ilicone material at 10^18(cm^3) has an n-type additive and a 10ohm resistance. The sample area is 10^-6(cm^2) and its length is 10µm. What is the doping yield of the sample
Q: A source of sound frequency 600Hz is placed inside water. The speed of sound in water is 1500 m/s an...
A: D
Q: Same material is used to make a sphere, a cube and a thin circular plate and having the same mass. T...
A: Given: The initial temperature of the material is T = 30000C
Q: Temperature less than absolute zero is not possible. a) True b) False
A: According to the kinetic interpretation of temperature, absolute temperature is proportional to the ...
Q: A body of mass 5kg hangs from a spring and oscillates with a time period of 2π seconds. If the body ...
A: D
Q: The mean kinetic energy of one mole of gas per degree of freedom (on the basis of a kinetic theory o...
A: Introduction: The kinetic theory of gases assumes that the molecules are very small relative to the ...
Q: Density of substance at 0°C is g/cc and 100°C, its density is 9.7g/cc. The coefficient of linear exp...
A: D
Q: 1. Describe the wind speed and air pressure in the different parts of a typhoon. 2. Describe the eff...
A: Introduction: A tropical cyclone is a generic term used by meteorologists to describe a rotating, or...
Q: Distance Suppose Figure 22 is an exaggerated diagram of a plane flying above earth.If the plane is 4...
A: Given: A diagram of a plane flying above earth is given . To find: If the plane is above earth by 4....
Q: The phase difference between the instantaneous velocity and acceleration of a particle executing sim...
A: Concept used: Acceleration is obtained by differentiating velocity with respect to time.
Q: Give an example situation that is being described from the motion diagram
A: Given: The motion diagram is: Introduction: Gravity is a force that attracts a body towards the cen...
Q: The time period of a simple pendulum on a satellite, orbiting around the earth, is ___________ a) In...
A: A
Q: At Boyle’s temperature? a) Joule’s effect is positive b) Van der Waal’s equation becomes zero c) Gas...
A: C
Q: A simple pendulum is attached to the roof of a lift. If the time period of oscillation, when the lif...
A: A
Q: In the experiment to determine the speed of sound using a resonance column ___________ a) Prongs of ...
A: A
Q: Amount of heat required to raise the temperature of a body through 1K is called ___________ a) Speci...
A: B
Q: 7. The equation E= kq/ř applies to: A) only pointlike particles B) any symmetric objects C) all obje...
A:
Q: A person in good physical condition can put out 100 W of useful power for several hours at a stretch...
A: Given: The output (WP) is 100 W The requirement of the generation (Wg) is 5000 W
Q: An ideal gas is heated from 27°C to 627°C at constant pressure. If initial volume was 4m3, then the ...
A: D
Q: A frictionless and leak-free piston moves up and down a cylinder whose diameter and height are 10 cm...
A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you. ...
Q: Help me fast so that I will give Upvote.
A: Given a mass of m is suspended to a string of length a and oscillating in a circle as shown in the b...
Q: Out of solid, liquid and gas of the same mass and at the same temperature, which one has the greates...
A: C
Q: For which cases did you determine that the flux was equal to the flux in case #1? #1: A charge +q wh...
A: Electric flux calculation through a surface enclosing a charge gives the information of the charge e...
Q: A sound absorber attenuates the sound level by 20dB. The intensity decreases by a factor of ________...
A: A
Q: A mass m is suspended from a spring. Its frequency of oscillation is f. The spring is cut into two h...
A: Option
Q: The displacement y of a particle in a medium can be expressed as y=10-6 sin(100t+20x+π/4) Where t i...
A: B
Q: A coin is placed on a horizontal platform, which undergoes vertical simple harmonic motion of angula...
A: B
Q: When the system shown is released from rest, block A requires a velocity of 2 m/s after moving 1m up...
A: (a) Let T be defined as the force exerted by the rope on each block. Therefore, T=2m1m2m1+m2g
Q: A constant volume gas thermometer using helium records a pressure of 20.0kPa at the triple point of ...
A: Option
Q: Average velocity of a gas becomes 4 times. What will be the effect on rms velocity at the same tempe...
A: B
Q: The latent heat of vaporisation of water is 2,240 J. If the work done in the process of vaporisation...
A: Given data, Latent heat of vaporization of water = 2240 J/gm Work done for vaporization of 1 gm wate...
Q: If an ideal gas has a volume V at 27°C and it is heated at a constant pressure, so that its volume b...
A: B
Q: How much electrical energy is needed to bring two charges Q1= 5.5 x 10-7C and Q2= 1.7 x 10-6 C from ...
A: For a system of two charges posses energy named electric potential energy value of electrostatic pot...
Q: A whistle giving out 450Hz approaches a stationary observer at a speed of 33m/s. The frequency heard...
A: F
Q: A particle executes simple harmonic oscillation. Its amplitude is a. The period of oscillation is T....
A: B
Q: A particle executes simple harmonic motion between x = -A and x = +A. The time taken for it to go fr...
A: A
Q: The values of the biological signals from 3 separate sensors before the amplifier are known as: V1 =...
A: Since the output voltage Vo of the Op.amp is positive so it is a non-inverting amplifier, and the in...
Q: A wave y=asin(ωt-kx), on a string meets with another wave producing a node at x = 0. Then, the equat...
A: B
Q: Advanced Physics Question
A:
Q: Find Z-transform for the following
A: Given: Z{2 cos [0.2π(n-1)]u(n)}
Q: Tork
A: 4. (a) In this question, the direction of rotation of the rod will be in the direction of net torque...
Q: takes 2 seconds for a second wave to travel between two fixed points when the day temperature is 10°...
A: B
Q: A simple pendulum is vibrating in an evacuated chamber. It will oscillate with ___________ a) Consta...
A: D
Q: The time period of mass suspended from a spring is T. If the spring is cut into four equal parts and...
A: C
Q: In an adiabatic process, the quantity which remains constant is ___________ a) Volume b) Pressure c)...
A: Adiabatic process is a process in which there is no exchange of heat between the system and the surr...
Q: Two plane harmonic sound waves are expressed by the equations: y1 (x,t)=Acos(0.5πx-100πt) y2 (x,t)=A...
A: A
Q: The car travels along a road which for a short distance is defined by r= (200/0) ft, where e is in r...
A: Given data: Distance r=200θ ft Constant speed v=28 ft/s=8.5 m/s
Q: The current density in case when 5 ampere of current passes through a conductor having cross-section...
A: The correct option is C that is 2.5 Am-2.
Q: The graph shows the time dependence of the vertical displacement of a lead ball with marked initial ...
A: Given : A graph of vertical displacement (y) versus time (t). The slope of a displacement-time gr...
Q: Coulomb's law for the magnitude of the force F between two particles with charges Q and Q' separated...
A:
Silicone material at 10^18(cm^3) has an n-type additive and a 10ohm resistance. The sample area is 10^-6(cm^2) and its length is 10µm. What is the doping yield of the sample? (µn=800cm^2/V-s)
Step by step
Solved in 2 steps
