7 B-8 C-9 D-10
- Write an Assembly Language for 8051 Microcontroller which copies the data from R0 of Banko to R1 of Bank1, R2 of Bank 2, and R3 of Bank 3.DIsassemble the following MIPS 32-bit hexadecimal instruction written as addr:instr 60005000 : 0c000020By using the design procedure for digital computers, design the following:i. Encoderii. Decoderiii. 4-bit comparator