If the real power in a circuit is 50 watts and the apparent power is 75 volt amperes, the circuit phase angle is: Oa) 48.2° (degrees) O b) 56.3° (degrees) O c) 33.7° (degrees) d) 41.8° (degrees) acer

If the real power in a circuit is 50 watts and the apparent power is 75 volt amperes, the circuit phase angle is: Oa) 48.2° (degrees) O b) 56.3° (degrees) O c) 33.7° (degrees) d) 41.8° (degrees) acer

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: 24 RC 2.2k 470k 200k RB VB EVE RE 1.2k

Q: Which of the following is NOT a factor that influence the value of resistance?

A: Answer is option "b" - volume of conductor because, Resistance of a wire, R=ρl/a where ρ is…

Q: b. Find discrete time signal x[n] obtained when sampling x_(1) with N, =1607 . Sketch x[n] over the…

A: Given the continuous-time signal: xc(t)=cos(200πt) b) We need to find the discrete-time signal x(n)…

Q: Isten Increasing the resistance of a series resonant R-L-C circuit will: Oa) decrease the resonant…

A: In this question, We need to choose the correct options A RLC circuit if increase the R then what…

Q: 1) Listen The period T of a signal is: Inverse of the frequency of the signal 1/f Measured in Herz…

Q: Consider the following JFET circuit. If Id = 2.2 mA the voltage at the drain is

Q: A 3-phase induction motor having a 6-pole, star-connected stator winding runs on 240V, 50HZ supply.…

Q: control, Current Control, DC bus voltage control) for each of the following cases • A stand-alone…

A: Stand alone inverter connected to a battery and Feed AC load - Proper control method is DC bus…

Q: Find the Laplace Transform of the following: 1. f(t)= cos? 3t

A: In this question, We need to determine the Laplace transform of the cos3 3t

Q: Q5: G3 R G1 G2 H3 H1 H:

Q: ) Listen If the applied voltage across a series RL circuit is 120V and the voltage across the…

Q: a)What is the value of downward current through inductor, ix(t) as a function of time? (not complex…

Q: Q1. Redraw the circuit with complex number values. Q2. Identify and CLEARLY write all the node/mesh…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Suppose a simple uniform hashing function is used with chaining. Here n is the number of keys stored…

A: When a simple uniform hashing function is used with the chaining, the collisions will be resolved…

Q: In the circuit shown below, the DMM ammeter reading is 6.653 mA. Accordingly, the internal…

Q: (d) A step-down transformer is rated 10KVA, 7500/250 V and has the following equivalent circuit…

A: In this question, We need to determine the equivalent winding impedance referred to the high…

Q: is 50 2 A

Q: When the emitter resistor is bypassed with a capacitor, how is the gain of the amplifier affe What…

A: In this question we will write effect of bypass capacitor across emitter resistance on gain and gain…

Q: Why is it a shorted circuit and not treated as a wye and dye?

A: We have labeled the nodes as shown in the figure below.

Q: Determine and sketch v, for the network of the figure below for the input shown. Show the details of…

Q: Compute the current (express your answer in milli (103)) ANSWER:Blank 1 10 k2 ... 5 V

Q: A DT system is described by the difference equation (E +4E + 3)s{n]= (10E + E+1)x[m]. Find the…

A: Solution- EQUATION,E2+4E+3yn = 10E2+E+1 xnZero input response,xn = 0E2+4E+3yn = 0characterstics…

Q: Calculate the value of i in the circuit ANSWER:Blank 1

Q: In the stairwell of a 10-storey building, there are two continuously used 75watt safety lamps in one…

Q: Determine the current in the loop of 12ohms, 0.1v, 12 ohms. (Express your answer in milli (103))…

Q: Briefly explain the energy losses in a ferromagnetic core.

Q: ) Listen Two capacitors, C1 = 6 µF and C2 = 12 uF, are connected in series to a 100VDC source. The…

A: We need to find charge on capacitor .

Q: Which term refers to the insulating material that is inserted between the plates of a capacitor?

A: Insulating material that is inserted between the plates of capacitor is reffered as:

Q: Ead the raaster tunchan KNG) for the Cirauil shown belowe 1H IH V.CA)

A: Solve the problem

Q: ToR ths Given CircuiT Finro 2,(t

Q: 3. Given the circuit, Find lo and the overall complex power supplied namely PT, QT & ST. 1.2 kW 0.8…

Q: You will search for properties of materials and tabulate properties. Complete Table 1 below for the…

A: From the table given in the question, the answer is as follows-

Q: Given y = mx + c. Find the value of y1, y2 and y3 based on the figure below. y(t) 2 -2 -1 0 1 t 3 2x…

A: The solution is given below The answer is option option a.

