If the particle size of powder is 0.011 in and MC is 300 what is the wire thickness of screen?

Q: what is the result and discussion about the different thermal and optical properties of agricultural…

A: Thermal properties of agricultural commodity For any growth of thermal system, important properties…

Q: Qʻ: Fill in the following blanks with suitable words : 1. Conductivity of a material depends on: and…

A:

Q: What is the difference between batteries and concentration cells?

A: The chemical energy is retained in both the cell and the battery, which is then…

Q: how many hours do you need to charge a 3.7 , 2600 mah li-ion battery on TP4056?

A: Given: A 3.7 V, 2600 mAh li-ion battery on TP4056. To find: How many hours are needed to charge the…

Q: Find the color of the FF. resistance value. B. 1MΩ

A: It is given that: R=1 MΩ

Q: Give samples of 10 samples of PPE that we use in Electrical.

A: The 10 samples of PPE that we use in electrical is as follows: 1. Head protection - Helmets - Hard…

Q: Plot a graph showing variation of current versus voltage for the material GaAs.

A: Given: Current versus Voltage for the material GaAs. Required: Plot of graph of Current versus…

Q: A wire that has a diameter of 10 mils will have a circular mil area of?

A: Given that D=10 mils Although formula for area of conductor is given by  A=πD24plugging valueA=π1024…

Q: finding the tolerance value of green blue green and gold

A: green→5blue→6green→100kgold→5%( tolerance band)

Q: determine whether 10komhs R sub E is  within the permissible range of values.

A: Given: Consider the UJT relaxation oscillator below. Assume that Lilt has the following…

Q: Question3: A uniform piece of n-type of silicon that is lum long senses a voltage of 1 V. Determine…

A:

Q: Find the color of the FF. resistance value. C. 25KΩ

A: Given: The resistance value is R=25 kΩ

Q: How did you know if the battery is charging in TP405

A: Introduction -  The TP4056 is a comprehensive constant current/voltage linear charger for individual…

Q: oper wire of certain length and ance is drawn out to three times gth without change in volume, w…

A:

Q: Where would you expect to find a laser diode? Please choose one: a. barcode reader b. automobile…

A: Where would you expect to find a laser diode?

Q: 3. The length of a Germanium material is 10 cm and its area is 5 cm2. Check in slide 30 the…

A: Resistance:  In the resistance, the power dissipation occurs in the form of heat. Its unit is Ohm.

Q: What is the mass of an assembly of 1000 electrons?

A: In this case, the mass of an assembly of 1000 electrons is to be determined.

Q: Calculate the amount of charge represented by four million protons

A: Given  No. Of protons - 4 million To find charge by no.of protons

Q: n ampere (A) of current is defined as the amount of charge that passes through a reference plane in…

A: It is known that current is defined as  amount of charges flowing per second  though a conductor  .…

Q: An assembly consists of 1040 individual protons. What will be the total charge of the assembly?

A: Although charge of a Proton is 1.6×10-19 C (+1e).It is given that number of protons is 1040.

Q: A proton is heavier than an electron by how many times

A: In this case, by how many times a proton is heavier than an electron is to be determined.

Q: The molar solubility of lead iodide in a water solution is M.

A:

Q: Which is the most common semiconductor? Please choose one: a. Silicon b. none of the above c.…

A: Silicon is the most commonly used semiconductor material.  Why because silicon has small leakage…

Q: In CRO , electron gun has a ..............for varying the electron density.

A: CRO means Cathode Ray Oscilloscope. CRO gives the strong electron beam. The  CRO has a electron gun…

Q: If PMMC meter have internal resistance of 102 and full scale range of ImA. Assume we wish to…

A: by connecting the external shunt resistnce acorss the PMMC the range of the PMMC can be increases…

Q: What is the intrinsic carrier concentration of Germanium

A: In this case, the intrinsic carrier concentration of Germanium (Ge) is to be obtained.

Q: What are the different types of Insulators, give examples for each type. Compare the glass insulator…

A: Materials can be classified into three categories namely conductors, insulators and semiconductors.…

Q: 6 volts are applied along a 2-cm-long semiconductor bar. The average drag speed is 104 cm/sec. What…

A: Drift velocity is given as                               ϑd=µE where µ is the mobility of an…

Q: (a) Plot a suitable graph that can be used to determine the values of Io and β?. (b) Use your graph…

A:

Q: How many electrons will be required for a flow of 3.2 A current in 2 nsec?

A: Given, Current, I = 3.2 A Time, t = 2 nsec charge on electron, e=1.6×10-19 C

Q: Find the value of voltage across Germanium

A: In this question Find the value of voltage across Germanium?  Assume forward bias voltage of Si =…

Q: When a current of 2A flows for 3us in a copper wire, estimate the number of electrons crossing the…

A:

Q: What is the atomic number of Sodium Germanium Gallium

A: Given: To find the atomic number of Sodium Germanium Gallium

Q: O) Number of electrons in 1C of charge ? O Charge of 5µC passes from a given section of a conductor…

A:

Q: Radium decomposes at a rate proportional to the amount present. If half of the original amount…

A:

Q: solution for Convert 160 Mil wire to millimeter

A: We have to convert 160 Mil wire to millimeter.

Q: The ratio of the mobility to the diffusion coefficient in a semiconductor has the unit. (a) V-1 (b)…

A: Answer: Concept used: using Einstein equation: Dpμp=Dnμn=VTwhere Dp and Dn are diffision constants…

Q: What is the resistance of gold (α = 0.003715/°C) at 65°C, if its resistance at 20°C is 25 kΩ?

A:

Q: 1- How can we measure the impurity concentration?

A: Intrinsic semiconductors have very low conductivity at the room temperature. Hence, extra charge…

Q: Determine the resistance and conductance of 20m of copper wire 2mm in diameter. P= 1-72 x10 S

A:

Q: Using the idea of energy bands in solid materials, explain the characteristics of the following…

A: The useful way to see the difference between Conductor, Insulator and Semiconductor is to plot the…

Q: Explain which has higher range among Ni 100 and Pt 100 . Y axis is resistance.

A: In this question we need to find among Ni 100 and Pt 100 which has high range .

Q: If you have a diode of power rating 10 mW. The voltage across it is O.7 V and the current passing…

A: In this question,  We need to choose the correct options What is power dissipate if voltage across…

Q: is an Area on a device characteristic where the ratio between applied voltage and resulting current…

A: Ohm's Law: According to Ohm's law, the current flowing through a conductor between two places is…

Q: Determine the reactions at the supports in the 50-kg paper roll. 35 mm B 30

A: Here the m=50 kg. The diagram is,

Q: i. Explain the types of semiconductors and the classifications of the semiconductor materials

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: What is the area in circular mils

A:

Q: (b) i. Explain the types of semiconductors and the classifications of the semiconductor materials. m…

A: Given  Explain the types of semiconductors and the classifications of the semiconductor materials.…

Q: (a) With the aid of appropriate diagrams, differentiate between metal, semiconductor, and insulator…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.