If Vs=147V, R1=49kΩ, R2=60kΩ, R3=24kΩ, L=181mH, determine the inductor current, iL (in mA) at t=6micro-s

Q: Write by inspection only the output g(t) in general terms if the input is a unit step of the system…

A:

Q: Op Amps Handout #2 1.a. Design an inverting amplifier to provide a gain of 25 using practical…

A: 1. Solution:

Q: 4. Simplify the circuit below so you can use current division to determine current ia and in. ib 2Ω…

A: In this question we need to simplify the given circuit so that we can use current division method…

Q: From the previous item, find the time response of vL(t) to an input v(t) = 8(t), an impulse…

A:

Q: A single room is supplied with a device which has 100volt circuit with a resistance of 25 ohms,…

A: Given data:-Supply voltage=V=100vResistance=25ΩFind:- Currnet=I=?

Q: Terms: amplitude (A), phase angle (op), frequency (f), angular frequency (w), period (T), peak value…

A: Given: Vp = 5 voltf = 60 Hz Find: Draw the Signal = ?

Q: Write troubleshooting and maintenance of the three-phase separator ( show your answer in table)

A: According to the question, we need to write troubleshooting and maintenance of the three phase…

Q: If the characteristic impedance of transmission line (Zo) equals to the load (R₁), the percentage of…

A: We need to tell about energy transferred load for given transmission line .

Q: The core loss of a single phase, 230/115 V, 50Hz power transformer is measured from 230 V side by…

A: Given- 230/115 V, 50 Hz power transformer, Core loss=1050 W, for 230 V, 50 Hz input, Core loss=500…

Q: 1. Show the stack and the sack pointer SP for each line of the following code: ORG 900H MOV SP,#50H…

A:

Q: 18. A three-phase motor has a nameplate that reads DUTY PLUGGING. This means that the motor A. is…

A: Motor: Motor is an electrical device that converts the electrical energy into mechanical energy.…

Q: 104. The nominal T'circuit of a transmission line has R = 10 Q; X = 20 22 and Y = 400 µS for each…

A: Given- The nominal T circuit of transmission line has, R=10 Ω.X=20 Ω.Y=400 μS. To find- The…

Q: 4. Determine the equivalent resistance between terminals A and B for the circuit shown. A 3 M 20…

A:

Q: If the value of dc alpha is 0.5, then the value of dc beta of a transistor is O 10 O 0.1 01 O 100

A:

Q: BASIC ELECTRICAL ENGINEERING (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO…

A: For calculating nortan equivalent short circuit the network between node a and b.the current flowing…

Q: 100V 20 b 1302 2403 3002 30Ω www 1002 5002

A: Calculation of current I in the given circuit. Ra,Rb and Rc are making delta configuration convert…

Q: Assuming the passive sign convention, sketch the voltage which develops across the terminals of a…

A: It is given that: C=2.5 F

Q: Build a truth table and draw the output wave form for the following logic gates shown in Figure Q2.…

A:

Q: DC shunt generator has a full load output of 10kW at a terminal voltage of 240V. The armature  and…

A:

Q: Find the transfer function G(s) = VL(S)/V(s) for the network: v(1) (+) 2 H 0000 252 www 292. elle m…

A: We need to find out the transfer function for given circuit ,  We will find out output voltage in…

Q: Solve for the node voltages shown in the figure below. The component values are R₁ = 12 N, R₂ = 16…

A: The given circuit is shown below, R1=12 ΩR2=16 ΩR3=12 ΩR4=7 ΩR5=7 Ω

Q: A FLOO DUGAT EMITTING 60° TO A POINT ON THE IN LUX IS. 25,000 CANDELAS IN THE CENTER OF ITS BEAM…

A:

Q: Find the magnitude of the steady-state response of the system whose system model is given by dx (t)…

A:

Q: Prove or disprove that f= g. 2.67 Repeat Problem 2.66 for the following expressions: f = x₁x₂x3 +…

A: The expression f is in SOP (sum of products form). The expression g is in POS (Product of sums…

Q: compare between static relays and electro- mechanical relays microprocessor relays?