Q: For Fixed Bias Configuration Solve for Ib, Ic and le. Atleast 2 decimal place. Be mindful of units.…

Q: 1. Obtain the Thevenin equivalent at the terminals a-b of the circuit and draw the equivalent…

Q: -2i,

Q: Find i, in the circuit ANSWER:Blank 1 5Ω 2 A 12 50

Q: 10 VDD=+12 V 8.0 Rp 1.0 k2 6.0 Ip (mA) 4.0 2.0 Ro 10 MQ Rs -5.0 -4.0 -3.0 -2.0 -1.0 Vos (V) (b)…

A: In this question, We need to determine the voltage VGS if voltage Vs = 2.7V

Q: (b) Draw the energy diagram of following pt-n-n* hetero-junction under equilibrium shown in Fig.1.…

Q: If the current in the secondary of a transformer is decreased from full-load to half- load the core…

A: * The core losses ( or iron losses) does not depends on current. * The core losses depends only on…

Q: X = 5 2 1, = 6A Z 0° R. Xc L = 4A 2 0°

Q: The main advantage of A.C. systems over D.C. systems is: O a) transformers can be used to change…

A: The transformer only works on AC and cannot be operated on DC. A transformer is a device that…

Q: Which term refers to the maximum electric field that can produced in the dielectric before it breaks…

Q: Question 3 Find i, in the circuit ANSWER:Blank 1 i. 2 A (1) 12 52 Blank 1 Add your answer

Q: debyte temperature

A: Conductor-Materials which have free electrons in valence which can flow when comes under any…

Q: In the power triangle of figures below, calculate the missing parameters; the reactive power (Q),…

Q: If a transformer has a primary voltage of 240 V and a secondary voltage of 120 V the value of x…

A: Transformer is an electrical device which converts voltage from one level to another without…

Q: In the figure, each transmission line of the three-phase system has an impedance of 0.2 / 90° Q. In…

A: In this question, We need to determine the currents in the loads and neutral current? Power…

Q: To improve a lagging power factor: a) the apparent power from the source is increased. Ob) the…

Q: Von Rp Rus RL RG R, For the circuit show above, if circuit parameters are: Cc = 0.5 µF, Cs 2 µF CG =…

A: JFET It means junction field effect transistor, it is a type of transistor or semiconductor tool…

Question

If the real power in a circuit is 50 watts and the apparent power is 75 volt amperes,
the circuit phase angle is:
a) 48.2° (degrees)
Ob) 56.3° (degrees)
c) 33.7 ° (degrees)
O d) 41.8° (degrees)
acer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the following voltage and current waveforms, the length of the current waveform parts are equal. Voltage (V) and Current (A) 200 150 100 O**** -50 -100 -150 -200 Current Vollage 3 Angle (Rad) 4 5 Calculate the rms value of the current waveform I
If the alternating voltage v= 180 sin(480t), then the frequency will be O 79.36 Hz O 50 Hz O76.39 Hz O 100 Hz
1. The phasor diagram representing four alternating currents is shown in the figure below where the length of each phasor represents the amplitude of that waveform. Write down the standard expression for each waveform. L-4A 1₁-7A 70⁰ 50⁰ -1₂-6 1₂=5A
QUESTIÓN 6 Add the following three phasors: 12240°, 9280', 22120° O 21262 O 25240 O 142-12 O 56284
In a pure inductive circuit O Current lags the voltage by 90 degrees O Current lags the voltage by 30 degrees O Current lags the voltage by 180 degrees O Current is in phase with the voltage
The alternating voltage is given by v = 30sin160t. What is its average value?
Sinusoidal AC Voltage displayed on the oscilloscope There is a value from the top to the top. Measured at 50 V. The RMS value of the voltage is 25V 70.7V 17.7V 35.4V
If the peak value of a sine wave is 20 V, the rms value is 14.14 V O6.37 V O7 07 V 12.7 V Moving to another question will save this response.
The peak voltage for a 60 Hz sinewave with rms voltage of 208 V is: 507 V 145 V 294 V 703 V
90 degree phase angle represents what? O it starts 90 deg later than another reference waveform O it forms a 90 deg angle with the x axis O it makes a 90 deg angle with the y axis O The waveform completes one cycle in 90 degrees
The phase angle between 15sin(7t) and 10sin(7t+50°)
Q6) If you apply an AC 50HZ 220V sine wave voltage to the following circuit, with the firing angle a1= 300, the RMS output voltage will be qual to AUd Uv a.153V b.155V c. 165V d.150V