If the flow between the two reservoirs is 3 L/s, calculate the difference in elevation between the water surface. Both pipes are made of stainless steel. Use a value of 1 x 10-6 m²/s for the kinematic viscosity of water. D = 50 mm L = 6 m D = 25 mm L = 6 m 2

Q: Fluid Mechanics , i need solutions in 15 minutes please. MCQ/Find the capillary rise (h) in the tube…

A:

Q: Water flows into the atmosphere from a nozzle and strikes a vertical plate as shown in the figure…

A: Diameter of pipe (D1) = 0.3m Area of pipe (A1) = Πd2/4 = 0.0706 m2 Diameter of the nozzle (D2) =…

Q: Please be clear with your soltuion. In the figure, x=25cm initially. If the pressure at m is…

A:

Q: A capillary tube of 1.3 mm diemeter is immersed vertically in water exposed to the atmosphere.…

A:

Q: Determine the pressure at the center of the pipe from the piezometer shown. 200mm WATER 75mmØPIPE

A: Given:- a piezo meter is attached to the pipe as shosn below

Q: Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: Given data  Hydraulic head at 1 (h1) = 66cm  Hydraulic head at 2 (h2) = 54cm  Travel distance (L) =…

Q: ion 1: The absolute pressure in a gas tank is 300 kPa. Determine the gage pressure

A: Given data : The value of absolute pressure=PAbs PAbs=300 KPa The value of atmospheric pressure…

Q: Water is transported in a pipe, at an average flow rate of Q = 80 L/s. Calculate the pressure…

A: Solution of a part a and part b

Q: 1. Atmospheric pressure is about 80 kPa (absolute). Water pressure at the base of a water tower is…

A: In this question I  have to question but according to our guidelines we can answer only one…

Q: 1. A venturi meter is used to measure the water flow in a pipe with the diameter of 85mm. The…

A:

Q: A venturi-meter having an entrance diameter of 300 mm and throat diameter 200 mm is used to measure…

A: Given diameter entrance =300mm throat diameter = 200 mm cofficient of discharge = 0.96 venturimeter…

Q: Question: A stream with a flow rate of Q = 8 m3 /s is passed through the turbine by means of a…

A: Solution: Given Data: Q=8 m3/s V1=4 m/s V2=1 m/s

Q: A 30-cm by 15-cm Venturi meter is installed in a vertical pipe, as shown below. The flow is upward…

A:

Q: Compute the height of capillary rise for water in a tube having a diameter of 0.05 mm (in SI units).

A: Given: The diameter of the tube is 0.05 mm.

Q: Home wok 2 Example ( 8) Steel tube shaft having length 3mm and diameter 50mm subjected to axial…

A:

Q: Question: As shown in the figure, water enters and leaves a U-shaped piece of pipe in the horizontal…

A: Solution

Q: Brine (SG = 1.1, viscosity = 1.1cP) is pumped at a rate of 45 ft^3/min (ID = 2.5in) from large open…

A: Given, Q = 45 ft3/min or 0.75 cfs D = 2.5 in or 0.208 ft

Q: 6. A water is supplied through the pipe network system as shown below. The reservoir water level…

A:

Q: Water flows from a tank through 160 feet of 4 inches diameter pipe and then discharges into air as…

A: Determine The velocity of flow in the pipe in fps The total head lost in the pipe in feet, The…

Q: Determine the flow rate in Its/s and in p^3/s that circulates through the Venturi meter. The height…

A:

Q: Flow rate of a fluid (density = 1000 kg/m³) in a small diameter tube is 800 mm³/s. The length and…

A: Given:Density of the fluidρ=1000 Kg/m3DischargeQ=800 m3/sQ=800×10-9 m3/sLength of the tube(L)=2…

Q: If the pressure in pipe

A: In a differential manometer, contains water at both the points A and B, and the gage fluid with…

Q: The diameter of a pipe carrying oil (s=0.92) changes gradually from 400 mm at A to 600 mm at B.…

A: To Determine (a) The direction of flow; (b) the frictional loss between the two points.

Q: (4) Consider that we have a horizentral pipe, like shown in the sketh, which is carrying in this…

A: Elevation of tank (z1) = 100 mElevation of pipe (z2) = 20 mDiameter of pipe (D) = 20 cm = 0.20…

Q: A differential manometer is connected at the two points B and C in of two pipes as shown in Figure…

A: Pressure at point B (Pb)=200kPa Difference in mercury level inside the U tube manometer (h)=30cm…

Q: At the end of a water fountain, a nozzle directs water out from a vertically-oriented pipe to the…

A:

Q: 2.) A liquid having a Reynolds number of 1500 flows thru a 200-mm diameter pipe, 220m long. The head…

A:

Q: 1- Water flows through a horizontal pipe at a rate of 9.1 L/s. The pipe consists of two sections of…

A:

Q: Q3. For the system of pipes in series shown, given that: • The kinematic viscosity is n =1.139×10“…

A:

Q: find the force ate.

A: To find : Force exerted by oil upon gate  Given: pipe line which is 6 m in diameter contains a gate…

Q: For the tank shown in the figure, compute the pressure at points B, C, D and E in kPa. (Liquid X =…

A:

Q: An illegal connection was detected along a water 400 mm water supply line made with cast iron pipe…

A: Given, D=400 mm n=0.012 ν=10-6

Q: Water is pumped from an elevated pool to a tank that is initially empty. The height from the water…

A: Given: Water is pumped from an elevated pool to a tank that is empty. The height from the water…

Q: In the figure shown, determine the height h of water and the gage reading at A when the absolute…

A:

Q: An incompressible fluid flows through a horizontal pipe which tapers from a diameter of 2 cm to a…

A:

Q: Flow rate of a fluid (density = 1000kg/ m³) in a small diameter tube is 800 m³/ s. The length and…

A: Given- discharge Q=800 m3/s density ρ=1000 kg/m3 Length L= 2 m Diameter D=0.5 mm pressure drop = 2…

Q: A manometer is attached to a conduit as shown. What is the pressure at A in kPa. Choices are: A.…

A: Objective: To determine the pressure at A.   Given: Specific gravity of liquid B (SGB) = 10 h = 150…