A: For the purpose of protecting the power system, a static relay, also known as a solid-state relay,…

Q: 2mA (1 3ΚΩ 12mA ΣΚΩ α ΙΚΩ 1) GmA

A:

Q: 1- Draw the phasor diagram of 3 phase line and phase currents if the connection is (a) Y and (b) A?…

A:

Q: 2mA 3k2 12mA 2kQ2 Solve for the current through the 2-k2 resistor using: A. Mesh Analysis B. Nodal…

A:

Q: Given the following specification for the JFET in the circuit below (ldss = 10 mA and Vp =-3 V),…

A: We need to find out the resistance value for given circuit for given current and voltage .

Q: I need the definitions of the following: First order high pass filter Second order high pass filter…

A: To define: First order high pass filter Second order high pass filter First order low pass filter…

Q: Given the transfer function find the natural frequency and damping ratio. G(s) = 16 S² + 3.5s +16

A: We need to find out natural frequency and damping ratio for given transfer function.

Q: 10V + w R₁-2002 R₂=300 www R4-200 M What is the current through Ra w R3=500

A: Given data, Circuit diagram is given as,

Q: NORTON'S EQUIVALENT THEOREM 2. Find RN, IN flowing through and VL across the load resistor by using…

A: We need to find out norton equivalent circuit for given circuit , for norton equivalent circuit we…

Q: 4. Determine the steady-state error of a negative-unity feedback system with G(s) = (5s+4)/(s+4) to…

A:

Q: C. Using the battery polarity concept, determine the resulting battery configuration for the…

A:

Q: Find the transfer function G(s) = VL(S)/V(s) for the network using Nodal analysis: v(1) 192 0000 1Η…

A: We need to find out the transfer function for given circuit by using nodal analysis.

Q: A four-story office building has a required load of 60000voltamperes and single-phase 240volt feeder…

A:

Q: 2. A 3 phase, 4 wire feeder has 220V per phase supplies two single phase motors. Motor A is rated…

A: Given that, Rating of Motor A= 8HP, 0.8 pf lag, 90% efficiency. Rating of Motor B= 5 HP, 0.866 pf…

Q: find the Fourier Transform and show that the most relevant frequencies that we need lie on an…

A:

Q: Calculate the value of current through each resistor, the total current, and the total resistance…

A:

Q: -5 ltl t all g(t) = 2. é 3.1. Determine the equivalent duration, Ley 3.2. Find the equivalent…

A:

Q: Q-A 250 V dc shunt machine has armature circuit resistance of 0.60 and field circuit resistance of…

A: Given- Terminal voltage VL=250 V, Armature resistance Ra=0.6 Ω, Field resistance Rf=125 Ω, Line…

Q: Present the complete solution and box the final answer. 1. A system has a transfer function, G(s) =…

A: In this question,  We need to determine the time constant, settling time and rise time.  We are…

Q: 10 mV + 20 mV + 50 mV +) 100 mV + 25 ΚΩ m 20 ΚΩ 10 ΚΩ 50 ΚΩ Μ Μ 50 ΚΩ + Vo 10

A:

Q: Using hodal analysis, Μ 6Ω 492 Ω σου Ε 20 Ω Μ 20 Ω x 50

A:

Q: Hell! Please find the discrete time fourier transform of the sequence below. Thank you! x[n] =…

A: We need to find discrete Fourier transform for given sequence , we will use direct formula for of…

Q: VIN R₁ R₂ Vcc + VBE Vcc www 2 Rc Q₁ RE VOUT VCE,sat VBE,Q = 0.7 V B = 150 Vcc = 6 V Rc = = 4.7 ΚΩ RE…

A: According to the question, for the given circuit as shown below Under maximum symmetric output…

Q: For the circuit shown below, given that v = 5 V: a) Calculate the voltage drop across the 6 A and 9…

A: The given problem is from circuits. The problem can be solved by using KVL.

Q: A feedback control system is illustrated in Fig. 2. The plant, compensator and sensor transfer…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: For the signal x[n], plot the following signals over a large enough time interval to show all…

A: